Frigidaire FAQE7011KW Support Question
Frigidaire FAQE7011KW Support Question
Find answers below for this question about Frigidaire FAQE7011KW - 7 cu. Ft. Cycle Electric Dryer Drum.Need a Frigidaire FAQE7011KW manual? We have 5 online manuals for this item!
Question posted by Staceyhale29 on March 19th, 2013
Frigidaire Frontloader Dryer Overheating
My frigidaire dryer is only 2 yrs old and keeps overheating. The connectors cord that connect to he back if he dryer keeps burnin up. This will be the 2nd time in less than a yr. ??? my brother in law thankfully is an electrician and fixed it for me last time and looked at it this time but he thinks there is an underlying issue. Has anyone else had this problem
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on March 21st, 2013 1:03 PM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hi Stacyhale29 – From what you are describing, the wiring you are referring to appears to be where the power cord attaches to the dryer terminal block. If this is correct, more than likely a loose connection may have caused the wires to overheat and melt. At this point, I would recommend one or two things. Replace the terminal block and cord, and make sure to securely tighten the terminal block screws to the cord terminals or seek expert for a further evaluation.
Online Outreach Specialist
Related Frigidaire FAQE7011KW Manual Pages
Complete Owner's Guide (English) - Page 1
All about the
Use &Care
of your Dryer
TABLE OF CONTENTS
Important Safety Instructions 2-4 Solutions to Common Problems 14-15 Features 5 Warranty 16 Operating Instructions 6-11 Notes 17-18 Dryer Settings Chart 12 Español 35 Care and Cleaning 13
www.frigidaire.com USA 1-800-944-9044
www.frigidaire.ca Canada 1-800-265-8352
137181700A (0901)
Complete Owner's Guide (English) - Page 3
... warnings listed below. IMPORTANT SAFETY INSTRUCTIONS
240 v Electric Dryer
120 v Gas Dryer
10-30R 3-wire
(fused 30 amp)
14-30R 4-wire
UL-approved service cord must be connected to an outdoors exhaust. Some rubber materials, when heated, can cause serious injury, fire or death.
Fire hazard, overheating and damage to the rubber or plastic parts...
Complete Owner's Guide (English) - Page 4
....
• Before the dryer is removed from the electrical supply before reaching into the dryer if the drum is moving. If the dryer is moved to a new location, have it will be installed and electrically grounded by a qualified service person.
• To prevent personal injury or damage to the dryer, the electrical power cord of all warnings...
Complete Owner's Guide (English) - Page 7
... less wrinkling.
• If desired, place a dryer fabric softener sheet on top of the load at the beginning of static electricity.
• Turn the cycle selector knob in the future.
• To return to factory settings, press the Start/Pause and Select buttons at a time. Allow the drum to come to a complete stop when the...
Complete Owner's Guide (English) - Page 8
...and humidity, type of installation and electrical voltage or gas pressure can be able to Timed Dry.
Quick Select this Auto Dry cycle for about 5 minutes. Drying time will light up in a circular ... Dry cycles save time and energy and protect fabrics.
If the load is changed after a few minutes.
With Auto Dry cycles, the load will be dried at the back of the dryer drum sense ...
Complete Owner's Guide (English) - Page 11
...; Drying • Cool Down • Extended Tumble
Drum Light The drum light will come supplied from the factory with a drying rack you may be hinged on the air grill.
The estimated remaining cycle time is equipped with this dryer.
11 OPERATING INSTRUCTIONS
Other Features
Drying Rack (on top of the rack, leaving space between items...
Complete Owner's Guide (English) - Page 12
... Low Air Fluff/No Heat
*
*
*
*
*
*
*
Dryness
More Dry
*
*
Normal
*
*
Less Dry
*
Damp Dry
Options
Shrink Guard
*
Extended Tumble
*
Signal Volume
*
*
*
*
*
*
*
* Factory presets Available selections
**Estimated cycle duration is based on gas models.
12 Displayed cycle duration may differ slightly on default dryness level and factory settings for electric dryers.
Complete Owner's Guide (English) - Page 14
... removal, residues of
load before starting the dryer.
• Do not overload dryer. • Use fabric softener in washer or dryer
to reduce static electricity. • Remove items when they are ... drying. • Block knits into shape.
• Do not overload dryer. • Remove items as soon as cycle ends.
14
Hang or fold.
For satisfactory drying results, follow these suggestions...
Complete Owner's Guide (English) - Page 15
.... OCCURRENCE
POSSIBLE CAUSE
SOLUTION
Dryer does not start. may save both time and expense.
Drying cycle takes too long, outside of the drum finish. Scratching or chipping of the dryer feels too hot or smells hot.
Dryer does not have not been followed.
LP gas supply tank is connected to the dryer.
*Drum damage caused by the warranty...
Wiring Diagram (All Languages) - Page 1
...drum seals, dryer installed in the digit display. Carefully free the and perform the test again. cycle has been interrupted.
137033000B 0810 The control will enter Field Test Mode, the buzzer will sound 3 times...voltage drop between "Fld" and the firmware revision number (ex. CAUTION: DISCONNECT ELECTRICAL CURRENT BEFORE SERVICING Please Return This Sheet to reset control. If reading is ...
Wiring Diagram (All Languages) - Page 2
...plunger) and placing a finger on the both moisture sense bars at the same time will sound 3 times and all the temperature LED's should light. Press and hold the Options and ...
4 turns:
Drive motor runs; Dryer will be ON. Immediately after, rotate cycle selector knob 5 turns counter-clockwise to reset the control. heat source is pressed, all the cycle status LED's should light. Drying ...
Installation Instructions (All Languages) - Page 1
All about the
Installation
of your Dryer
TABLE OF CONTENTS
Important Safety Instructions 2-3 Reversing Door 18-21 Installation Requirements 4-10 Accessories 22 Installed Dryer Dimensions 11 Notes 23-24 Installation Instructions 12-17 Español 25
www.frigidaire.com USA 1-800-944-9044
www.frigidaire.ca Canada 1-800-265-8352
137112200B (0903)
Installation Instructions (All Languages) - Page 3
...‰ Door latches and drum tumbles when cycle starts
‰ Registration card ...on all corners
Gas Supply (Gas Dryer)
‰ Manual shutoff valve present in supply ‰ All connections sealed with a WARNING or CAUTION ...64258;ame
240v Electric Supply (Electric Dryer)
‰ Approved NEMA 10-30R or 14-30R service cord with all safety messages that follow this dryer. IMPORTANT
IMPORTANT indicates...
Installation Instructions (All Languages) - Page 4
... cord connection instructions see ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM.
Í NOTE
Dryers manufactured for sale in Electrical Installation section.
3-WIRE POWER SUPPLY CORD KIT (not supplied)
3-wire receptacle (NEMA type 10-30R)
The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 type SRDT rated at 240 volt AC minimum, 30 amp, with 4 open end spade lug connectors with...
Installation Instructions (All Languages) - Page 7
...ft. (19.5 m)
48 ft. (14.6 m)
1
52 ft. (15.9 m)
40 ft. (12.2 m)
2
44 ft. (13.5 m)
32 ft. (9.8 m)
3
32 ft. (9.8 m)
24 ft. (7.3 m)
4
28 ft. (9.5 m)
16 ft... times....dryer must be connected to an exhaust outdoors. The dryer...dryer produces combustible lint. If the dryer is not exhausted outdoors, some fine lint will be exhausted outdoors. The dryer must be expelled into the laundry...
Installation Instructions (All Languages) - Page 12
...For a grounded, cord-connected dryer: 1 The dryer MUST be properly grounded. For a permanently connected dryer:
1 The dryer MUST be connected to be cut by a path of your dryer.
In the event of a malfunction or breakdown, grounding will have longer drying times than dryers operating on 240 volt power supply. Electrical shock can result if the dryer is not attached, the cord can be...
Installation Instructions (All Languages) - Page 13
...) plug for electrical current.
2 Since your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle.
2 The plug must be grounded. Grounding requirements - Grounding type wall receptacle
Do not, under any circumstances, cut or remove ground prong from the plug.
For a grounded, cord-connected dryer: 1 The dryer MUST be plugged...
Installation Instructions (All Languages) - Page 22
...frigidaire.com, for the Frigidaire Authorized Parts Distributor nearest you may have been included in the initial purchase of 51.25" (130 cm). MOBILE HOME INSTALLATION KIT
P/N 137067200 Installation in Canada 1-800-265-8352)
If replacements parts are needed for your dryer...WARNING
ELECTRICAL SHOCK HAZARD Label all wires prior to elevate the dryer for stacking this dryer may order one .
Product Specifications Sheet (English) - Page 1
... Classic Red - load / quick cycle selected for various load compositions.
3Based on dryers 36" or less in height and 27" or less in a standard size1 lets you can save time when doing laundry. Front Load Dryers
FAQe7011K W/B/R
Signature Features
Fits-More™ 7.0 Cu.
PN # APWD15R
Capacities
Total Capacity
7.0 Cu Ft. Dryer
The largest capacity dryer in width.
2Based on 8 lb...
Product Specifications Sheet (English) - Page 2
... properly and reduce excessive noise and vibration. Note: For planning purposes only.
Frigidaire Affinity
Front Load Dryers
FAQE7011K W/B/R 7.0 Cu. For additional installation details, refer to Product Installation Guide on web.)
• Always consult local and national electric codes.
• Can be installed alone, with or without optional 15" Drawer Pedestal, or stacked above matching...
Similar Questions
What Causes The Burner To Go Out In My Dryer For The 3rd Time In Two Years?
(Posted by Jackeelex 9 years ago)
Frigidaire Dryer Feq1442eso Beeps 3 Times And Will Not Start
(Posted by vandrndr 9 years ago)
Lightning Surge Then Dryer Would Not Come On
(Posted by andyjr 10 years ago)
