Frigidaire FAFW4011LW Support Question
Frigidaire FAFW4011LW Support Question
Find answers below for this question about Frigidaire FAFW4011LW.Need a Frigidaire FAFW4011LW manual? We have 4 online manuals for this item!
Question posted by rutkajb on August 6th, 2015
Frigidaire Fafw4011l Not Filling With Water In Normal Cycle Only
All cycles work and fill with water except the Normal cycle. Water is supplied to machine correctly and all taps are on, hoses operational.
Current Answers
Answer #1: Posted by Odin on August 6th, 2015 11:28 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See http://www.repairclinic.com/RepairHelp/How-To-Fix-A-Washing-Machine/43-2-832628-/Frigidaire-Washer-fills-slowly-FAFW4011LW0. Good luck!
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by rutkajb on August 21st, 2015 2:25 PM
rutkajb
Member since:
August 6th, 2015 Points: 60
Member since:
August 6th, 2015 Points: 60
Ok, so I spoke to a Frigidaire expert who tells me that sometimes when there is a power failure or power outage it can cause errors to the functionality of the washing machines control panel. Example in my situation, the normal setting did not fill the tub with water before starting the cycle.
To fix simply press the START button and the SELECT button on the front of the washer at the same time and hold until the signal sounds. This will reset to factory settings and machine should operate normally.
Hope this helps.
Related Frigidaire FAFW4011LW Manual Pages
Installation Instructions (All Languages) - Page 2
... all instructions before using this washer.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
Please read thoroughly
‰ Door locks and water enters drum when cycle starts
‰ Registration card sent in
2 Recognize safety symbols, words and labels
Safety items throughout this manual are installed in NEW inlet hoses (shipped in drum)
‰ HOT supply is connected to HOT...
Installation Instructions (All Languages) - Page 4
...generators or any circumstances, cut off or alter the grounding prong on the power supply cord. DO NOT cut , remove, or bypass the grounding prong. In ...washer can result in doubt, call a licensed electrician.
Check with a properly grounded three prong grounding type receptacle. For higher standpipe, use of least resistance for laundry hose connection. If in a risk of your water...
Installation Instructions (All Languages) - Page 6
...;oor line
* To obtain these minimal depth dimensions, dryer must be vented straight back. INSTALLED WASHER DIMENSIONS
51.4" (131cm) to clear open door
30.3" (77cm)* to front of closed door
water supply connection on rear of unit1
drain hose on rear of unit3
27.0" (68.5cm)
power cord on rear of unit2
39" (99cm...
Installation Instructions (All Languages) - Page 9
...
or over-tighten these connections.
4 Connect the HOT inlet hose to the HOT water
e
supply and the COLD inlet hose to -corner.
3 Press down on top of the washer.
2 Use adjustable pliers to adjust the leveling legs so the washer is cold supply.
2 Remove the inlet hoses and rubber washers from the plastic bag located in the drum of...
Installation Instructions (All Languages) - Page 11
...your washer. CAUTION
Failure to the washer.
(682.57.0cm" )
(3185c.0m")
(2667.5c"m)
Replacement parts:
If replacements parts are needed for your washer, ...hose supplied, order the DRAIN HOSE EXTENSION KIT. WARNING
ELECTRICAL SHOCK HAZARD Label all wires prior to reach standpipe heights or distances beyond the reach of 51.25" (130 cm).
*Other colors may be available. Verify proper operation...
Complete Owner's Guide (English) - Page 6
... correctly. Operating Your Washer
WARNING
To reduce the risk of fire, electric shock or injury to the stand pipe of these higher spin speeds.
You will vary slightly as water is normal and will hear water flowing into loads that at-
DRAIN HOSE The washer has a flexible drain hose to carry water from the washer. WATER VALVES/DISPENSER As water...
Complete Owner's Guide (English) - Page 8
OPERATING INSTRUCTIONS
Operating Your Washer, continued
5 Add laundry products to the desired settings.
8 Liquid Fabric Softener • If desired, pour the recommended amount of a fabric softener-dispensing ball is part of the normal operation of the bleach or fabric softener.
Í NOTE
From time to time you may need to be indicated for large loads. • DO...
Complete Owner's Guide (English) - Page 9
...
Operating Your Washer, continued
• To select or delete an option, press Options;
sanitize hot warm cold cold water clean
max high medium low no spin
delay start
chime
stain clean
energy saver
freshwater rinse
heavy normal light
door lock sensing wash
touch pause to delay the beginning of the cycle, if desired.
• As...
Complete Owner's Guide (English) - Page 10
... models) The Heavy cycle provides 20 minutes of reversing
tumble wash action for bulky items such as comforters, blankets, mattress pads, sleeping bags and similar items. Ten minutes of reversing tumble wash action for reference only.
Hot water is recommended to remove heavy soil and most stains. OPERATING INSTRUCTIONS
normal bulky
casual delicates rinse...
Complete Owner's Guide (English) - Page 11
... with a no-iron finish followed by a Cool Down rinse, 2 additional rinses and a final spin. OPERATING INSTRUCTIONS
Cycle Selection, continued
NSF Protolcol P351 Allergen Reduction Performance of Residential and Commercial, Family-Sized Clothes Washers
The Allergy cycle will kill all dust mites and eliminate at the same time and hold until the signal...
Complete Owner's Guide (English) - Page 12
... temperature of Residential and Commercial, Family-Sized Clothes Washers
Auto Temp Hot Use this setting for each time that should be...water is recommended for normally soiled white or colorfast cottons or blends. The indicator will be line dried.
Then, while it is not available with cold tap supply to 152° F (67° C).
Use this setting for fabrics and colors that cycle...
Complete Owner's Guide (English) - Page 13
... rinse
heavy normal light
door lock...cycle is no spin
delay start the washer, press Options and Select at the same time and hold for ten seconds to lower position before closing position. Status Display/Status Lights The estimated total cycle time will still operate...cycle.
The latch arm can be snapped back in place. OPERATING INSTRUCTIONS
sanitize hot warm cold cold water...
Complete Owner's Guide (English) - Page 14
...cycle.
Í NOTE
If the System Clean cycle is cancelled or paused during the cycle, the washer will cause a severe out-of TIDE® WASHING MACHINE ...Cycle. sanitize hot warm cold cold water clean
max high medium low no detergent or bleach to "CLn". OPERATING INSTRUCTIONS
System Clean Cycle
TO REFRESH OR CLEAN INSIDE OF WASHER To clean and freshen the washer, perform the System Clean cycle...
Complete Owner's Guide (English) - Page 23
...
Do not store or place laundry products on top of cardboard or thin fiberboard under the front leveling legs to prevent damage to prevent pressure build-up in freezing temperatures, follow these winterizing instructions to prevent damage to the washer:
1 Turn off water supply faucets. 2 Disconnect hoses from water supply and drain water
from tape or labels...
Complete Owner's Guide (English) - Page 25
...discoloration. PREVENTIVE MEASURES
• Use fabric softener in your water supply system.
25 This is due to abrasion from normal wear.
• Undissolved detergent. • Some granular detergents
can combine with hard water minerals to form a residue. • Overloading the washer.
• Overloading the washer. • Incorrect wash cycle for a few minutes to clear lines.
• Drain...
Complete Owner's Guide (English) - Page 26
...cycle.
• At the end of each wash, dry inside of washer and gasket after use or whenever washer is not in washer. • Cold water washes which
may not completely dissolve and remove detergents.
• Moisture in the washer. • Use of non-HE detergent. • Overdosing detergent.
• Result of washing and part of normal operation...dehumidifier in laundry
room. • ...
Complete Owner's Guide (English) - Page 27
... or safety pins may be in or connection may be loose.
If sound continues, washer is restarted, objects may not be in wall outlet. Wash load unevenly distributed in drum. OPERATING Washer does not start.
Do not increase fuse capacity.
Water supply faucets are hitting wash drum.
If noise continues after a cool down period of...
Complete Owner's Guide (English) - Page 28
... plumber if necessary. ing washers provided. Run rinse cycle. Run rinse cycle. Stand- Warm or hot water is a distance from washer.
Oversudsing. See Operating Your Washer, step 4.
Water inlet hoses are not completely Fully open . Hot water heater is set too low or is not hot enough.
Fill hose connection is out of the cycle. Wrong detergent.
Incorrect...
Product Specifications Sheet (English) - Page 1
... SilentDesign™
Designed for second floor installation.
Ideal for quiet operation.
Ft. / 4.0 I.E.C. Stay-Fresh™ Door Seal
Optional...Fresh Water Rinse Option
An additional rinse cycle uses advanced rinse technology to 35%.1
frigidaire.com
Cu. Front Load Washers
FAFW4011L B / W
Optional SpaceWise® Pedestal Drawer Shown
Signature Features
7 Wash Cycles 3....
Product Specifications Sheet (English) - Page 2
...Inc. Ft. / 4.0 I .E.C. (Cu. Height (Single) Height (Stacked) B - Height B -
Appliance must be grounded for detailed installation instructions on the web at frigidaire.com. Width C - Washer Frigidaire Affinity (L models)Front Load Washers
FAFW4011L B / W 3.47 D.O.E. Cu. B
C
A
B
C
A
NOTE: For planning purposes only. Width C - Front Load Laundry - Printed in the U.S.A.
Similar Questions
Frigidaire Affinity Washer Will Not Fill Water
(Posted by jsasubzer 9 years ago)
Fafw4011lwo Normal Cycle
My FAFW4011lwo washer doesn't fill on normal. We've had this problem before. The repair guy reset th...
My FAFW4011lwo washer doesn't fill on normal. We've had this problem before. The repair guy reset th...
(Posted by msc0518 10 years ago)
Washer Fills On Wash Cycle,but Very Slowly On Rinse Cycle
My washing machine fills properly on wash cycle but water only trickles in on rinse cycle, for large...
My washing machine fills properly on wash cycle but water only trickles in on rinse cycle, for large...
(Posted by Anonymous-97606 11 years ago)
My Washer Will Not Spin In Normal Cycle
My washer will not spin in normal cycle but will spin if put in spin only cycle
My washer will not spin in normal cycle but will spin if put in spin only cycle
(Posted by Anonymous-82015 11 years ago)
Circuit Board Failed After 60 Days As The Normal Cycle Stoped Working
Sercice man replaced the board under warantie and3 months later the same issue but Bulky cycle,,, is...
Sercice man replaced the board under warantie and3 months later the same issue but Bulky cycle,,, is...
(Posted by leclaim 11 years ago)