I Need To Reprogam My 2nd Tv Remote And Don't Know How. Help

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MaryBDish on July 8th, 2011 3:41 PM

This answer was accepted by the poster of the original question.

MaryBDish

Member since:
December 30th, 2010

Points: 627,730

1,080
points

Hi, here are the steps to reprogram your DISH Network remote:

1. Go to the System Info screen (Menu-Menu)

2. Hold down the "SAT" button on the remote until all mode lights light up.

3. Enter a number between 1 & 15 using the numeric keypad on the remote.

4. Press the (#) button under the number 9.

5. Once the Sat button blinks three times, press the black and red record button.

NOTE: If successful, the number in step # 3 will appear in the System Info screen under Remote Address.

I hope this helps, but if you have any additional questions please feel free to contact me directly. Thank you!

Mary Catherine Brady

DISH Network Customer Support

[email protected]

Mary Catherine Brady
DISH Internet Response Team
[email protected]
Tuesday-Saturday 2:45pm-11:15pm(MST)

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... TV Mode, (you will need two discrete buttons for the remote,...Remote. For programming a TV (or a 2nd TV in AUX mode), limited mode will not teach the learning remote. 3.0 IR, 3.1 IR, ot 3.2 IR With the desired equipment on the DISH remote that controls the TV. for the remote...Remote. If still no way to know your TV code, blink out the code by the Green UHF Pro remote, the Primary Remote...
Tech Portal : (choose receiver model) : Remotes : (choose remote)
... 3 seconds), then release. remote because of your TV screen should match the one that equipment. The receiver will need this later). Note: Any button on the DISH remote that equipment. To verify that... check that the mode light is programmed into TV Mode, (you input. If you do not know your TV code you are multiple RCA TV codes). Use the number buttons to enter the...
Tech Portal : Remotes : Buttons & Images
...2nd TV, 1 for a 2nd VCR, 2 for widescreen displays. Satellite Mode Button - Note: The SELECT button may use the RECOVER button, complete the following section, the remote...if you need to raise (+) or lower (-) the TV sound volume. Press this button to enter the number. See your TV to open...'ve set the remote to show you see help information when a Help button appears in the...