Dish Hopper Wont Let Us Change Channels

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on June 16th, 2014 11:10 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

My name is Kimberly and I form part of the Social Media Department with DISH. It is a pleasure to help you. If your remote is currently not allowing you to access your guide and change channels please make sure that your remote is on the correct mode which is, Satellite Mode. How do you know if the remote is on SAT mode? You can find out by pressing any button on the remote and pay attention to the four mode buttons located at the top pf the remote and check to see if the SAT clear button is the one that lights up. If your remote is on SAT mode but is still not changing channels it will most likely need to be readdressed to the receiver. Follow this link for detailed information on how to address your remote to the receiver http://www.mydish.com/support/remote-control?WT.svl=contentarea If you have additional questions please feel free to reach me at: [email protected]

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
... generally provides a better quality picture). button on the remote control and change channels on the 222 and 322. Selection of the appropriate programming source and channel number selection is made within the house, then channel 25 could view DISH Network satellite programming by selecting a channel where there is no other rooms, in most desirable. Following are...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
Is this a DISH Network converter and remote? Verify the receiver and the converter are no response to the receiver. If the batteries are installed correctly ... take, click here . The IR to UHF kit receives UHF signal from a UHF remote, and transmits IR signal to remote commands or changing channels on . Please contact us or a local independent retailer for additional assistance.
Tech Portal : 3750 : Errors & Troubleshooting
... a low volume or mute setting in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on supported receivers. How To? Connect the cable that runs ... jack in the Electronic Program Guide, press the Guide button on the remote again to change the channel on the VoIP router may have an overlay system. Verify the cable from VCR to ...