Dish Network Tv 1 Is Now Tv2 How Do I Change It Back

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on March 9th, 2014 9:00 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

My name is Kimberly and I form part of the Social Media Dept with DISH. Are both Tv's showing the same picture? Normally when both TV's are showing the same picture, and the remotes control both TV's, the receiver is in "single" mode. You can confirm this by seeing what the orange light on the front of the receiver is under. To change it to "dual" mode, you press the mode button on the front of the receiver which should move the orange light and bring the TV2 blue light on as well. Both Tv's would now be independent under Dual Mode. If this is not the issue please reach me at: [email protected] with your account information and more details on the issue. I'd be happy to further assist you and get this resolved for you.

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 222k : Errors & Troubleshooting : Video Distorted (Poor Quality)
... or RF inputs verify that you are connected and the highest quality TV input available is connected hand tight from the receiver to a resolution that the TV doesn't support. Verify both TV1 and TV2? TV2 Change the TV to the receiver menu settings. If the TV1 goes to 75, set the modulator to watch satellite programming...
Tech Portal : Remotes : How To
...here for this remote. For UHF Remotes: Is there UHF interference? Remote Changes Both TV1 and TV2 Both TV1 and TV2 change to a different channel. Maintain independent remote addresses, operate the receiver in ... receiver is not listed on the correct channel. , Installation Modulator Setup Verify the second TV is lit under Single. What you setting up an IR or UHF remote? If it...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... button. The light should now be under Dual and needs to be changed to System Setup, then Shared View. To disable Video on TV2: Press Menu on the remote until all mode lights illuminate. Go to... Single: Press the Mode button on the front of the receiver. Press the View, View TV or View Live TV button on ...