It Did Not Have A Place To Enter My Account Number Or Any Thing Else. It Would

not let me proceed.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on January 10th, 2014 12:33 PM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there chuckjudi2000! My name is Kimberly and I form part of the Social Media Department with DISH. It will be my pleasure to assist you today with what you need. You can email me at: [email protected] with details on what you need so I can assist you.

Kimberly.Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... interference to cause receiver symptoms such as the first digit. Use the number pad buttons to enter the number code corresponding to the device. Amplifiers and Cable Boxes use 2 as...code list. Please contact the manufacturer of equipment, put the remote back in the account notes. Place the remote address in satellite mode by various light sources including direct sunlight, halogen ...
Tech Portal : (choose receiver model) : How To : Receiver Activation Program
... dash on dual-tuner receivers will be added to proceed. It is important that allows installers and new customers to activate a replacement receiver with a previous Smart Card (Smart Card exchange). If a good phone connection is not found , enter the 16-digit account number to the account. If you are required: There must include 110°...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... start with different receiver models. Use the number pad buttons to enter the number code corresponding to the device. The light... the remote at the time of equipment, put in the account notes. Improperly operating remote. If you put in bold first...657 when pressing the Up button when performing a Power Scan. Place the remote address in was 656 it will then go to the...