Dish Remote Won't Change Channels

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by CheriTDISH on October 15th, 2013 10:02 AM

This answer was accepted by the poster of the original question.

CheriTDISH

Member since:
December 23rd, 2010

Points: 149,620

1,100
points

Hi, I would be happy to help! Please follow the instructions below to readdress your remote to your receiver. If this does not resolve your issue please send me an email at [email protected] with more details. Thank you!

1. Press the menu button on the front of the receiver.

2. Press and hold down the SAT button on the remote until all the lights are lit.

3. Enter any number 1-15 on the remote keypad.

4. Press the pound(#) button once.

5. Press the record button 3 times.

Cheri Torres

Social Media Representative

DISH L.L.C.

[email protected]

Cheri Torres
Social Media Team
DISH L.L.C.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
... (TV2 OUT), you must install the attenuator in Appendix B of the receiver. button on the remote control and change channels on channel 25. If there is suitable, however, you must meet these requirements, an in the TV as a possible channel. A channel selection within the home. is no programming or adjacent to use the TV2 composite audio...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... DVHS-IRR, 7100/7200 are replaced frequently (multiple times per month), RA the remote. Verify the receiver and the converter are no response to remote commands or changing channels on . Check the line of sight to the front of the receiver (reference ... interference to take, click here . Please refer to the receiver. Is this a DISH Network converter and remote? The issue may help.
Tech Portal : Remotes : Troubleshooting
... as delayed or no response to remote commands or changing channels on their ow Point the remote directly at the equipment, with a maximum range of 40 feet. The IR remote controls equipment a maximum range of 40...the room, between the receiver and the remote. If the problem persists, please call 1-800-333-DISH (3474) for assistance. Does the functionality return when closer to the...