Frigidaire GLTF2940FS Support Question
Frigidaire GLTF2940FS Support Question
Find answers below for this question about Frigidaire GLTF2940FS - 3.5 cu. Ft. Front Load Washer.Need a Frigidaire GLTF2940FS manual? We have 3 online manuals for this item!
Question posted by luciestanr1 on March 12th, 2012
Why Does The 'er Uo' Message Always Come On And Stop The Wash Cycle?
dishwasher GGHD2433KF model Frigidaire----the er uo message always comes on and stops the cycle. What is the problem?
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on March 13th, 2012 11:50 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Er UO indicates that the unit has an open vent. Typically technicians check the following:
While in wash cycle, Main Control Board does not receive signal from vent assembly that vent plunger is closed. Plunger status
is sensed with optical sensor in vent assembly. Check wiring between vent assembly and Main Control Board. If wiring correct, replace vent assembly. If error still exist, replace Main Control Board.
This is not a typical DIY job so please consult with your manufacturer first.
Online Outreach Specialist
Related Frigidaire GLTF2940FS Manual Pages
Use and Care Guide - Page 2
...messages will be treated as instructed in the Use and Care Guide, Operating Instructions, Installation Instructions and on Use the washer only as household waste. Table of Contents
IMPORTANT SAFETY INSTRUCTIONS ...3-4 Washing Procedures ...4-6 Stain Removal ...6-7 Common Washing Problems... local city office, your washer. We have every feature Record Your Model and Serial Numbers included here...
Use and Care Guide - Page 3
...laundry products out of this time.
3
Printed in fire, explosion, serious bodily injury and/or damage to comply with these warnings could result in serious injury or death. - It may be necessary to reinforce the floor to the wash... this washer. Do not install on a solid floor. Install washer on carpet. Before loading, unloading or adding items, push in the cycle selector knob...
Use and Care Guide - Page 4
...; Follow the guidelines below for preparing the wash load. • Read the Operating Instructions for operating your specific model. • Always read Important Safety Instructions before operating this warning can cause serious injury, fire or death.
Washing Procedures
Note: The instructions appearing in a load.
Add laundry load to washer. • Combine large and small items in...
Use and Care Guide - Page 5
...for
front-loading washers to exceed 1/3 cup (80 mL)) and pour it into the
washer drum as it stops. • After adding laundry products,... the cycle. D. FABRIC SOFTENER • If desired, pour the recommended amount of the bleach which could result in tumble action washers.
5...mininum fill line (MIN.) for this symbol
on the wash load. • Use of a fabric softener dispensing ball is...
Use and Care Guide - Page 6
..., spin speed, options and features according to improve venting of each load. Do not store or place laundry products on the door or crawl inside seam. • Rinse and wash items after the cycle has ended.
8.
Follow fabric care label instructions. Start the washer. (See Operating Instructions for colorfastness by fabric care label. General Precautions...
Use and Care Guide - Page 7
...
Scrape residue from fabric. Replace towels under stain frequently. Some inks may be removed. Wash with product containing enzymes. Brush off excess.
May be impossible to remove.
Pretreat with...fluid. Rub with a paste of an entire load, use on acetate fabrics. Pretreat or soak in hottest water safe for fabric. Wash using hottest water safe for fabric. For ...
Use and Care Guide - Page 8
... softener. Wrinkling
•Overloading the washer. •Incorrect wash cycle for a few
minutes to remove rust stains. Yellow or brown rust stains
•Iron or manganese in water supply, water pipes, or water heater.
•To restore discolored load of detergent. •Wash synthetics frequently using hot or
warm water. PROBLEM POSSIBLE CAUSES SOLUTIONS
PREVENTIVE MEASURES...
Use and Care Guide - Page 9
...stops. (Figure 1
• Reach back into a properly grounded electrical outlet. 4. This prevents dye transfer to empty wash
drum. Outside • When washing... residue from the washer as soon as the cycle ends. Turn off...L) nontoxic recreational vehicle (RV) antifreeze to future loads. Do not add wash load 9
Store washer in freezing temperatures, follow these parts with water...
Use and Care Guide - Page 10
... block have it rests firmly on . Stop washer and rearrange wash load. Close drawer.
• Washer door is not hot enough. Add 1 or 2 similar items to support more than 1 use .
See Washing Procedures.
• Load is usually normal. Run rinse cycle.
Avoid using hot water elsewhere before washing
• This is a result of the washing action and is open . Standpipe...
Operating Instructions - Page 1
It has important safety and warranty information. Sort laundry into loads that cycle is selected in your laundry, not every temperature, spin speed, option and soil level is interrupted during the entire wash cycle and the Door Lock indicator wilt be lighted. • A forgotten item can be washed together.
2. Select the appropriate cycle and settings for your Owner's Guide...
Operating Instructions - Page 2
... items such as clean garments removed from luggage or storage containers, seasonal items from the washer and spin out the load. Sport This cycle is selected in a regular cycle. Items will be very wet. A hot water wash is available with this cycle. The Extra Rinse and Extra Spin options are followed by 2 rinses and a stow finat...
Operating Instructions - Page 3
...;
d
*¢
*¢
¢
*¢
*¢
¢
*¢
*¢
¢
*¢
Delay Start
v_
¢
• Factory Settings ,/ Available settings
,/
,/
,/
v_
v_
v_
¢
¢
,/
** Estimated cycle duration is based on factory settings and does not include water fill times, out-of-balance
,/
,/
or oversudsing conditions.
PN 134848800
v_
(0703) The following...
Installation Instructions - Page 1
...-Installation Requirements Electrical Requirements Grounding Requirements Water Supply Requirements Drain Requirements Rough-In Dimensions Location Of Your Washer Unpacking Installation Replacement Parts
PAGE
2 2 2 2 2 3 4 4-5 5-6 6
Installation and ...
WHAT TO DO IF YOU SMELL GAS · Do not try to the washer must conform with local codes and ordinances and the latest edition of this or ...
Installation Instructions - Page 2
... capabilities, the use hose P/N 134889610, available from an authorized parts distributor.
2 OUTLET RECEPTACLE - Water pressure MUST be installed within 42 inches (107 cm) of your washer's water inlet. GROUNDING REQUIREMENTS
Improper connection of the equipment grounding conductor can reach a 79 in doubt, call a licensed electrician. Carpenter's level.
In the event of...
Installation Instructions - Page 4
In an area exposed to protect the floor, lay the washer on it will come in . (7.6 cm) from top and bottom of other flammables are kept or stored...vibration or movement does not occur, reinforcement of the floor may be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. Using a rug, blanket or piece of 1/2 in. In an area where it 's back.
3.
On...
Installation Instructions - Page 5
...valve.
Run some water from the plastic bag located in the drum of the washer and install the rubber washers in the holes vacated by the packaging spacers. Carefully connect the other inlet ...water valve. Remove the 4 plugs from the back panel of the washer.
POWER CORD
2 hose clips
INSTALLATION
Leveling the Washer Excessive noise and vibration can be reinstalled to the HOT and COLD ...
Installation Instructions - Page 6
...near the washer for your washer, contact the...If your washer does ...frigidaire.com, for play. NOTE: Check to the washer. TIGHTEN
10. Place all the Safety and Operating instructions are needed for future reference.
Pedestal A pedestal accessory,Model No.
Good safe practice and caution MUST be used when elevating the washer...washer tub) to the standpipe, inlet hose, laundry tub, etc....
Similar Questions
Wash Cycle/codes
My washer fills & agitates, but will not drain or spin. then a code comes up e20. Not sure what ...
My washer fills & agitates, but will not drain or spin. then a code comes up e20. Not sure what ...
(Posted by nicolemnelson2008 8 years ago)
Frigidaire Front Load Washer Won't Start Rinse Cycle
(Posted by viatono 9 years ago)
Interrupted Wash Cycle
my washer won't complete a full cycle w/o repeated restarts
my washer won't complete a full cycle w/o repeated restarts
(Posted by timcfoulke 11 years ago)
Normal Wash Cycle......
what is the normal time for the normal wash cycle...mine is 53 min...is that normal
what is the normal time for the normal wash cycle...mine is 53 min...is that normal
(Posted by kyref45 11 years ago)
Washer Doesnt Aggitare During Wash Cycle?
(Posted by Anonymous-60658 11 years ago)