Hitachi NT65GB Support Question
Hitachi NT65GB Support Question
Find answers below for this question about Hitachi NT65GB - 2-1/2 Inch Gas Powered Angled Finish Nailer.Need a Hitachi NT65GB manual? We have 1 online manual for this item!
Question posted by gnorth on May 22nd, 2017
Works Once And Quits
I put a new battery in my NT 65GB it fires one nail then red light comes on then after a few seconds goes out then nothing. Take battery out put it back and same again. I have two good batteries both are charging fine. Could it be the controller
Current Answers
Answer #1: Posted by Odin on May 22nd, 2017 5:03 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
It's likely either the battery is not set properly or the battery is deficient. See https://www.manualslib.com/manual/1106697/Hitachi-Nt-65gb.html?page=18#manual and the pages following. (Navigate with the sideways caret on the right). If the problem persists or if you require further explanation, you'll have to consult Hitachi: use the contact information here--https://www.contacthelp.com/hitachi/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Hitachi NT65GB Manual Pages
Instruction Manual - Page 5
.... DANGER 1. Do not touch with dispensers for combustible gas which are listed in this instruction manual. This Nailer produces hot exhaust gases that may ignite flammable materials and... FOR USING NAILERS
READ ALL INSTRUCTIONS
This Nailer is powered by the Nailer operator and others in work area.
2. This Nailer shall only be used with bare hands.
5 This Nailer must conform ...
Instruction Manual - Page 6
... AND FIRE HAZARD. Keep the Nailer, fuel cells and battery away from
sunshine and from ignition sources - Fuel cell and/or battery may fail to operate below
32°F (0°C) or above 104°F (40°C).
6 Keep away from temperature exceeding
120° F (50°C). NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA. Always...
Instruction Manual - Page 7
... unexpectedly. When not in use, the
120°F MAX (50°C)
Nailer, fuel cell and battery should be called "Safety".) Never use the Nailer if parts are recommended when working outdoors. Wear protective hair covering to its original position. English
SAFETY - KEEP WORK AREA CLEAN.
The Push Lever and Chamber operate in a dry place. The...
Instruction Manual - Page 8
... CARE. Do not operate the Nailer when you have taken fuel cell and battery out of the Nailer and removed all
OTHER THAN THOSE SPECIFIED IN THIS
times. Turn off the breaker switch to ensure there are doing maintenance and inspection; 2) clearing a jam; 3) it is not in use; 4) leaving work area; 5) moving it to...
Instruction Manual - Page 11
... AND CAUSE INJURY! Follow these injuries:
1. NEVER 4. NEVER
6. The battery can lead to avoid the risk of the battery or battery charger can explode in -car power source. insert any other than with a DC 12V in a fire. connect two battery chargers together. insert foreign objects into the battery charger's air vents. use of injury:
WARNING
ⅷ Improper...
Instruction Manual - Page 12
.... Keep Nailers in a fire or accident due to overheating.
7. Be use to dispose of the exhausted battery. EMPLOYER'S RESPONSIBILITIES
1.
Maintain Nailers properly. 6. Do not place the battery charger on a blanket-type car seat cover or car mat during charging. Using a different cable could result in safe working order. 5. The battery is incinerated. Do not leave the battery...
Instruction Manual - Page 13
... operation of the Nailer. Gas Finish Nailer
Top cover
Actuator
Chamber
Handle
Top cover
Chamber
Actuator Handle Battery
Piston
Driver blade
Trigger
Battery Hook
Piston
Driver blade
Trigger
Firing head
(outlet)
Magazine
Push lever Nail feeder (B)
Top cover
Chamber
Actuator Handle
Magazine
Firing head (outlet)
Nail feeder (B)
Push lever
⅜ Battery (EMB315)
Terminal...
Instruction Manual - Page 14
Gas Brad Nailer
Top cover
Chamber
Piston Driver blade
Actuator Handle
Battery
Trigger
Hook Stop lever
Firing head
(outlet)
Push lever
Magazine
Magazine cover
3. Battery Charger (UC3SML)
Strap
Battery installation hole
Connecting socket
Charger connecting plug
Pilot lamp
Nameplate (on the bottom side)
Charger connecting plug
Cigarette lighter connecting plug
Cord
14
AC adapter...
Instruction Manual - Page 15
...nails (1 strip)
Intermittent: 2 nails per second Continuous: 1,000 nails per hour
EBM315 (1.5 Ah) Li-ion battery, 3.6 V
Type No. 728-981......sold separately
3. Battery Charger (UC3SML)
Input power ...and power source voltage.
15 Gas Finish Nailer
Model Dimensions
Length × Height × Width Weight Includes battery and fuel cell Nail capacity
Cycle rate
Battery Fuel Cell
NT65GS
NT65GB
...
Instruction Manual - Page 20
....
NOTE: The recharging time may not light.
BEFORE OPERATION
Read section titled "SAFETY" (pages 5 - 12). Make sure of the tool becomes weaker, stop using them the first and second time.
How to the ambient temperature and the power supply voltage.
5.
Supporting the battery charger with hand, pull out the battery from receptacle to use or exposure...
Instruction Manual - Page 21
... the metering valve. Expanding gases
cause
low
temperatures. CAUTION ⅷ If the gas leaks from the gas cartridge.
21 COLD WEATHER CARE
⅜ Do not store the Nailer, fuel cell and battery in temperature below when;
English
WORKING ENVIRONMENT
WARNING
ⅷ No flammable
gas, liquid or other
flammable objects
at altitudes above 5,000 feet (1,500 m), or...
Instruction Manual - Page 22
If gas is not dispersed, fuel cell is operating properly.
22
Push lever
Nail feeder (B)
(2) Installing the battery.
The charging method of the metering valve.
WARNING
ⅷ Never use . If the battery indicator light is flashing red, the battery doesn't have enough power and it . Check the metering valve: Press the metering valve stem on fuel cell two or...
Instruction Manual - Page 23
... cell
Adapter Stem
Fuel cell
Battery indicator light (3) INSERT FUEL CELL INTO NAILER. 1 Push up
23 Flashing RED: Insufficient
power
remaining (The light turns
steady during
operation).
OFF: The battery is extremely empty. Fuel cell
Handle
Battery
Battery
release button
BATTERY INDICATOR LIGHT
Flashing GREEN: Enough
power
remaining (The light
turns steady during operation...
Instruction Manual - Page 26
NAILER OPERATION
Read section titled "SAFETY"(pages 5 - 12). WARNING
ⅷ NEVER point tool at yourself or others in work area.
ⅷ Keep fingers AWAY from
ignition source.
ⅷ No smoking. The push lever
and nose will
become hot and
get heated up
after prolonged
or rapid use in work area MUST wear safety glasses with...
Instruction Manual - Page 27
... on the workpiece with Nailer at too steep of an angle; NT65GS, NT65GA, NT65GB enter a state where the push lever cannot be driven into thin boards or near corners and edges of workpiece.
To continue nailing in a separate location, move the nailer along the wood, repeating steps 1 - 4 as hammer. ⅷ Disconnect battery and fuel cell from...
Instruction Manual - Page 31
... dust and
wooden chips which may show details or attachments that the nail feeder slides smoothly by pulling it with Hitachi Gas tool lubricant.
Inspecting the magazine 1 REMOVE FUEL CELL and BATTERY. 2 Clean the magazine. DANGER
ⅷ Store Nailer
properly with fuel
cell and battery
removed.
ⅷ The fuel cell is designed to assist you in...
Instruction Manual - Page 32
...tool to avoid rust.
⅜ Do not store the Nailer, fuel cell and battery in a cold weather environment. Storage
Storing in a place below 104°F (40°C) and out of the reach of cigarette lighter connecting plug
Warning label
4.
A new...In the operation and maintenance of power tools, the safety regulations and standards ...Keep it out of reach of fire, replace only with
loosened screws ...
Instruction Manual - Page 33
....
Operator troubleshooting
PROBLEM Nailer operates, but no nail is driven.
Nail feeder (B) worn or damaged? Check push lever's moving of nail feeder per page 31.
Replace piston ring. The operation of piston. Driver blade worn? Nail feeder (B) worn or damaged? Push lever bent? Replace ribbon spring. Use only recommended nails. Keep push lever working Promote operator safety...
Instruction Manual - Page 34
...Load more nails in the magazine. If red: charge the battery. Check fuel cell, insufficient? Check spark plug wire, worn out? Fan does not operate when push lever is working, light
Check for.... If green: Contact Hitachi for returning of the light indicator. Exchange it doesn't drive a nail
or operation unstable. Unable to charge battery.
----------
Too low temperature, warm up fuel cell ...
Instruction Manual - Page 112
.... Pour le RAMASSAGE, contacter HITACHI KOKI U.S.A. Norcross, GA 30093
Hitachi Koki Canada Co.
450 Export Blvd.
LTD. Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo 108-6020, Japan
Distributed by
Hitachi Koki Co., Ltd.
at 1-800-59-TOOLS (toll free), or HITACHI AUTHORIZED POWER TOOL SERVICE CENTER regarding COLLECTION. Con respecto a la RECOLECCI...
Similar Questions
Screeching Noise
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
nail gun gives screeching noise when firing nails sounds like fan motor but not sure when activated ...
(Posted by Rongowrie 2 years ago)
Nail Gun Won’t Work
my nail gun stopped working after using it twice,I opened back up and a fan is loose,is this the pro...
my nail gun stopped working after using it twice,I opened back up and a fan is loose,is this the pro...
(Posted by Iandharkness 5 years ago)
Nt65ga Will Not Fire
NT65GA Does not fire when trigger is pulled. Battery has full charge.
NT65GA Does not fire when trigger is pulled. Battery has full charge.
(Posted by dmcgeeoo6 7 years ago)
Hitachi C12lsh Wiring Power Swith
I neglected to take a picture of the wiring of the switch. It has 3 connections.... One for the powe...
I neglected to take a picture of the wiring of the switch. It has 3 connections.... One for the powe...
(Posted by wsigurdson 9 years ago)
Laser Doesn't Work On New Saw
Just purchased used a few times to keep a project moving laser neone came on, checked in dark
Just purchased used a few times to keep a project moving laser neone came on, checked in dark
(Posted by jsh159 11 years ago)