After I Program My Dish Remote It Wont Allow Me To Bring Up Dish Tv Guide

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech : Home : (choose receiver model) : Remotes : Other Remotes : EZ Remote
... the manufacturer codes for programming the remote control to include all buttons shown in this guide. Every attempt has been made to control your device. In some cases codes may not control your TV or VCR. If your TV or VCR is not listed or the codes do not work, the remote may operate some but...
Tech Portal : DTVPal : Receiver Information : Receiver Images
... turns receiver off after four hours (userselectable up to -Analog TV Converter H x 1.3in; DTVPal Digital-to eight hours) of inactivity Green light indicates receiver is powered on 1 ATSC antenna input for over -the-air digital broadcasts Electronic Program Guide with as much as seven days of program listings and information (PSIP and/or TV Guide guide data;
Tech Portal : Remotes : How To : SAT TV Autotune
... for the installation must be used to indicate programming was disabled. The TV channel programmed for satellite viewing. The TV button flashes three times to change the channel used for SAT Auto-Tune is enabled by default on newer DISH Network remote controls lets the user program into the remote using the steps under Setting SAT Auto-Tune...