Remote For Tv 2

I have 2 televisions hooked to my receiver. each is labeled one and two. the remote for tv 2 is now contolling tv one on receiver. how do I get the remote back to contolling tv2 input on box.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MaryBDish on December 15th, 2012 3:15 PM

This answer was accepted by the poster of the original question.

MaryBDish

Member since:
December 30th, 2010

Points: 627,730

1,100
points

Hi, I am sorry that you are having this problem with your receiver and I will be happy to assist you. On the front of the receiver, right hand side is a little door that will open from the top. Inside this little door will be a MODE button. Press it until the blue light lights up on the front of the receiver. If you have any additional questions or concerns, please email me directly. Thank you!

Mary Catherine Brady
DISH Internet Response Team
[email protected]
Tuesday-Saturday 2:45pm-11:15pm(MST)

Answer #2: Posted by coastie97 on December 15th, 2012 1:30 PM

coastie97

Member since:
December 15th, 2012

Points: 50

100
points

On receiver someone pushed the mode button which switched it from dual mode to single mode. Thanks for assistance.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Remotes : 6.3 IR/UHF/UHF Pro
... Response IR Delayed Response UHF Draining Batteries Loss of Functions Remote Changes Both TVs Troubleshooting IR to Other Equip. Feedback Forums Contact Us SEARCH: HOME RECEIVERS REMOTES TROUBLESHOOTING Select Symptom Addressing to the Receiver Addressing to UHF Kit Troubleshooting w/ TV/VCR/AUX Troubleshooting TV2 IR Converter Kit 6.3 Remote Codes About IR About UHF About UHF Pro Battery...
Tech Portal : 3750 : Errors & Troubleshooting
... replaced. If yes , wait for initial software download. Verify the television is on the receiver to the TV. TV2 OUT. The TV must download PPV and/or DOD events. The input source can be reset to resolve the issue. If no video, replace cable between the TV and VCR and the VCR output can be needed to...
Tech Portal : Remotes : Troubleshooting TV2 IR Converter Kit
... of the TV, cabinet, or tabletop, ensuring that the cable is set to take; . Please contact the manufacturer of the sensor. Reference the TV2 IR Converter page for the remote control. Receiver TV2 / TV1 ...on receivers model. This can be set to IR Verify the remote control is to the receiver? Are you programmed the remote to the rear of your equipment. If the television ...