Epson LX-300II Support Question
Epson LX-300II Support Question
Find answers below for this question about Epson LX-300II - LX-300+ II Impact Printer.Need a Epson LX-300II manual? We have 3 online manuals for this item!
Question posted by paradeii on May 16th, 2013
Reverse Line Feed In Epson Lx-300 Printer
I am trying to print labels in continues form. one by one. If I print empty lines in the end of the label, the label proceeds having let say a manual rear off. How can I send to printer the command to reverse feed some lines, before it prints the next label;
Current Answers
Related Epson LX-300II Manual Pages
Product Information Guide - Page 1
..., improves continuous paper handling and reduces the chance of ordinary single-sheet paper. Black Ribbon Cartridge (#8750)
Expected ribbon life is approximately 3 million characters.
7/06
Epson LX-300+II - 1 To find the nearest reseller, call 800-GO-EPSON (800-463-7766).
Additional Tractor Unit (C800301)
Used in your printer. Epson LX-300+II
LX-300+II Parts
Printer cover
Paper...
Product Information Guide - Page 2
...) Roll paper holder (optional)
Continuous 3 inches/second (76 mm/second)
Intermittent 63ms/line at 20 cpi
Bidirectional logic seeking for text and graphics printing. Epson LX-300+II
Printer Specifications
Mechanical
Printing method Printing speed
Printing direction Line spacing Printable columns Resolution Emulation Interfaces
9-pin impact dot matrix
High-speed draft 300 cps at 10 cpi 337...
Product Information Guide - Page 3
...-3-2 EN 61000-3-3 EN 55024
Paper
Use recycled paper, envelopes, and single-sheet multipart forms only under normal temperature and humidity conditions, as follows:
Temperature: 59 to 77 °F (15 to 25 °C) Humidity: 30 to 0.035 inch (0.9 mm)
7/06
Epson LX-300+II - 3 Ordinary single sheets: paper guide and cut-sheet feeder entry
Width
Paper...
Product Information Guide - Page 5
... the top-of-form and tear-off
position.
4 Load/Eject button
❏ Loads a single sheet of paper. ❏ Ejects a single sheet of paper. ❏ Loads continuous paper from the printer's control panel.)
❏ Draft ❏ Roman ❏ Sans Serif
❏ Draft Condensed ❏ Roman Condensed ❏ Sans Serif Condensed
7/06
Epson LX-300+II - 5 However, you want...
Product Information Guide - Page 6
... printer error has occurred.
The printer feeds the paper to select a built-in the printer. Make sure that the printer is aligned with the tear-off position when the perforation is on or flashing, or the printer beeps, use the control panel to the standby position. Epson LX-300+II
7/06
Tear off the Pause light, if necessary. the printer resumes printing...
Product Information Guide - Page 7
... forward to the right of the paper over the sprocket pins.
3. Epson LX-300+II
Printing on Continuous Paper
You can print on continuous paper using the tractor in either the push or pull position:
❏ Use the tractor in the push position if you will be printing on labels, multipart forms, or other documents that the paper is midway between...
Product Information Guide - Page 8
... position, where you finish printing, follow these steps to load single sheets.
8 - To feed continuous paper backward to the loading position. Then press the Load/Eject button.
After you can adjust the tear-off your printed document before you press the Load/Eject button. Reverse feeding several pages at a time may cause a paper jam.
2. Epson LX-300+II
9.
Product Information Guide - Page 9
... the position marked
0 (under the paper now).
7/06
Epson LX-300+II - 9 Printing with the pull tractor
To load continuous paper using the scale on both sides and then rotate the tractor up . Pull the paper release lever forward to the continuous paper position.
4. Feed the paper into the rear paper slot as shown below , and pull it lock...
Product Information Guide - Page 10
Epson LX-300+II
8. Open the sprocket covers. If you want to change the position where printing begins on the page, you feel it beyond these limits, the printer beeps and stops moving the paper briefly. To eject the paper, tear off feature in the paper and then lock it open.
13. To separate ...
Product Information Guide - Page 11
... to feed the paper backward, or press the Load/Eject U button to the tear-off position whenever it , even if you turn on page 14. Tear off mode and select the appropriate page length for instructions.)
7/06
Epson LX-300+II - 11 See page 14 for continuous paper in two ways:
❏ Manually, by pressing the printer's Tear...
Product Information Guide - Page 12
... paper, you 're using the printer's paper guide.
Epson LX-300+II
7/06 Turn off the printer. 2. Slide the left side of special paper types, including multipart forms, labels, and envelopes.
Before printing on a wide variety of the printer.
3. Follow these steps: 1. The printer automatically pulls it begins printing. Load the next sheet and the printer will continue printing.
Product Information Guide - Page 13
... print on the printer. Push it firmly and hold it until it feeds into the printer.
❏ Make sure that multipart forms are especially sensitive to the correct position for your application software or change the top-of-form position as described above .
❏ Use continuous multipart forms that are joined only by spot gluing or side-crimping. Epson LX-300+II...
Product Information Guide - Page 14
..., turn off the printer. Epson LX-300+II
Default Settings
While you can select in this mode. (For more information, see the one you want . Press the LF/FF button to scroll through your application software or printer driver, you may need to print a list of paper each time the printer ejects a printed page.
1. Restoring the printer's default settings
If...
Product Information Guide - Page 15
... run the test using either single sheets or continuous paper. To temporarily stop printing and the LF/FF button to print the remaining sets of characters). Epson LX-300+II
Clearing a Paper Jam
If paper becomes jammed in the printer, follow these steps:
1. Follow the instructions to eject the printed page before turning it back on;
then disconnect the...
Product Information Guide - Page 16
...-00/CPD-21416
Transporting the Printer
If you have just used the printer, the print head may detach and cause the printer to remove the ribbon cartridge.
Make sure the print head is not hot. Related Documentation(
Manual
Epson LX-300+II User's Guide
CD-ROM containing the on top of the printer firmly to prevent water from getting inside the printer;
Epson LX-300+II
5.
Reference Guide - Page 6
Introduction
Your Epson® LX-300+II printer provides high-quality printing and superior performance in a compact design. The CD-ROM that came with one original and up to four copies), labels, single sheets, and envelopes.
❏ High-speed printing of up to 300 cps (characters per second) at 10 cpi (characters per inch).
About This Manual
This manual provides detailed information...
Reference Guide - Page 40
... Faxes. 2. For Windows XP Professional, click Start > Settings > Printers and Faxes. Click the EPSON LX-300+II ESC/P icon. 3. Defining a custom paper size If your paper is not included in the Measurement fields. 6. Click Save Form and then click OK.
40 Using the Printer Software For Windows 98 and Me: Click Custom or User Defined Size and...
Reference Guide - Page 44
... CD-ROM in the CD-ROM or
DVD drive. Close the Installation Program window. 4. Make sure the EPSON LX-300+II icon is running on
your computer. 2. The Status Monitor 3 files are installed.
44 Using the Printer Software Make sure the printer is off and Windows is selected and click OK. or if you have the...
Reference Guide - Page 60
4. On the Printer Model tab, select the LX-300+II icon, and click OK.
60 Using the Printer Software Select EPSON Printer Software, and click Add/Remove or Change/Remove.
1
2
5.
Reference Guide - Page 91
....
Maintenance and Troubleshooting 91 If your drivers are correctly installed, EPSON USB Printer Devices should appear on the Device Manager menu, click the plus (+) sign beside Other devices to view the installed devices. If EPSON LX-300+II appears, the printer driver is not installed correctly.
If EPSON USB Printer Devices does not appear on the Device Manager menu.
Similar Questions
Printer Driver Not Found For Windows 7, Model-epson Lx 300 Ii,p170b
Printer Driver not found for Windows 7, Model-EPSON LX 300 II,P170B
Printer Driver not found for Windows 7, Model-EPSON LX 300 II,P170B
(Posted by ublora 9 years ago)
Why Epson Lx-300 Ii Impact Printer Cannot Print
(Posted by rojabw 9 years ago)
Dos Based Printing Using Epson Lx-300 + Ii Printer
Does Epson LX-300 + II printer support dos based printing? I have connected my epson lx-300 + ii pri...
Does Epson LX-300 + II printer support dos based printing? I have connected my epson lx-300 + ii pri...
(Posted by khuntetapreeti 10 years ago)
Layout Issue For Print Web Page With Epson Lx 300+ Ii
Hi,I have problem with Epson LX 300 + iiI use Chrome browser..I need print facture/invoice from my a...
Hi,I have problem with Epson LX 300 + iiI use Chrome browser..I need print facture/invoice from my a...
(Posted by ronysetyo 10 years ago)
How Can I Use Epson Lx 300+ii Printer In Windows 7?
How can I Use Epson LX 300+II Printer in Windows 7
How can I Use Epson LX 300+II Printer in Windows 7
(Posted by praviakshaya 11 years ago)