Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by Anonymous-155185 on October 18th, 2015
Grumbling Noise From Tub
after done spinning there is a grumbling noise from tub
Current Answers
Answer #1: Posted by techyagent on October 18th, 2015 10:13 PM
techyagent
Member since:
June 17th, 2014 Points: 4,799,780
Member since:
June 17th, 2014 Points: 4,799,780
Check your belt it may be lose. A lose belt will cause a squealing noise and the machine spin slower or take time to come up to full speed.
This is typically something that a professional would need to diagnose. Possible causes could be unbalance drum, bearing, or pulley issue .
http://www.fixya.com/search/p906795-frigidaire_fex831f_top_load_stacked_wash/spin_loud_noise
Thanks
Techygirl
Answer #2: Posted by TechSupport101 on October 18th, 2015 9:59 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Hi. Pages 3 & 6 of the Use & Care Manual reads
CAUTION: Do not continue to use the dryer if you hear squeaking, grinding, rubbing or other unusual noises. This could be a sign of mechanical breakdown and lead to fire or serious injury. Contact a qualified technician immediately.
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
... supply line (gas dryer).
• 3-wire or 4-wire 240 volt corg kit • Metal foil tape not (duct tape).
(electric dryer).
2 All safety messages will simplify the installation and ensure the Laundry Center is the safety alert symbol. Place all safety messages. • The instructions in this dryer are not followed. do not...
Installation Instructions (All Languages) - Page 3
...loop connectors and marked for use 4-conductor cord for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
WATER SUPPLY REQUIREMENTS
Hot..., have a qualified technician install a longer hose, PIN 134049201, available from plug. ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center
NOTE: Do not under any circumstances remove grounding prong from an authorized parts distributor. ...
Installation Instructions (All Languages) - Page 4
... for proper and safe operation of elbows allowed in the "MAXIMUM LENGTH" charts can create a health and fire hazard. Do not exhaust dryer into the laundry area. MAXIMUM LENGTH OF 4-INCH (10.2 CM) DIAMETER RIGID METAL DUCT
0
56 ft. (17.07 m)
42 ft. (12.8 m)
1
46 ft. (14.02 m)
36 ft. (10...
Installation Instructions (All Languages) - Page 5
...be disconnected from the gas supply piping system during any pressure testing of 1/2 inch (1.27 cm) pipe.
3.If codes allow, flexible metal tubing may be exhausted four (4)... C M)
WASHER
60 SQ.
Floor MUST be unobstructed when a door is acceptable.
5.The following illustrations show minimum clearance dimensions and air openings for proper ventilation. The laundry center may be ...
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR...¼ IN (104.77 CM) 29 7/16 IN (74.77 CM)
3 ¾ IN. (9.52 CM)
36 1/16IN. (91.60 CM)
27 IN. (68.58CM)
25 ¼ IN. (64.13 CM)
47"
2 ½ IN. (6.35 CM)
1 7/8 IN. (4.76 CM)
4...
Installation Instructions (All Languages) - Page 7
... the laundry center to within 4 feet (1.22 m) of the final location to begin the installation. Using a ratchet with no obstructions. From the back of the washer backsheet....for Mobile Homes.
Return laundry center to prevent water syphoning. Remove: (a) foam tub blocking pad. (b) tape from the center of the base.
Carefully move Laundry Center.
2.
Plastic clamps secure...
Installation Instructions (All Languages) - Page 8
...wired power cord with a copper wired receptacle OR aluminum wired power cord with the appliance. Check with all local codes and ordinances.
ELECTRICAL INSTALLATION
ALL ELECTRIC Laundry Centers
GROUNDING REQUIREMENTS
Non-Canadian ELECTRIC Laundry Center
WARNING The following are specific requirements for the length power cord to be purchased, allowing some slack in the cord. The proper...
Installation Instructions (All Languages) - Page 9
... screws securing the cord restraint against the power cord.
9. approved power
power cord.
Reinstall the terminal block access cover.
9 ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM
ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM
NON-CANADIAN ELECTRIC Laundry Center
1. Install a U.L. approved strain relief connector in the entry hole on the terminal block. Attach the power cord neutral...
Installation Instructions (All Languages) - Page 10
... water valve (on the back of the washer. Gently set aside.
7. Remove the panel and set the laundry center back down to 3/8 inch (0.96 cm) reducer for leaks at both connections.
5. NOTE: DO NOT connect the laundry center to its final location.
6. b. Use a 1/2 inch (1.27 cm) to ensure the laundry center is level and solid on all connections...
Installation Instructions (All Languages) - Page 11
...and maintaining any appliance.
14. Children might use them for your laundry center, contact the source where you purchased your laundry center.
11. Wiring errors can become airtight chambers causing suffocation. WARNING ...box. Turn on , the safety switch will light, it is unpacked. Run the washer and dryer though a cycle. Reinstall the dryer front access panel. Cartons covered with ...
Complete Owner's Guide (English) - Page 2
... LAUNDRY CENTERS:
Avoid fire hazard or electrical shock. You can cause serious injury or death.
Do not store these areas could ignite or explode. • Under certain conditions, hydrogen gas may
• Clear the room, building or area of life. This will release any appliance. The interior of all instructions before using the washer...
Complete Owner's Guide (English) - Page 3
... on type of agitation. Sort items by recommended water temperatures, wash time, and agitate/spin speeds. • Separate white, light, and colorfast items from dark and noncolorfast items.... bleach to the laundry center, the electrical power cord of liquid chlorine bleach in the wash load. • Mend rips and tears to the wash tub before operating this washer.
1.
Pretreat stains...
Complete Owner's Guide (English) - Page 4
... cycle is missing or damaged.
4 Do not force open the lid during a spin, push in the washer after the tub stops spinning. • To open the locked lid. Excess wrinkling, color transfer or odors may... knob and wait about
2-3 minutes for your safety, the lid locks when the tub is spinning.
Add laundry load to washer.
• Dry load level should not be higher than the top of agitator...
Complete Owner's Guide (English) - Page 7
.... • Read the Dryer Operating Instructions for drying.
• Dry items of static electricity, which may permanently set dryer controls (some stains. Dryer heat may not have been removed... tangling and for your specific model. • Always read and follow fabric care labels and laundry product labels. If an item sheds lint, turn pockets inside .
7. Close the dryer door...
Complete Owner's Guide (English) - Page 9
... warnings listed in Important Safety Instructions, page 2, and those listed below.
• Before cleaning the washer or dryer interior, unplug the electrical power cord to future loads. Excess wrinkling, color transfer, and odors may remain on the laundry center. To remove this by pulling straight up in inefficient drying and possible fire hazard. Outside...
Complete Owner's Guide (English) - Page 10
... in a heavy-duty washer. Do not add wash load. It may produce a thumping sound. Rattling and clanking noise. fasten fasteners and turn items inside out.
Adjust leveling legs.
Winterizing Instructions
If the laundry center is a power outage, call local electric company. Add 1 gallon nontoxic recreational vehicle (RV) antifreeze to tub,
hitting wash tub. A certain amount of...
Complete Owner's Guide (English) - Page 11
...sand from laundry center.
Straighten drain hose. Wait until water supply and pressure increase. Water level does not cover Washer is incorrect...washer. Incorrect wash and rinse Hot and cold water hoses are connected
temperatures. Washer won't spin. Contact plumber if necessary. spin. Straighten hoses.
OCCURRENCE
POSSIBLE CAUSE
WASHER - Lid is being used elsewhere in wash tub...
Operating Instructions (Operating Instructions) - Page 1
... dust draperies.
4. Drying time is determined automatically at the temperature selection of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS in place.
3. It...dryer. A signal will sound when the cycle ends. To reduce the risk of your laundry center Owner's Guide.
Temperature Selection
Always follow directions on LESS DRY.
Prepare items for obtaining ...
Operating Instructions (Operating Instructions) - Page 3
...
WARM COLD
Before Operating Your Washer
Read your Laundry Center Owner's Guide before adding the laundry load.
Printed in your Laundry Center Owner's Guide. If desired, add liquid fabric softener to restart the washer.
10. The dry load should not be washed together.
2.
To reduce the risk of normal agitation and a fast spin for washing.
3. Prepare items for...
Operating Instructions (Operating Instructions) - Page 4
... vanes. Warm and cold wash and rinse water temperatures are low.
• Follow proper laundry procedures to the tub. Undersize loads waste energy.
• When small wash loads cannot be enough water in...To reduce drying time, select a wash cycle with a fast spin speed to remove more water from heavy items such as towels and jeans.
• Operate the washer in the tub for basic fabric types.
Similar Questions
Frigidaire Laundry Center
Washer will not pick up speed i spin cycle
Washer will not pick up speed i spin cycle
(Posted by Anonymous-169735 2 years ago)
Washer Frigidaire Fex831fs Wont Work On Spin Cycle
(Posted by Lashbhogi 9 years ago)
Frigidaire Laundry Center Glet1031cs0 Dryer Spins But Won't Heat
(Posted by krld2diegof 10 years ago)
Laundry Center Dryer Turns But Makes A Loud Thumping Noise. What Could It Be?
(Posted by Anonymous-131323 10 years ago)
Motor Won't Spin On Washer Model Fex831fs4
(Posted by mmasBam 10 years ago)