Tv Remote Numbers For Vizio Tv's?

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by DanBwithDishNetwork on May 13th, 2012 3:04 PM

This answer was accepted by the poster of the original question.

DanBwithDishNetwork

Member since:
December 23rd, 2010

Points: 72,970

1,230
points

95% of all Vizio TV sets use the remote code 505 on a DISH remote. If that fails try the following codes. 627, 506, 766, 678, 458, 500, 670, 888, 629 To address the remote hold the cear "TV" button in the upper left hand corner of the remote for 5 seconds then enter the code followed by the # (pound) button. Once you have entered in the code press the "SAT" key and try the volume mute and power buttons. Let me know if you have any trouble, my email address is [email protected]

Daniel Busa
DISH L.L.C.
Social Media

Daniel Busa
DISH Internet Response Team
[email protected]
3:00PM-11:00PM (MST) Tues-Sat

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
... operating the receiver as normal. The TV2 OUT is a suitable choice to distributions with a large number of TVs or when long cable runs exist. If there is amplified to the "SAT" To ..." Connector Color Code Chart CONNECTOR COLOR Satellite In Blue TV Ant/Cable In Black TV SET OUT White TV2 OUT Yellow UHF Remote Antenna Green The TV2 OUT is made within that naturally occurs...
Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
... codes by pressing and releasing the gray satellite mode button. Release the antenna button. TV light stays on . Put the remote back in your remote control. The light will flash three times Turn your TV. The way a VCR displays channel numbers may differ from an off -air channel. Thursday August 21 2008 ©...
Tech Portal : DTVPal DVR : Remotes : DTVPal DVR 5.3 IR : Buttons & Images
.... Display the DTVPal's System Information screen. To control analog signal pass-through TV inputs to DTV programming. Places the Remote in DTV Mode. Closed Captions (CC) Button - DVR button - Mute ... - Guide Button - Left/Theme Button - enter numbers in DTV Mode to set or change the remote address, press # to limit search ( 0 for a 2nd TV, 1 for a 2nd VCR, 2 for skipping one...