Dish Remote Won't Operate The Tv

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on April 25th, 2014 12:31 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,100
points

If you have not gotten this resolved, I would be happy to assist you! The following link has steps to program the remote to the TV. Please email me at [email protected] for further assistance if needed!

http://www.mydish.com/support/program-to-tv-code-non-basic

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 625 : Receiver Images
...Mode (amber) MPEG-2/DVB compliant MPEG is active. DISH 500 Antenna, DISH Pro Twin (1) DISH 500 dish antenna (1) DISH Pro Twin LNBF (1) 3.0 IR remote (1) 4.0 IR/UHF Pro remote Monday September 15 2008 © watch the same programming on the television. DISH Player-DVR 625 DishProPlus SD Interactive TV Two-TV Dual-Tuner IR/UHF Pro Residential/Commercial Receiver...
Tech Portal : 622 : Receiver Information : Receiver Images
...not interrupt a download in a slide show on -screen channel and program info. TV2 remote does not operate receiver. reverse back up space on TV1 and TV2. It requires a one time-... (8 total), capable of storing a combined total of interactive television is a default feature that Dish Interactive TV has to the hard drive. IR Blaster MPEG-4 and MPEG-2 technology Method to a 16...
Tech Portal : 3750 : Errors & Troubleshooting
... steps are red in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on the receiver to Point Dish/Signal. Then go to a TV video input. screen. ... using the known good cable (between the TV and VCR), brings the installation down to basics and only leaves the receiver or operator error as favorite lists and locks may need...