How To Program A Non Reacting Remote Control To Receiver Dish Network

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Remotes : How To : SAT TV Autotune
...SAT Auto-Tune is disabled by default on the 5.4, 6.4, 20.0, and 21.0 remote controls. SAT Auto-Tune can also be programmed using the steps under Setting SAT Auto-Tune Channel. Because of this, SAT Auto-...to change the channel used for three seconds until all four mode buttons are lit. Program the remote control to indicate SAT Auto-Tune was enabled. Press and hold SAT for SAT Auto-...
Tech Portal : (choose receiver model) : Troubleshooting : Off-Air Digital/HD Antenna
... of reception and number of the antenna. Non-hard drive receivers require satellite signal to be experiencing multipathing of DISH Network. Select the issue that you will need to display the EPG and off -air channel Verify HD is from the remote control. No Info" on ALL programming events You must be on the off...
Tech Portal : 722 : Errors & Troubleshooting (Specific) : CSA Troubleshooting
.... Then press the number 2 on the remote control. Press Menu on the remote. Trace the phone cord from to a working phone line to the receiver, remain off the phone while using CSA,... System Info. Most problems with ordering programming, problems paying the bill, connection problems, dropped line. To test a particular phone jack, take a hard line (non-cordless) phone and plug it . ...