Can The Hopper Ota Module Receive The Signal From A Comcast Receiver?

I have the Dish Hopper and four Joeys. I also have Comcast cable on the TV that the hopper id connected to. I want run the output coax from the Comcast box (the coax that goes to the TV) to the Hopper OTA module through the Hopper. Will this work?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MarkHDISH on August 14th, 2013 12:06 PM

This answer was accepted by the poster of the original question.

MarkHDISH

Member since:
January 27th, 2011

Points: 71,460

1,100
points

You can always try but we would assume not as different companies and different software for the devices based on this.

Thank You

Mark Haakenson

Social Media Representative

DISH LLC

[email protected]

12 pm – 11 pm Sunday through Wednesday

Mark Haakenson DISH Social Media

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 722k : Receiver Information : Receiver Images
... a second dish. to 55 hours of 1500 channels. Q-Box Support HDMI (1) TV Antenna / cable input (with some VoIP systems (broadband phone) (1) 20.0 IR Remote (1) 21.0 IR/UHF Pro Remote While channeling up to move the window (either size) into one of -the-art HD receiver. Dual Mode is disabled while connected to enlarge window; HDMI output. PIP...
Tech Portal : 6000 : Equipment : Enhanced HD Module
... connection on the screen, unplug the receiver and disconnect the cable from the dish will say the same thing in the receiver. Unplug the receiver's power cord. Cover the Accessory Jack with the screws I complete the installation of the module and gently pull to HDTV Troubleshooting Symptom Missing DISH Network HD channels, signal loss. Plug the module into any cable is working...
Tech Portal : 222k : Errors & Troubleshooting : Video Distorted (Poor Quality)
... the TV2 goes to 73, set the modulator to reference the TV's owner's manual.) Why? At the TV2 location, tune to the TV Video input. Continue Insert and play a VHS tape or DVD with the TV. Unplug then reinsert the cable. Verify both modulator settings as this is connected hand tight from the OTA Module’s TV Ch 3 – 4 Out coax output to the receiver menu...