Frigidaire FGX831FS Support Question
Frigidaire FGX831FS Support Question
Find answers below for this question about Frigidaire FGX831FS.Need a Frigidaire FGX831FS manual? We have 3 online manuals for this item!
Question posted by sarahong98 on September 11th, 2011
Fabric Softener Dispenser
where is the fabric softener dispenser located? i saw bleach dispenser only.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on September 13th, 2011 8:29 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hi Sarah -
Fabric softener dispensers are not available in all models, but if it is in your model, it will be in the center of the your unit, right on top of the agitator.
To separate the cap from the cup, put your thumb into the dispenser and push against the side of the cup. Add liquid softener to the dispenser, following fabric softener label directions. Add water to bring liquid to the fill line on the dispenser cap. Remember to remove the dispenser from the agitator after each use, and rinse both the cap and the cup with warm water. After cleaning, push the cap and cup firmly together. Replace dispenser by lining up the ribs and grooves and snapping it back into position.
More information about your specific model can be found in the owner's manual. Hope this helps!
Best of luck!
Chris Polk
Online Outreach Representative
Follow me on Twitter @ChrisPolk
Online Outreach Specialist
Related Frigidaire FGX831FS Manual Pages
Complete Owner's Guide (English) - Page 2
... and Serial Numbers Record below the model and serial numbers found on the laundry center serial plate located on your appliance.
We have every feature included. You can happen if ... killed or seriously injured if you cannot reach your gas supplier, call your laundry center.
Your laundry center may not have provided many important safety messages in the vicinity of electrical...
Complete Owner's Guide (English) - Page 3
... only.
• Clean the dryer lint screen before using the washer, turn on or near the dryer. Do not use heat to...Important Safety Instructions:
• To reduce the risk of the laundry center. This will release any kind of the dryer, lint screen... smoke or use or mix liquid chlorine bleach with other flammable or explosive substances to fabrics can be killed or seriously injured if ...
Complete Owner's Guide (English) - Page 4
... service or discarded, remove the washer lid and dryer door to prevent accidental entrapment. • Failure to the laundry center: - All repairs and servicing must replace the thermal limiter switch after the laundry center is moved to a new location, have it checked and reinstalled by the manufacturer of the
fabric softener or product. • Failure to...
Complete Owner's Guide (English) - Page 5
...or injury to persons, read and follow fabric care and laundry product labels. Sort items by recommended ...bleach directly on type of agitation. Bleach Dispenser (some models). • Before adding the wash load, add liquid bleach to bleach dispenser located in a mesh bag to prevent tangling during the wash cycle. • Turn knit items inside out to the wash tub before operating this washer...
Complete Owner's Guide (English) - Page 6
..., push cap and cup firmly together. DO NOT REMOVE SERVICE CAP FOUND INSIDE THE AGITATOR POST. Pull out the knob to the dispenser, following fabric softener label directions.
2. Add laundry load to washer. • Dry load level should not be higher than half the total wash load. • When washing a single heavy item, add 1 or...
Complete Owner's Guide (English) - Page 7
....
Collar or cuff soil, cosmetics
Pretreat with prewash stain remover or rub with cold water. Ink
Some inks may intensify discoloration. Rinse. Wash using bleach
safe for fabric.
7 Rub with prewash stain remover or nonflammable dry cleaning fluid. Nail polish
May be impossible to remove. Beverages (coffee, tea, soda,juice, Pretreat stain...
Complete Owner's Guide (English) - Page 8
Then start washer.
•Add fabric softener to dispenser (available on some models).
•Dilute fabric softener with synthetic and permanent press fabrics.
water temperature, water level, and
preparing the wash load.
•Overloading the washer.
Pilling (Fibers break off, ball up and cling to fabric)
•Pilling is normal with water. Soak item. Yellow buildup of body soil ...
Complete Owner's Guide (English) - Page 9
... according to tumble freely for your specific
model. • Always read and follow fabric care labels and laundry product
labels. When the cycle ends, remove items immediately and hang or fold. To... tangling and for stains which can produce more lint. • If desired, add a dryer fabric softener sheet.
4. Repeat stain removal process before the cycle ends, turn it inside out for even ...
Complete Owner's Guide (English) - Page 10
... , ball up and cling to fabric.)
Shrinking
•Pilling is clean and in washer or dryer to reduce
electricity.
•Or, add a fabric softener sheet and
static electricity.
•... to complete drying. Weight should not be tumble dried.
1.
liquid fabric softener in the final rinse. •Use fabric softener in place. avoid overdrying.
•Lint is attached to "pills."...
Complete Owner's Guide (English) - Page 11
...bleach [1/2 cup (120 ml) in place. • If the dryer drum becomes stained from using dryeradded fabric softener sheets. Excess wrinkling,
color transfer, and odors may form on the laundry...a dirty residue may become stained from the washer as soon as the cycle ends. Hazardous ...noncolorfast fabrics, clean the drum with mild soap and water.
Outside • When laundering is located at...
Complete Owner's Guide (English) - Page 12
...
1 minute to tub,
hitting wash tub. NOISE
"Clunking" or gear sounds. Additional floor bracing may not be loose.
Pull out knob and let washer spin for service, review this laundry center. Store washer in tub.
Laundry center is restarted, objects may be in this list. See INSTALLATION INSTRUCTIONS for details. Squealing sound or hot...
Complete Owner's Guide (English) - Page 13
... dirt and sand from laundry center. See Washing Procedures. Straighten drain hose.
Washer will automatically restart after spin. Water supply is being used elsewhere in washer does not Drain hose ... To conserve energy, the temperature of circular holes in tub.
Install rubber sealing washers provided.
House drain pipes are not completely open hot and cold faucets. Close lid...
Complete Owner's Guide (English) - Page 14
... the heater will be at least 4 inches in the dryer circuit. There are 2 house fuses in diameter and made of items.
See Drying Procedures.
Follow fabric care label instructions.
14
Installation Instructions (All Languages) - Page 2
...; 3-wire or 4-wire 240 volt corg kit • Metal foil tape not (duct tape).
(electric dryer).
2 These conditions will simplify the installation and ensure the Laundry Center is being installed. • Before beginning installation, carefully read and obey all materials in your building. • Clear the room, building or area of...
Installation Instructions (All Languages) - Page 3
...inch (maximum unbalance pressure, hot vs. POWER SUPPLY CORD -The gas laundry center is prohibited for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
WATER SUPPLY REQUIREMENTS
Hot and cold water ... marked for use 4-conductor cord for this purpose). NEMA 10-30R receptacle to be located so the power supply cord is accessible when the dryer is installed on the same ...
Installation Instructions (All Languages) - Page 4
... is made up of Fire - The dryer MUST NOT be inspected and cleaned a minimum of a building which has a swing-out damper(s) that extend into the laundry area. Exceeding the length of duct pipe or number of elbows allowed in the "MAXIMUM LENGTH" charts can cause an accumulation of the vent system...
Installation Instructions (All Languages) - Page 5
... have an individual shutoff valve.
5.A 1/8 inch (0.32 cm) N. LOCATION OF YOUR LAUNDRY CENTER
DO NOT INSTALL YOUR LAUNDRY CENTER: 1.In an area exposed to dripping water or outside wall. ...exhausted outdoors.
2.No other fuel burning appliance shall be exhausted four (4) ways with rear flush installation: 1.
C M)
WASHER
60 SQ. Left (8 inch [20.32 cm] length of 4 inch [10.16 cm] rigid
duct, 1 ...
Installation Instructions (All Languages) - Page 7
....
CAUTION Excessive weight. Use two or more
people to move the laundry center to within 4 feet (1.22 m) of the final location to be retained.
3. This provision is to prevent water syphoning.
These...than twice the area of the washer, remove the wire shipping clips securing the drain hose and power cord (if equipped). NOTE: If the laundry center is to begin the installation....
Installation Instructions (All Languages) - Page 10
... with pliers. WATER WILL SYPHON FROM THE WASHER IF THE ABOVE INSTRUCTIONS ARE NOT FOLLOWED. CAUTION
DO NOT CROSS THREAD OR OVERTIGHTEN THESE CONNECTIONS.
4. Carefully move the laundry center to L.P.
GAS CONNECTION (Gas laundry centers only)
a. An L.P.
NOTE: DO NOT connect the laundry center to its final location.
6. conversion kit must be disengaged from the...
Installation Instructions (All Languages) - Page 11
...laundry center does not operate, please review the "Avoid Service Checklist" located in a location near the laundry center for service.
16. Label all joints. Verify proper operation after the laundry center is located behind the dryer front access panel.
11 Run the washer...use them for proper operation. Cartons covered with your laundry center.
11. Place all the Safety and Operating ...
Similar Questions
Where Is The Fabric Softener Dispenser On An Older Model Frigidare Washer?
(Posted by Anonymous-94777 11 years ago)
Dryer Of Washer Dryer Combo Not Heating But Turning
The dryer in my washer dryer combo not drying but running.Just started with second load
The dryer in my washer dryer combo not drying but running.Just started with second load
(Posted by Kmbates10 11 years ago)
Lp Conversion Of Fgx831fs
I received a GRLP3 conversion kit with no directions. What do i do ?
I received a GRLP3 conversion kit with no directions. What do i do ?
(Posted by eringdahl 12 years ago)
I Have To Wait 30 Between Loads Of The Washer
Everytime my washer ends with a load I have to wait 30 mins before I could start a new one. The elec...
Everytime my washer ends with a load I have to wait 30 mins before I could start a new one. The elec...
(Posted by ivanfraustro 12 years ago)
Fabric Softener Dispenser Will Not Work
Everything works just fine, except the fabric softener does not ever drain into my washer. After eve...
Everything works just fine, except the fabric softener does not ever drain into my washer. After eve...
(Posted by haswenson 13 years ago)