Frigidaire ATF8000FS Support Question
Frigidaire ATF8000FS Support Question
Find answers below for this question about Frigidaire ATF8000FS - Gallery - Washer.Need a Frigidaire ATF8000FS manual? We have 5 online manuals for this item!
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on September 15th, 2011 9:20 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
You are more than likely in need of a new door latch assembly kit, part number 131763245, which is common on such units. If that does not work you may have a sensor or control panel problem, but my money is on the door switch. Call your manufacturer for direct pricing or find a local repair shop to do the work for you. I wouldn't recommend doing it yourself, in case something gets damaged or if this is not the problem - then the tech can immediately diagnose it.
Online Outreach Specialist
Related Frigidaire ATF8000FS Manual Pages
Use and Care Guide - Page 2
.... Record and retain these numbers.
Read all safety messages. Failure to the washer.
This is very important.
This Use and Care Guide provides general operating instructions...washer only as household waste.
Your washer may not have provided many important safety messages in personal injury, property damage or damage to use . By ensuring this product is disposed of the door...
Use and Care Guide - Page 3
... the water flow from service or discarded, remove the washer door to prevent accidental entrapment. • Failure to comply ... Before loading, unloading or adding items, push in the cycle selector knob and allow children to a complete stop if...up to comply with an electrical overload protector. Do not combine laundry products for such a period, before attempting any accumulated hydrogen gas...
Use and Care Guide - Page 4
...irritation.
2. Add 1 or 2 similar items to follow fabric care and laundry product labels. The door should close easily. CORRECT Use this washer.
1. Note: The instructions appearing in a load.
Common sense and caution...wash load. • Mend rips and tears to prevent further damage during the wash cycle. • Turn knit items inside out to persons, read and follow this warning ...
Use and Care Guide - Page 5
... • Slowly open the dispenser drawer. • After adding laundry products, slowly close the dispenser drawer. LIQUID BLEACH • If...this symbol on the wash load. • Use of the cycle. Overfilling can cause early dispensing of liquid chlorine bleach (not to... Closing the drawer too quickly could result in tumble action washers.
5 Use the cap or scoop provided by the detergent ...
Use and Care Guide - Page 6
...determined that could entice children to force the door open when DOOR LOCK light is completed.
Do not store or place laundry products on stain removal products. • Keep...the kind of washer at any utensil used. • Do not combine stain removal products, especially ammonia and chlorine
bleach. Safety Door Lock
Washing Procedures Con't
6. Select the cycle, temperature, spin...
Use and Care Guide - Page 8
... and cuffs.
•Turn items inside out to reduce abrasion.
• Rewash load.
•Increase water temperature using the Perm Press or Delicate cycle.
•Do not overload washer. •Remove items from normal wear. PROBLEM POSSIBLE CAUSES SOLUTIONS
PREVENTIVE MEASURES
Blue stains
•Undiluted liquid detergent or fabric softener dispensed directly...
Use and Care Guide - Page 9
...storage, run empty washer through a
complete cycle using detergent. Figure 1 (Lock tab is required. • To clean the drawer opening , flexible gasket, and door glass. If door or console becomes ...2. Turn water faucets off to remove traces of washer with a damp cloth. Return the dispenser drawer. Press START and let the washer drain for cold weather care. Care and Cleaning...
Use and Care Guide - Page 10
... leveling legs and tighten lock nuts. Close door completely. Residue left in washer does not drain or drains slowly. WATER Water collects in folds of the bellows at nearby faucet with a nonabrasive household cleanser, then rinse. Do not overload washer. See Washing Procedures. • Load is probably out of the cycle. Straighten drain hose. Run...
Operating Instructions - Page 1
... drum, press Start/ Pause, open the door, add the item, close the door and press Start/Pause to resume the cycle.
"cd" will light when the option has been selected. WASHER OPERATING INSTRUCTIONS
Before Operating Your Washer
Read your laundry, not every setting or option is interrupted during spin, it will take approximately 2-3 minutes for the door lock to release...
Operating Instructions - Page 2
... prior to the load.
To provide the best care for your schedule or during the cycle:
• Door Lock • Wash • Rinse • Final Spin
Drum Light The drum light will no longer displayed. Start/Pause Press Start/Pause to the type and size of occasional tumbling are available options.
Cancel Press Cancel to...
Parts Catalog - Page 5
... Hose, water inlet, 4 ft., hose & washer Screw, pan head, 8-18B x 0.31 Control Board, motor Wiring Harness, motor control Bracket, angle, motor control Screw, 8-18AB x 0.455 Door Lock/Switch Assy Wiring Harness, door switch Screw, pan head, 10-16AB x 0.500, locking Panel, door glass Frame, inner door Screw, 10-16 x 0.750 Striker, door/lock Hinge, door, with bushings Screw, 10-16...
Parts Catalog - Page 7
... bellows clamp, retainer Bellows Kit, boot, w/light hole Nut, hex, 1/4-20 UNC-2B, (2) Washer, Bellville, spring steel Plate, counterweight Shell, tub, front Spring Assy, suspension Screw, hex head, ... element Stop, detente, heating element Receptacle, lamp, door light Lamp, G4 light bulb, 5 W, 12 V Diffuser, lamp, door light
*
134884800 Energy Guide
Publication No: 5995498952
# Functional Parts
7
...
Installation Instructions - Page 1
... ordinances and the latest edition of life.
- This will simplify the installation and ensure the washer is installed correctly and safely. Follow the gas suppliers instructions. · If you cannot reach... building. · Clear the room, building or area of fire or explosion or to the washer must be performed by a qualified installer, service agency or the gas supplier.
WHAT TO DO ...
Installation Instructions - Page 2
... BACK NOTE:
Drain hose attached to the washer can advise you are in doubt as to have a licensed electrician replace it is not recommended. Channel-lock adjustable pliers. 4. In the event of ...the appliance is not required.
NOTE: GFI (Ground Fault Interrupter) receptacle is properly grounded.
1. The washer MUST be 3/4 inch (1.9 cm) garden hose type so inlet hoses can result in . (61 cm...
Installation Instructions - Page 4
...with curtains or drapes.
3.
Using a rug, blanket or piece of door. In an area exposed to protect the floor, lay the washer on it will come in contact with a maximum slope of 1/2 in ...type building) where gasoline of the floor may be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. Remove the carton.
2. In an area where it 's back.
3. per foot (1.27...
Installation Instructions - Page 5
..., place a level on alternate corners and sides and feel for leaks. Carefully move the washer to the inside "C" outlet of the water valve. Connect the inlet hose ends to an...pliers. NOTE: Use only new hoses.
2. POWER CORD
2 hose clips
INSTALLATION
Leveling the Washer Excessive noise and vibration can be reinstalled to flush the water lines and remove particles that ...
Installation Instructions - Page 6
...the cable tie (provided in washer tub) to drain hose.
6. NOTE: Check to the standpipe, inlet hose, laundry tub, etc.
Place these instructions in a location near the washer for ease of the drain hose...end of use. Turn on the inside of the water.
7. Run the washer through a complete cycle. Pedestal A pedestal accessory,Model No. Cable Tie
REPLACEMENT PARTS If replacements parts are...
Data Sheet - Page 1
... water should enter through the softener compartment. 5. The drain pump & door lock solenoid will activate and the washer will signal the last error code. • Press and hold the Option and Start/Pause buttons until wash cycle LEDs appear. an error has been detected. Washer Tech Data Sheet
This information is intended for 3 seconds. The control...
Data Sheet - Page 2
... control board failed or wire off pump. E41 Control board thinks the door switch is closed. E48 Board thinks the door PTC circuit is open in spin. E58 High current on heater or ... Replace the control board. Check voltage at the outlet. E45 Control board problem. E47 Board thinks the door PTC circuit is open . E82 Console control problem. Replace the control board. Refer to test (14...
Data Sheet - Page 4
... speed control board.
1. Is it around 50K ohms?
1.
Replace the control board. Defective door lock assembly. If the reading is between 105 & 130 Ohms, replace the speed control board. ...If the meter reads other than between 4 and 6 Ohms.
1. Check the tub bearings. Remove the door lock assembly and measuere the resistance of the windings (pin 1 to pin 2, pin 1 to pin 3, ...
Similar Questions
My Washer Paused At The Final Spin Cycle. Cancels And Restarted A Spin Only Cycl
washer stopped at the final spin. Cancelled and restarted a spin only cycle and it immediately pause...
washer stopped at the final spin. Cancelled and restarted a spin only cycle and it immediately pause...
(Posted by Dcvincent228 9 years ago)
Frigidaire Gallery Washer Won't Spin With Load In It Gltf2940fs2
(Posted by brentgowtha 9 years ago)
How To Get Out Of Diagnostic Mode On Affinity Washer
(Posted by jolbs 10 years ago)
Washer And Dryer Go Down The Same Day
dryer drum will not move, stopped working all togather, washer won't spin all the water out. atf8000...
dryer drum will not move, stopped working all togather, washer won't spin all the water out. atf8000...
(Posted by jimmycookjc21 11 years ago)
My Washer Will Not Spin In Normal Cycle
My washer will not spin in normal cycle but will spin if put in spin only cycle
My washer will not spin in normal cycle but will spin if put in spin only cycle
(Posted by Anonymous-82015 11 years ago)