Haier HLP21N Support Question
Haier HLP21N Support Question
Find answers below for this question about Haier HLP21N.Need a Haier HLP21N manual? We have 2 online manuals for this item!
Question posted by vidyamahadeo on February 8th, 2016
Haier Hlp21n Washer
Haier HLP21N washer fills and drains but won't agitate or spin. Any suggestions?
Current Answers
Answer #1: Posted by TommyKervz on February 8th, 2016 3:16 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Related Haier HLP21N Manual Pages
Energy Guide Label - Page 1
... Electricity Use
$14
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on your utility rates and use.
Clothes Washer Capacity:Compact
Model HLP21N
Estimated Yearly Operating Cost
(when used with an electric water heater)
$23
$19
$49
Cost Range of this label before consumer purchase.
User Manual - Page 3
... get the best performance from your proof of purchase to this Haier product. Route Drain Hose (Optional 10 Step 3 - Install Bottom Plate 10 Step 4 - Secure the Drain Hose 13 Step 7 - Prepare and Sort Laundry 19 Step 2 -
Load the Washer 20 Step 4 - Staple your new washer. For future reference, record the model and serial number located on...
User Manual - Page 4
...shock, or injury to persons when using this appliance. • Use this appliance only for filling the wash basket with all of the instructions before using your old appliance.
• This...installed and located in this user
manual.
• Do not use the washer for commercial clothes washing. • This washer has only one water inlet hose for its intended purpose as described in ...
User Manual - Page 5
... this appliance is
moving.
• Do not tamper with the controls. • Never unplug your washer by or near
children. These substances give off vapors that you understand and have been previously cleaned in, ...ignite or explode.
• Do not reach into the appliance if the wash basket, tub or agitator is used by pulling on , with, or inside this appliance.
• Do not place ...
User Manual - Page 7
INSTALLATION INSTRUCTIONS
TOOLS NEEDED
• Pliers • Wrench • Phillips Screwdriver
• Measuring Tape • Carpenter's Level
PARTS SUPPLIED
• Drain Hose Hook
• Water Hose
(flat washers pre-installed)
FRONT FACE TO FLOOR
• Bottom Panel
• Bottom Panel
Screw (6)
• Caster (4)
• Caster Wrench
• Quick Sink Faucet
Adapter...
User Manual - Page 8
... 76.0 cm)
17¼" (43.8 cm)
17 44.7 cm)
6
Water remaining in the washer will be installed on a solid floor to minimize vibration during the
spin cycle. WARNING
Do not install or operate the washer where it will freeze and cause damage to cold water tap (faucet). • The water pressure should be...
User Manual - Page 9
.../2" (80 cm) and 471/4"(120 cm) from the bottom of the washer.
The height of the laundry tub must be at least 311/2" (80 cm) and no more than 471/4"(120 cm).
31½" - 47¼" (80 cm - 120 cm)
7 DRAIN SYSTEM REQUIREMENTS
WALL OR FLOOR STANDPIPE
The height of the standpipe must...
User Manual - Page 10
... can result in doubt as to a properly grounded 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply. ELECTRICAL REQUIREMENTS
WARNING
The washer must be connected to whether the appliance is properly grounded.
• This appliance must be grounded.
User Manual - Page 11
... by a qualified appliance technician. NOTE: The bottom panel is properly installed, contact a qualified appliance technician. If you feel that you are unsure that your washer was below freezing, do not operate until the washer warms up to remove the wash basket brace. Open the top lid to room temperature. STEP 1 - UNPACK THE...
User Manual - Page 12
... to extend from the right-hand side of the cardboard or protective material. Gently pull the drain hose back through the opening on top of the washer for draining, you , and the end marked "front" aligned with the drain hose routed so that it extends from babies and children. IMPORTANT: To avoid damage to...
User Manual - Page 13
... a Phillips screwdriver and the 6 bottom plate screws (provided), insert each caster into the holes in the base of the washer.
Caster Wrench Caster
3. Tighten the screws completely. Unscrew and remove the 4 fixed leveling legs. 2. FRONT FACE TO FLOOR
Bottom Panel Screw
STEP 4 - 3. Screw each of ...
User Manual - Page 14
... are firmly in its final location.
Raise
Lower
Outer Ring
Center Foot
2. Once the washer is inclined more than 2°, it will help reduce noise and vibration.
1. Place washer in contact with the floor and that the water and drain lines are not strained or pinched. Using a carpenter's level, check to make sure...
User Manual - Page 15
... by fastening it to adjust the height.
Raise
Lower
Locking Nut
STEP 6 -
A
Washer
13 SECURE THE DRAIN HOSE
1. Put the drain hose hook end in a drain pipe or laundry tub.
2. Secure the drain hose in each end of the water
inlet hose. See "Drain System Requirements" for cracks, cuts, leaks or wear.
NOTE: Periodically inspect hose for...
User Manual - Page 16
.... OPTION 1 -
FIXED
NOTE: In order for leaks. Then using pliers, tighten an additional two-thirds turn . Turn on the water faucet and check for this washer to meet the regulated energy standards, the faucet supplying the water must be set to the hose coupling, do not use plumber's tape or sealants...
User Manual - Page 17
...sink faucet adaptor to the grey end of the inlet hose making sure the pre‑installed flat washer is threaded so that it will need to determine if it will lock into place.
6. ...threads - Thread the silver faucet connector onto the faucet. If there is any leaking, check for this washer to meet the regulated energy standards, the faucet supplying the water must be set to cold. 1. Remove...
User Manual - Page 18
Plug the washer into a grounded 3 prong outlet. 2. See the "Operating Instructions" section.
16 7. Using 2 cable ties, fasten the water inlet hose to the drain hose so that water faucet is turned on. 3. Run a ...heck that the hoses will stay in place.
Water Inlet Hose Cable Ties Drain Hose
IMPORTANT: Place the extra hose length (slack) inside the sink to avoid strain and possible damage to ...
User Manual - Page 21
...allow the liquid detergent to fill with the water before dispensing...being supplied to the washer.
• If ...laundry detergent to determine the amount of water
before adding laundry. 1. OPERATING INSTRUCTIONS
STEP 1 - PREPARE AND SORT LAUNDRY
PREPARE LAUNDRY • Check garment labels for cold water. SORT LAUNDRY • Sort laundry by the type of the wash basket or clogging the drain...
User Manual - Page 22
... wash cycle and allow the wash basket to fill with the lid open. Powdered Detergent NOTE: For best results, add the detergent to the wash basket before adding
laundry.
IMPORTANT: Be careful not to turn the washer on garment label for a balanced load.
2. Close the washer lid. NOTE: Do not pour detergent into the...
User Manual - Page 24
... pinched. PROBLEMS WITH WATER
Water flow is slow or filling takes a long time:
• Check to make sure that the washer lid is normal in some cycles. When the soak time ends, the washer will not hear the washer operating during that period of drain
outlet must be redistributed
to re-balance the load.
•...
User Manual - Page 25
... wear and tear - FOR MORE HELP, VISIT HAIER.COM OR CALL THE CONSUMER HELP LINE AT 1‑877‑337‑3639.
23 Stop the washer and check for garment care.
Do not mix heavy...sort your load. WASHER IS MAKING NOISE
Thumping Sound:
• The wash load may be in the wash basket. If this occurs,
use liquid instead of dyes. • Large and heavily soiled laundry may need more ...
Similar Questions
I Have An Hlp21n When Time To Drain Does Not Drain
I have an hlp21n when time to drain WONT DRAIN SOMETIMES pump does not kick in but if I lower the ho...
I have an hlp21n when time to drain WONT DRAIN SOMETIMES pump does not kick in but if I lower the ho...
(Posted by kenasun01 2 years ago)
Washer Over Flows
Why is my hlp21n washer over flowing? What part & part# do I need?
Why is my hlp21n washer over flowing? What part & part# do I need?
(Posted by debidudley2 2 years ago)
How Do I Replace The Drain Pump ?
the washer only drains by lowering the hose?
the washer only drains by lowering the hose?
(Posted by Joelaney1 9 years ago)
Washer Is 1 Year 5 Months Old. The Washer Fills, But Will Not Agitate, Or Empty
Washer in question is a Haier RWT350AW
Washer in question is a Haier RWT350AW
(Posted by jayne76 12 years ago)