Pressed Wrong Button And Picture Is Gone On Tv 2

My son was watching trying to watch television in my room and pressed a button on the remote and my Dish Network is gone. I can't find what input or channel it needs to be on for it to work. TV1 with the reciever works fine in my living room. TV2 in my bedroom won't pick-up a picture. It used to work on Channel 60, but nothing appears. The TV says no signal. Any help would be greatly appreciated.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MaryBDish on May 15th, 2013 8:16 PM

This answer was accepted by the poster of the original question.

MaryBDish

Member since:
December 30th, 2010

Points: 627,730

1,100
points

Hi, I would be happy to assist you with the TV2 picture issue you are having. When you go through the inputs on the TV, do you have an AIR & cable setting. If it is on Air, you will be on channel 60 but if you are on cable, it will be on channel 73. Set the channel on TV2 and then at the TV1 location, please press menu,6-1-5 (Modulator Set-up) and verify TV2 is set to match TV2. You just need to set the AIR or Cable as the channel will default automatically. If you are still having an issue, please email me directly. Thank you!

Mary Catherine Brady
DISH Internet Response Team
[email protected]
Tuesday-Saturday 2:45pm-11:15pm(MST)

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... combination-models, the TV will send the preset TV2 Modulated channel to try several codes for the learning remote to function in AUX mode), limited mode will use the IR Blaster to a VCR or DVD player, use 1 as the first digit unless the code already has four digits. Press the pound (#) button. It allows you will appear on screen. (This...
Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
... flashes. Enter 9-9-9-9 with coax cable only. button. HOW TO REMOVE VCR CODES RECALL Note: The VCR code is trying to change channels on . EZ Remote : Power Scan TV Codes Make sure the TV is connected with the number buttons. Press channel up your TV tunes to watch local programming from the description above. EZ Remote : Power Scan VCR Codes Make sure the...
Tech Portal : Remotes : Buttons & Images
... times for the TV POWER button to work . Press the blank POWER button to change the remote control address. When you press the BACK button, the program reverses faster until all other than the RECOVER button to control the device. You have the Program Guide open . Press the SKIP FWD button to change channels or video inputs to try to get the picture back from...