Frigidaire FHWC3625MW Support Question
Frigidaire FHWC3625MW Support Question
Find answers below for this question about Frigidaire FHWC3625MW.Need a Frigidaire FHWC3625MW manual? We have 1 online manual for this item!
Question posted by buzzzvulture on December 14th, 2015
Fhwc3625mb What Is The Distance From Rear(at Wall) To Recirculating Cover(rear)
I have 13 inches from back wall to bottom front of cabinets. Will the recirculating vent be exposed as is should be or under the cabinets as it should not be? Thanks. I can't find the dimension from the drawing in the online manual.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on December 15th, 2015 9:15 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hello buzzvulture, thank you for your inquiry!
From my understanding you are searching for a distance dealing with the installation of your range hood, FHWC3625MB. I have included a link to your installation guide. I hope this information is helpful. -OOS
Online Outreach Specialist
Related Frigidaire FHWC3625MW Manual Pages
Use and Care Manual - Page 2
... Safety Instructions 3 List of materials 5 Electrical requirements 5 Location requirements 6 Product dimensions 6 Venting Requirements 7 Prepare the location 8 Install Range Hood (Ducted version 10 Make Electrical Connection 12 Installing Range Hood (Recirculating version) .........10 Range Hood Use 13 Range Hood Care 14 Troubleshooting 15 Warranty Information 16
Be sure to visit us...
Use and Care Manual - Page 3
...When the service disconnecting means cannot be vented to the service panel. D.Sufficient air is the safety alert symbol. do not vent exhaust air into wall or ceiling, do not damage electrical wiring... read the safety precautions in this hood in accordance with a WARNING or CAUTION based on accidentally. When cutting or drilling into spaces within walls, ceilings, attics, crawl spaces, or...
Use and Care Manual - Page 4
... Not Use This Hood With Any External Solid State Speed Control Device.
The manufacturer declines all responsibility for the size of the product. WARNING
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE....be burned. WARNING
TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: a)SMOTHER FLAMES with your back to observe the instructions ...
Use and Care Manual - Page 5
...determined by recess dimensions. • Four... • Phillips screwdriver • Saber or keyhole saw
For cabinets with recessed bottoms: • Two 2" (5.1 cm) wide ...vent
system. UL listed wire connectors • 1 - 75W max, 120V incandescent light bulb • Wall or roof cap with
the rating of the above code standards can order this kit as specified on the left side of the range hood...
Use and Care Manual - Page 6
... installation of range hood to floor. cabinet opening dimensions that are shown must be sealed. B. 30" (76.2 cm) min. C. 13" (33.0 cm) cabinet depth D. 36" (91.4 cm) base cabinet height
PRODUCT DIMENSIONS
7/8" (2.2cm)
415/16" (12.5cm)
7/8" (2.2cm)
DIM B
9/16"(1.4cm)
10" (25.4cm)
9½" (24cm)
recirculating cover
7" (17.8cm)
1½" (4cm)
recirculating cover
hood model
FHWC3025...
Use and Care Manual - Page 7
...system
= 50 ft (15.2 m)
= 5.0 ft (1.5 m) = 8.0 ft (2.4 m) = 0.0 ft (0.0 m)
= 13.0 ft (3.9 m)
Roof cap with damper (purchased separately)
C. 24" (61.0 cm) min. wall cap
Length of the vent system. The break should be kept to a minimum to provide efficient performance.
NOTE
Flexible vent is recommended. Venting Methods Vent system can terminate either through the roof. (purchased...
Use and Care Manual - Page 8
... that surface. .Lift the range hood and set it upside down onto covered
surface. 4.If cabinet has recessed bottom, add wood filler strips
on
the wall and cabinet bottom. VENTING REQUIREMENTS
3¼" x 10" (8.3 cm x 25.4 cm) Vent System
Vent Piece
3¼" x 10" (8.3 cm x 25.4 cm) 90° elbow
5.0 ft (1.5 m)
3¼" x 10" (8.3 cm x 25.4 cm) flat elbow
12.0 ft (3.7 m)
3¼...
Use and Care Manual - Page 9
...188;" (3.2 cm) diameter hole (B) through the rear wall at this point. Recirculating Hood version For this installation, go to "Install Range Hood (recirculating version)" on this line that is 7⁄8" (2.2 cm) from the
back wall on the centerline of the underside of cabinet. .Mark lines 5¼" (13.3 cm) to cut a rectangular opening
for vent. 4.Repeat steps 1-3 for the underside of...
Use and Care Manual - Page 10
... LOCATION
Style 3 -
Mark on the underside of cabinet the location of the 4 keyhole mounting slots on the range hood (See slot dimensions on the inside of the range hood.
1.Unpack the 3¼" x 10" (8.3 x 25.4 cm) rectangular vent from the inside of cabinet.
.Mark a line 5" (12.7 cm) from the back wall on a covered surface. Keyhole slot Cut Openings for this installation...
Use and Care Manual - Page 11
... circuit breaker) box to make the connection in the hood electrical terminal box. There must be installed up to range hood with each other.
Terminal box cover B. A
A. Then push the hood toward the wall so that the large end of the slot. For wall installations, remove the rear rectangular vent knockout. A
A. Attach to 1" (2.5 cm) on the thin area of...
Use and Care Manual - Page 12
.... Set range hood aside on a
covered surface.
Terminal box cover B. Home power supply cable
F.
Disconnect power and check wiring connections.
NOTE
Do not reconnect power until the installation is complete.
.Remove the screw from your new range hood, read the "Range Hood Use" section.
12
INSTALL RANGE HOOD (Recirculating version)
1.Lift the range hood up under cabinet and...
Use and Care Manual - Page 13
... top or rear of the vent hood (depending on the incoming location of your home power supply cable) and install a UL listed or CSA approved ½" strain relief.
The hood controls are over the mounting screws. Tighten the strain relief screws.
.Position the range hood so that the screws are recirculating the air exhaust, the recirculation vent cover must remain...
Use and Care Manual - Page 14
... cover and inserting tabs into socket. .Replace lens cover by placing the back edge in direction of hood.
IMPORTANT
Exterior Surfaces Do not use .
RANGE HOOD ...6 months with
phillips screwdriver .Turn the filter retainer to range hood.
14
Charcoal / Grease Filter Accesory Kit For recirculating vent hood, an optional charcoal filter is not washable.
Or place
in...
Use and Care Manual - Page 15
...duct opening . 4. Change the motor. 2. Adjust the distance between the cook top and the bottom of ducting. 1. TROUBLESHOOTING
Problem
...
4.
The unit is connected properly. 2.
The hood is vibrating. Metal filter is not venting out properly.
The power line and the cable ...2. Using the wrong size of the hood within 24" (61 cm) and 32" (76.2 cm) range. 2. Grease filter is plugged into the...
Use and Care Manual - Page 16
... as -is" are not a part of the unit.
4. Exclusions
This warranty does not cover the following:
1.
Service calls to use your receipt, delivery slip, or some other cosmetic parts... with the provided instructions.
Service calls which has proven to , any parts of Alaska.
13.
14.
original date of purchase, Electrolux will repair or replace any after hour, weekend,...
Similar Questions
Motor Stopped Working
I bought the FHWC3055S at the Brick in October 2015.After 4 time use, the motor stopped.
I bought the FHWC3055S at the Brick in October 2015.After 4 time use, the motor stopped.
(Posted by bluemind40 7 years ago)
Fine Mesh Recirculation Filter Frigidaire Dishwasher It Does Not Pop Back In
(Posted by lgden59 11 years ago)
Duct Free Kit
why would i need a duct free kit for the frigidaire chimney wall mount hood?
why would i need a duct free kit for the frigidaire chimney wall mount hood?
(Posted by dnd 11 years ago)
How Do You Reinstall A Fridgidaire Fine Mesh Recirculator Filter
(Posted by alextobey 12 years ago)