Home » Graco » Baby & Toddler Car Seats » Graco 8F12MIN3

Graco 8F12MIN3 Support Question

Find answers below for this question about Graco 8F12MIN3 - SnugRide Infant Car Seat.
Need a Graco 8F12MIN3 manual? We have 1 online manual for this item!

Graco Overview Questions Manuals Reviews Videos Research

Question posted by esqjackiemark on September 27th, 2014

Missing 3 1/4' Bolt To Complete Assembly

I am missing a 3 1/4 inch bolt to complete assembly of the Graco convertible crib. Baby is due in 3 weeks, and I can't find one anywhere.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TechSupport101 on September 27th, 2014 9:26 PM

This answer was accepted by the poster of the original question.

TechSupport101

Member since:
May 24th, 2013

Points: 12,171,305

1,100
points

Hi. Try the Graco parts portal here

http://www.gracobaby.com/replacementparts/pages/replacementparts.aspx

www.satechhelp.co.za

Related Graco 8F12MIN3 Manual Pages

Owners Manual - Page 1

FAILURE TO PROPERLY USE THIS INFANT RESTRAINT INCREASES THE RISK OF SERIOUS INJURY OR DEATH IN A SUDDEN STOP OR CRASH. © 2007 Graco ISPC089BB 2/07 US Do not install or use this infant restraint until you read and understand the instructions in this manual. Infant Restraint/Carrier Owner's Manual READ THIS MANUAL KEEP INSTRUCTIONS FOR FUTURE USE.

Owners Manual - Page 2

... Base 13 3.4 Adjusting Handle 13 3.5 Attaching Canopy (certain models 14 3.6 Seat Pad Assembly (on certain models 15 3.7 Head Support (certain models 16 3.8 Cold Weather Boot (certain models 16 3.9 Harness Covers (certain models 17 4.0 Important Information 18-22 4.1 Warnings for Use as Infant Restraint 18 4.2 Warning for Use With a Stroller 20 4.3 Additional Warnings for...

Owners Manual - Page 3

...Positioning Harness Straps 29 6.1.1 3-Point Harness 30 6.1.2 5-Point Harness 31 6.2 Securing Child in Infant Restraint 33 6.2.1 3-Point Harness 34 6.2.2 5-Point Harness 35 6.3 Installing Infant Restraint/Base Using Vehicle Belt . . . . . .36 6.4 Using LATCH to Install Base 39 6.5 Reclining Infant Restraint/Base 40 7.0 Additional Information 43-45 7.1 Airplane Use 43 7.2 Storing LATCH 43...

Owners Manual - Page 4

... to READ THE OWNER'S MANUAL. Inserting the harness straps in the proper slots for this infant restraint. 2. Your child's safety depends on: 1. You must also read your vehicle. Choosing a suitable location in your vehicle owner's manual. Some seating positions, such as those equipped with air bags, may not be safe locations for...

Owners Manual - Page 5

Properly reclining the infant restraint. 7. Many seat belts are NOT safe to restrain an infant restraint or by using LATCH. 5. Properly securing the infant restraint in the vehicle using a seat belt designed to use with infant restraints, even though they can easily be threaded through the infant restraint! 5 Properly routing the vehicle seat belt or LATCH. 6.

Owners Manual - Page 6

... restraint to http://www.NHTSA.gov • Graco: 1-800-345-4109 or www.gracobaby.com 6 Exton, PA 19341 or call 1-800-345-4109 or www.gracobaby.com 2.2 Recall Information • Call the U.S. Send your infant restraint. 2.0 Registration Information Model Number: Manufactured in: Purchase Date: 2.1 Register Your Infant Restraint Please fill in a recall. Child...

Owners Manual - Page 7

... efficiently. These numbers can be found on a sticker on the underside of your product's model and serial numbers ready so that we may have your infant restraint. or Canada, please contact our Customer Service Department with any questions you may help you contact us, please have concerning parts, use, or maintenance...

Owners Manual - Page 8

... The system is called LATCH. * LATCH may be used IN PLACE of the infant restraint comes with LATCH anchor points. OR 3-Point Harness 5-Point Harness Adjustment Belt ...infant restraint properly, it is equipped with different harness options. 3.0 Features and Components Each model of vehicle belt ONLY if vehicle is very important to vehicle owners manual for installing car seats...

Owners Manual - Page 10

Harness tightener REAR VIEW: 3-POINT HARNESS Canopy (on the bottom of the infant restraint. The locking clip is stored on certain models) Release handle Level indicator* Owner's manual... clip** The level indicator is attached to use it with certain types of the infant restraint, and indicates whether or not the infant restraint is properly reclined. You will need to the side of vehicle...

Owners Manual - Page 12

... buckle Harness adjustment strap Locking clip** The level indicator is properly reclined. REAR VIEW: 5-POINT HARNESS Canopy (on the bottom of vehicle seat belts. 12 You will need to the side of the infant restraint, and indicates whether or not the infant restraint is attached to use it with certain types of the...

Owners Manual - Page 13

... be sure it clicks into any of the 5 positions: Position A: MUST be sure it clicks into base. Push and pull on both sides of seat and lift infant restraint from base – as shown –. Rotate handle until it is the sitting position, NEVER use positions B or C in position. ˜ Carrying A B C D E Sitting...

Owners Manual - Page 14

...; canopy support parts. The canopy should appear as shown ˜. ˜ OR ™ 4. Thread one canopy support completely through one and two for the other canopy tunnel. Attach canopy in the areas between the infant restraint and the handle base ™. Slide straight end of a second support into the straight end of...

Owners Manual - Page 15

.... Skip Steps 3 and 4 if your model does not include straps. 3.6 Seat Pad Assembly (on the other side of the seat pad. 15 Step 2. — Wrap the top edge of the seat pad around the foot end of the seat as shown. Repeat steps for the elastic strap and hook on certain models) Step 1. – Wrap...

Owners Manual - Page 16

...include a head support, you may need extra support to use , wrap elastic around bottom of seat and place both elastic loops around vehicle belt hooks as shown . 16 To use a... for support œ. If your child's shoulders. 3.8 Cold Weather Boot (on certain models) Some infants may want œ to keep their head and body in the cushion ›. MAKE SURE THAT NOTHING...

Owners Manual - Page 18

...SUDDEN STOP OR CRASH. Check vehicle owner's manual for Use as Infant Restraint • DO NOT INSTALL OR USE THIS INFANT RESTRAINT AND BASE UNTIL YOU READ AND UNDERSTAND THE INSTRUCTIONS IN THIS...vehicle. • DO NOT PLACE THIS INFANT RESTRAINT IN A VEHICLE SEATING LOCATION THAT HAS A FRONT AIR BAG. Your child can injure your child if the infant restraint is not properly installed or if ...

Owners Manual - Page 20

... sheet for Use With a Stroller • USE ONLY WITH STROLLERS THAT ARE PART OF THE GRACO TRAVEL SYSTEM. Always touch the surface of Graco's infant car seat with other manufacturers. • NEVER USE INFANT RESTRAINT AND BASE IF IT HAS DAMAGED OR MISSING PARTS. If you do not know. 4.2 Warning for details about how to attach the...

Owners Manual - Page 31

... plate ›. Follow the appropriate instructions for a smaller or larger baby on them through the harness slots and then reinsert them . 31 SAFETY CHECK: After the harness has been completely reinstalled, a) CHECK that straps are not twisted in front or back. Behind seat, remove the ends of the two shoulder straps from the...

Owners Manual - Page 32

... and the end strap loops š. CHECK that straps are completely within junction plate slots ›. FOR SMALLER BABY: Use the lower harness slots – (if they are ...that the loops are secure by pulling š › on them . 32 CHECK that the loops are completely within junction plate slots ™. ™ CHECK that straps are even with or just below your child's shoulders)...

Owners Manual - Page 41

... still orange in the level indicator when the ™ infant restraint is resting on the vehicle seat then place a rolled towel under the infant restraint until ONLY blue shows ˜. ˜ When ... the infant restraint firmly in the level indicator when the foot is completely extended then place a rolled towel under the foot until ONLY blue shows ™. Readjust the vehicle seat belt ...

Owners Manual - Page 44

... LATCH with adjustment belt. LATCH storage should look like this when complete –. Carefully remove the seat pad. Machine wash on adjustment belt to make sure LATCH is ...push aside the small tab that harness system is not twisted, and pull on harness system to reinstall seat pad. Reverse steps to be sure harness is securely fastened. 5. Check that holds the anchor buckles in...