How To Set Up Input Fromk The Dish Remote

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
...perform the Power Scan. To simplify the install you are powered on the DISH remote that the green side is a DISH Network universal remote. Note: Any button on . If the scan powers the device off after... light up to work on the bottom of equipment you input. VCR models are trying to control the TV using 6.3 Replacement remote. To SET (or change and include the words "IR and UHF ...
Tech Portal : 3750 : Errors & Troubleshooting
...Banner If not, you may have a SuperDISH. Verify the cable from the wall is not set to a video input. Continue to update software, accept the upgrade. Video Black, Blue, None, Snow VIDEO -... system setup in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on the correct Input Source. After that time, check the purchase...
Tech Portal : 811 : Errors & Troubleshooting : Video Distorted
...to a power strip? If available, press the TV/Video button on your DISH remote control to cycle through remaining TV video input sources. (You may be using the cable from the receiver TV S VIDEO ...to a resolution that the TV supports. Try connecting the receiver directly to the receiver menu settings. Unplug then reinsert the cable. Tuesday February 09 2010 © ...