Dish Network Channel Remote 2 Address Wont Change

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on December 7th, 2013 9:57 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there gadevon, my name is Kimberly and I form part of the Social Media Department with DISH. I regret the inconvenience you have experienced with our remote and will be happy to help you. First make sure that you are using the correct remote control #2 in case you have more than one dual receiver at home. If you do, check that your UHF remote antenna is securely connected to the "Remote Antenna" port on the back of your receiver and that the antenna is upright. Try addressing the remote again. Please take the remote to the TV1 location (where the receiver is) once you are here, (using remote #1) Press Menu on the remote twice, this should take you to the System Info screen. On the System Info screen towards the bottom you will see listed 'Remote address 1' and 'Remote address 2' put remote #1 down and grab remote #2. On the remote, press and hold the clear SAT button at the top for 5 seconds (once the buttons begin to flash) press the number 8 button on the remote, and then the 'Record button 3 times' After this procedure grab remote #1 again and press 'Select' take remote #2 to Tv. 2 location and try it. If you need additional assistance please contact me at:[email protected]

Kimberly Escobar
Social Media Representative
DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : How To : Setting Timers
... a higher priority timer at this channel Mon-Fri: timer fires for a 625 receiver). Press Select on the remote. Deleting recorded events Deleting an Event DVR Select the event to and select Done. Adjust start and end time and to be available. Name Based Recording works on the remote. To change . Setting up a timer, select...
Tech Portal : Remotes : Buttons & Images
... it reaches normal speed. The following instructions: Press and hold the RECOVER button until you have recovered your receiver. If you accidentally change the remote control address. You have accidentally changed the TV channel or video input. Skip back one time for a D, and 9 three times for a U, 3 one day at a time in the Program Guide. A high...
Tech Portal : Remotes : How To
... and TV2 Both TV1 and TV2 change to a different channel. Remote addresses are the same, receiver is lit under Dual. If the mode light on the front of the receiver is in the Modulator Setup screen. Highlight and select Disable View Done Verify TV2 is on the correct channel. , Installation Modulator Setup Verify the second...