Why Do I Only Get Sd Dish Signal

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on January 20th, 2014 9:09 AM

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,397

100
points

Call DISH Customer Service: 1-855-318-0572 to find solution for your signal quality.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Tech Depot : HDTV
... lines of resolution or 480 and 1080 interlaced lines of both standard definition (SD) and high definition (HD) DISH Network programming. ViP 222 HDTV Information The ViP 222 is a full-featured... signal from the appropriate orbital locations. An HDTV image contains approximately 5 times as much picture information (picture elements or pixels) as opposed to the standard and high definition DISH ...
Tech Portal : (choose receiver model) : Troubleshooting : Off-Air Digital/HD Antenna
... Channels Select Scan Digital to System Setup, then Installation, and Point Dish/Signal. Select Save. 921 942 Select Sat Locals. If the Local Channels menu is NOT available on both SD and HD with the receiver. Is there an amplifier connected? If signal returns and is important to display the guide information for the...
722 : 061
... Check Switch on . On the Installation Summary screen, select Test. One the test has completed, select Done or Cancel to return to the Multi-Dish Installation or Point Dish/Signal Screen. Perform a check switch test. Select Save or Cancel Wednesday February 11 2009 © Wait 15 seconds, plug the receiver back...