Latch Replacement

REMOVING CARTRIDGE ELEMENT

1. Shut off the pump.

2. If filter is located below water level, close valves or block off suction & discharge lines to prevent backflow of water from

the pool.

3. Remove drain plug and open the manual air relief valve to allow water to drain from filter.

4. Depress safety latch and unscrew the lock ring (counterclockwise direction). Carefully lift off filter head with the attached

lock ring to gain access to filter cartridge. (Set Head on a flat surface on top of the handle)

5. Lift out cartridge and clean or, replace with a clean, spare cartridge. (See Cleaning Cartridge.)

6. Clean body o-ring in filter head.

REINSTALLING CARTRIDGE ELEMENT

1. Clean any collected debris from the bottom of filter body. Clean the Body o-ring seal area.

2. Carefully replace cartridge element into filter body ensuring that the cartridge sits evenly on the collector hub in bottom of

filter body.

3. Place filter head on filter body (being sure filter head 0-ring is in place and clean).

4. Tighten lock ring (in clockwise direction) until safety latch fully engages the catch.

5. Proceed as in STARTING THE FILTER

https://www.hayward-pool.com/assets/documents/pools/pdf/manuals/swimclear-single-element-ISCS100.pdf

Thanks