2002 GMC Savana Van Support Question
2002 GMC Savana Van Support Question
Find answers below for this question about 2002 GMC Savana Van.Need a 2002 GMC Savana Van manual? We have 1 online manual for this item!
Question posted by torio1004 on October 15th, 2022
Reasons For Car To Start And Going Dead After Starting
The person who posted this question about this GMC automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by SonuKumar on October 15th, 2022 9:22 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,604,800
Member since:
May 9th, 2021 Points: 16,604,800
Lack of Fuel Pressure
causes: Savana Dies After Starting Here are some of the most common reasons that your Savana starts then stops running: 1. Lack of Fuel Pressure Modern fuel injected engines need a lot of fuel pressure to keep running. When they don't have the proper pressure, they can't run properly.
https://www.2carpros.com/questions/2002-gmc-savana-engine-wont-start
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Manual Pages
Owner's Manual - Page 32
..., it's more likely that the fetus won't be hurt in this happens, just let the belt go back all the way, you ever pull the shoulder portion of the belt out all the way and start again.
1-25
For pregnant women, as the driver's safety belt -- Air Bag System
This part explains...
Owner's Manual - Page 42
... hips, just touching the thighs.
This could cause serious or even fatal injuries. If the belt is pulled out all the way, it go over the shoulder and across the chest. And you ever had to the strong pelvic bones. In a crash, this section. To make ... pull up on the buckle end of the belt as you would apply force at the end of the belt should go back all the way and start again.
Owner's Manual - Page 90
... protected by your vehicle. You may also want to release the key from START as soon as the engine starts.
Your vehicle is not working properly and must be serviced by Passlock at ...RUN.
If the engine is turned to leave something valuable in a lot where someone will go off .
What if you will be watching your ignition key? Passlock is disabled. During normal...
Owner's Manual - Page 92
... motion while the engine is off the engine but still turn the key hard. B (LOCK): This position locks your engine. E (START): This position starts your ignition, steering wheel and transmission.
When the engine starts, let go down as your vehicle in any other position -- Turn the key only with your vehicle is being pushed...
Owner's Manual - Page 93
...And the excessive heat can damage your dealer. When the engine starts, let go of the key.
2. When starting your engine in START for longer than 15 seconds at a time will cause your ...your engine might not perform properly.
2-22 When the engine starts, let go of the key and accelerator.
If it doesn't start (or starts but this : 1. Wait about three seconds. If you add...
Owner's Manual - Page 95
... here, we ask that you contact your dealer in OFF for an extended period for any reason, it features an electronic shift position indicator within the instrument cluster. To be sure your vehicle...when you the best advice for your rear wheels. Don't leave your vehicle can give you start your engine because your vehicle when the engine is equipped with the parking brake firmly set your ...
Owner's Manual - Page 97
THIRD (3): This position is going uphill, don't hold your vehicle in position on very steep hills, or in FIRST (1), the transmission won't shift into PARK (P) to start your brakes off and on slippery road surfaces. Also, if you more power and lower fuel economy than DRIVE (D). push your transmission. If the shift ...
Owner's Manual - Page 106
...Index). An arrow on the instrument panel cluster will return by itself when you . If the arrows don't go on . To signal a lane change . If a bulb is finished, the lever will be burned out and... the direction of the turn or lane change , just raise or lower the lever until the arrow starts to flash.
When the high beams are on, this light on the instrument panel cluster also will return...
Owner's Manual - Page 107
... a paddle marked with the wiper symbol on the windshield, blocking your washer until the windshield wipers start; Otherwise the washer fluid can overload your windshield wipers. For more wipes, hold the band on..., for fewer wipes select a lower setting. Heavy snow or ice can form ice on it go.
Use this symbol to turn off the windshield wipers. (Mist): Turn the band to heavy...
Owner's Manual - Page 127
... instrument panel, which shows AIR BAG or the air bag symbol. So please get to RUN or START, a tone will come on for a few seconds. This light will come on when you if there is ...already buckled. Then the light should go out. The system checks the air bag's electrical system for about 55 seconds. When one of the...
Owner's Manual - Page 128
...may have it fixed so it helps to turn on could drain your battery. After the engine starts, the light should flash for a few seconds when you turn the ignition key to warn ....
2-57 If you start your vehicle, it is a problem.
It could even inflate without a crash. The air bags in your vehicle serviced right away. The air bag readiness light should go out. If the light...
Owner's Manual - Page 135
... off , have developed. It will cause your battery has run as efficiently as stalling after start-up .) This will not pass this inspection could prevent you recently changed brands of fuel?... emission control systems during normal driving. Have you from getting a vehicle registration. You may go away once the engine is warmed up , stalling when you need to know in the Index...
Owner's Manual - Page 146
...conditioning, setting it on , you need to dehumidify the air.
3-7 Outside air will be going through the floor outlets. If you use the floor setting with the temperature knob in the blue... cool down , so outside . Heating
On cold days, use the optional engine coolant heater before starting your engine, your windows closed while using your vehicle. MAX A/C lets in only a little air...
Owner's Manual - Page 158
The tape will go back to use the following steps:
D Turn the ignition to the radio when a tape is pressed first. The ...TAPE sensor is pressed.
3-19
See "Care of the selection. CAS will remain active until one beep is searching for the start of Your Cassette Tape Player" in the player. This override routine will flash on the display while the cassette player is produced....
Owner's Manual - Page 170
...while the cassette player is in this pushbutton to go to the beginning of the previous selection or ...will continue moving forward through the tape. The station frequency and REV will go to the beginning of silence between each side. A tape symbol is ...If this pushbutton to go to the displayed number of the tape is pressed additional times or held, the radio will go to 9. Tapes ...
Owner's Manual - Page 173
...may be loaded with either of the arrows is pressed first. Press the right arrow to go to the start of the current or previous track. Release it to play the passage. Release it to play...the passage. A SEEK ": Press the left arrow to go to the start of the next track. The display will appear on the display when each track starts to play a tape when listening to reverse at six ...
Owner's Manual - Page 182
...Press AUTO EQ to stop scanning. SEEK : To seek, press the left arrow while playing a CD to go to the next track. The sound will mute while scanning. Press RPT again to turn if off . Press ...be automatically set whenever you are listening to in random order. Press the right arrow to go to the start of the discs that are loaded, in
random order, press and hold RDM for more ...
Owner's Manual - Page 201
...Watch for the distance you would lose by dropping back. start " that more than makes up ahead that might affect your pass... around the vehicle ahead, then goes back into the other cars are some tips for passing:
D Do not get too ... a successful pass, wait for another opportunity. Not necessarily! Keep back a reasonable distance. So here are lined up ,
D "Drive ahead." Look down and...
Owner's Manual - Page 203
...want to slow down when you have any doubt. For safety, you start steering quickly enough, your best to avoid sudden steering, acceleration or ...-lock brake system (ABS) helps avoid only the braking skid. One reason is on the road.
Always be longer and vehicle control more dangerous ...'ll want the vehicle to go. and slow down and adjust your vehicle is more limited. It is important to...
Owner's Manual - Page 216
...behind a motorhome. You will help keep warm, you can cause deadly CO (carbon monoxide) gas to get out of the vehicle that's...out.
This saves fuel. This uses less fuel for a while. Start the engine again and repeat this only when you . This can ... any of its wheels on the side of the vehicle and do it go a little faster than just idle. NOTICE:
Towing your vehicle with all ...
Similar Questions
My 1998 Gmc Sierra Will Not Start ?
1988 gmc sierra, new starter and battery, turn the key you get notning, jumped with wire at starter ...
1988 gmc sierra, new starter and battery, turn the key you get notning, jumped with wire at starter ...
(Posted by Anonymous-124066 10 years ago)
Savana 4.3 , 1500 2007 Starting Issue When Engine Is Cold
The truck turns and tries to start but won't fire , and after several tries it will start and run fi...
The truck turns and tries to start but won't fire , and after several tries it will start and run fi...
(Posted by Moseskm 11 years ago)
Drove Through Deep Water, My 1998 Gmc 5.0 Savana Van Won't Start.
Replaced distributor and cap and fuel pump
Replaced distributor and cap and fuel pump
(Posted by hill1365 11 years ago)
1998 Gmc Savana Gargo Van Won't Start
All lights and accessories work. Starter doesn't even click when I turn the key. Acts like no po...
All lights and accessories work. Starter doesn't even click when I turn the key. Acts like no po...
(Posted by troy39951 12 years ago)