What Hdmi Version Does Software L625 Support?

I have software version L625 on my receiver. Does this support HDMI 1.3?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by KirstieFwithDISHnetwork on February 3rd, 2011 10:09 AM

This answer was accepted by the poster of the original question.

KirstieFwithDISHnetwork

Member since:
December 23rd, 2010

Points: 24,540

1,100
points

The HDMI version supported would be dependent upon the actual type of receiver you have. As of right now all of our DISH Network receivers support HDMI version 1.3 but compatible with 1.4. I hope this helps & answers your question!

-Kirstie DISH Network

DISH Network Executive Office

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 3750 : Errors & Troubleshooting
...None, Snow VIDEO - If using RCA cables or cable for 15 minutes to update old software to change the channel on supported receivers. The TV input source must be turned off to the TV. How is connected to ... again to the most current version. By ensuring that it may not be shown on ch.101 and ch.9900, ch.580 if you have to remain off the receiver for Dolby Digital. If no...
Tech Portal : Errors & Troubleshooting
... installation process is being installed. The receiver does not recognize a Dish 500 when a Dish 500 does not exist. Verify the receiver's software version matches the software version on 110W. If the problem persists ... to System Setup, Installation, and Point Dish/Signal. This can be prevented by entering supported HDTV codes. If you have a DISH Pro or Legacy Twin or DISH Pro or ...
Tech Portal : Errors & Troubleshooting
... version to the programming services. Do NOT change the smart card number on the account. Channel directory or Programming: Basic Packages Does customer have problems with the steps suggested that the customer is calling back after day 21. If the DNASP number is the receiver active? Avoid authorization issues by maintaining current software...