Frigidaire FEQ1442ES Support Question
Frigidaire FEQ1442ES Support Question
Find answers below for this question about Frigidaire FEQ1442ES - 27" Electric Dryer.Need a Frigidaire FEQ1442ES manual? We have 2 online manuals for this item!
Question posted by AVmanpasca on December 6th, 2013
How To Stop Frigidaire Stackable Dryer From Beeping
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Frigidaire FEQ1442ES Manual Pages
Installation Instructions - Page 2
...27 m)
10 ft. (3.05 m)
NOT RECOMMENDED PRE-INSTALLATION REQUIREMENTS
Tools and Materials Required for additional instructions. Channel-lock adjustable pliers. 3. Rigid or flexible metal 4 inch (10.2 cm) duct. 7.
See ELECTRICAL CONNECTIONS for Installation: 1. OUTLET RECEPTACLE - The following are kept or stored. Restricted air flow will be exhausted into the laundry area.
Exceeding...
Installation Instructions - Page 3
... N.P.T. inches (387.1 sq. Read the measurement on electric dryers, exhausting can be constructed of door. In an area exposed to the dryer. 2. In an area where it for test gauge connection, MUST be
exhausted outdoors.
2. A dryer installed in a bedroom, bathroom, recess or closet, ... of the door, is higher than 0.75 inches of 1/2 inch (1.27 cm) pipe. 3. cm)
CLOSET DOOR
Installation Instructions - Page 4
... to clear knobs (70.49cm) 28.5 to clear door handle (72.39cm)
2.375" (6.03cm)
(34.29cm) 13.5" To rear & base exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to...
Installation Instructions - Page 5
...mobile home) using metal ducting that secure the door hinges to the opposite side of the dryer exhaust outlet.
4. Installation MUST conform to be fastened to help pull out the plugs.... not support combustion. REMOVE 4 SCREWS (ONE FROM EACH HINGE FIRST)
5 MOBILE HOME INSTALLATION
1. This dryer MUST be not less than twice the area of the cabinet.
"Solid door " Reversal Instructions:
1. ...
Installation Instructions - Page 6
... plugs from the left by removing the door in Step 4. 7. Be careful to the dryer front panel. Apply moderate downward pressure on the left by pulling straight out from the door...lens with both hands and rotate it from the opposite side of the door and use later. Open the dryer door. Retain the plugs for use later. Install the handle and screws removed in Step 2.
Retain the ...
Installation Instructions - Page 7
...
FOR 3-WIRE SYSTEM
NEUTRAL GROUND WIRE
RED
BLACK
WHITE
NUT
STRAIN RELIEF MOUNTING BRACKET
TIGHTEN NUT TO THESE THREADS
POWER CORD
ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM
ELECTRIC Dryer
1. Thread a U.L. Install a U.L. Finger tighten the nut only at the connections. approved 30 amp. Attach the power cord neutral (center wire) conductor to a grounded metal, permanent...
Installation Instructions - Page 8
... through a cycle check for play.
Connect a 1/2 inch (1.27 cm) I.D.
If the burner does not light within 45 seconds the first time the dryer is resting solid on all connections by the manufacturer could result in your dryer, call 1-800-944-9044, or visit our website, www.frigidaire.com, for service.
7.
Use duct tape to...
Operating Instructions - Page 1
...2. Prepare items for best drying results. If desired, add a dryer fabric softener sheet. Select the cycle and drying temperature for more details...Dry Auto Dry cycles take the guesswork out of installation and electrical voltage or gas pressure can also affect drying time. Auto...once.To resume the cycle, press START again. • To stop or change the temperature, turn the TEMP knob to tumble, ...
Operating Instructions - Page 2
...settings can be removed any time during Press Saver.
Dryer Features
Control (Control Lock) To avoid having someone accidentally start or stop the dryer, press OPTIONS and SELECT at the end of the... a cycle, the indicator will automatically be used with every cycle. High is selected, a beep will result in crowded closets or drawers, or unpacked from clean and dry items that cycle is...
Operating Instructions - Page 3
....
ERROR CODE CHART
If the dryer stops, the status lights flash and the signal beeps, an error has occured. If the dryer stops, status lights flash again and the beeping continues, please contact service for the possible cause and solution. Reduce load size. Press buttons lightly and release.
Ventilation system clogged. Remove lint;
Make correction, ...
Similar Questions
Why My Frigidaire Dryer Won't Start And Goes Straight To Pause
(Posted by Msvettadotdon318 2 years ago)
Dryer Stops And Beeps 6 Times
The dryer stops and beeps 6 times, lights flash and does not reset.Cleaned out the lint, front and b...
The dryer stops and beeps 6 times, lights flash and does not reset.Cleaned out the lint, front and b...
(Posted by electqa2002 8 years ago)
Gallery Series Gas Dryer Beeping. Which Buttons Do I Press To Reset?
(Posted by queendeb4 8 years ago)
Why Is My Frigidaire Dryer Beeping
(Posted by crimuigpt 9 years ago)
Frigidaire Dryer Beeps Three Times And Wont Start
(Posted by smewaltja 9 years ago)