Dell PowerEdge 2900 Support Question
Dell PowerEdge 2900 Support Question
Find answers below for this question about Dell PowerEdge 2900.Need a Dell PowerEdge 2900 manual? We have 9 online manuals for this item!
Question posted by rmiciano on September 18th, 2018
E161c E1614
I have ben a fail a in message monitor the Server PEdge 2900E1624E161C
Current Answers
Answer #1: Posted by waelsaidani1 on September 20th, 2018 6:57 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,777
Member since:
May 12th, 2013 Points: 19,501,777
This problem could be caused by disk failure, refer to solution here: https://www.dell.com/community/PowerEdge-HDD-SCSI-RAID/DELL-Poweredge-2900-Disk-failure/m-p/5044810#M44611
Related Dell PowerEdge 2900 Manual Pages
Installing a SATA Optical Drive - Page 3
... Installing a SATA Optical Drive
3
Installing a SATA Optical Drive
These instructions apply to Dell™ PowerEdge™ systems to remove the system cover and access any of the system.
See "Removing a ...peripheral bay and remove the optical drive from the back of the optical drive.
6 PowerEdge 2900 and 1900 systems only: Perform the following steps. See "Removing the Bezel" in which...
Installing a SATA Optical Drive - Page 4
...is used for the SATA optical drive. The PowerEdge 2900 and 1900 systems do not reuse the interposer board attached to the optical drive. On PowerEdge 1950 systems, the existing optical drive tray ...interposer board outward to lock it into the corresponding holes in the same carrier. Replacing a PowerEdge 2950 or 2970 Optical Drive
NOTE: If you are replacing an existing IDE optical drive, ...
Installing a SATA Optical Drive - Page 9
9 Replace the cooling shroud. See "Closing the System" in your Hardware Owner's Manual.
11 Reconnect the system to the SATA connector on the system board. PowerEdge 2900 and 1900
1 If the mounting screws are not attached to the drive, install them now.
2 Align the mounting screws with the bay slide slots and ...
Installing a SATA Optical Drive - Page 10
....
10 Reconnect the system to the SAS controller daughter card.
9 Close the system. See "Closing the System" in a PowerEdge 2900 or 1900
3
2
4
5 1
1 optical drive 3 SATA data cable 5 SATA power connector on SAS
backplane (PowerEdge 2900 only)
2 SATA power cable 4 SATA connector on system board
8 Reconnect the cables to power and turn on the system...
Information Update - Page 1
Dell™ PowerEdge™ 2900 Systems
Information Update
Information Update - Page 3
Safeguarding Encrypted Data 9
System Message Update 10
LCD Status Messages Update 14
System Setup Program Update 19 Memory Screen 19 CPU Information Screen 20 Integrated Devices Screen 20 System Security Screen 21 Serial Communication Screen 22
Contents
3 Contents
PowerEdge 2900 III - New System Features 5 New Performance Features 5 New I/O and Storage Features 5 New Security ...
Information Update - Page 5
...safeguarding encrypted data • System message update for PowerEdge 2900 III system • LCD status message update for PowerEdge 2900 III systems • System Setup program update for iSCSI boot. Information Update
5 New Security Features
• Trusted Program Module (TPM) support for improved security. • Optional support for PowerEdge 2900 III systems • Operating...
Information Update - Page 6
... storage device. The USB memory key can be enabled in the Integrated Devices screen of the System Setup program. Optional Internal USB Memory Key
The PowerEdge 2900 III system provides an internal USB connector located on page 20.
Information Update - Page 9
....dell.com for your hard drive(s). Safeguarding Encrypted Data
On PowerEdge 2900 III systems using Windows Server® 2008, you are prompted to the 5100 and 5200... recovery key. Information Update
9 Be sure to secure the contents of quad-core Intel Xeon processors. PowerEdge 2900 II and PowerEdge 2900 III Systems
• If the front of your system chassis is labeled with a "II", your ...
Information Update - Page 10
...! The memory configuration does not support node interleaving, or the configuration has changed (for the PowerEdge 2900 III system and the probable cause and corrective action if the message appears. System Message Update
Table 1-1 lists new system messages for example, a failed DIMM) so that node interleaving cannot be available... Remote Access Controller initialization failure
Ensure that...
Information Update - Page 14
... site.
Faulty USB device, USB medium, optical drive assembly, hard drive, or hard-drive subsystem. For hard drive problems, see the system documentation on the PowerEdge 2900 III system and the probable cause for each message. For more information on selected drive
Causes
Invalid memory configuration.
Information Update - Page 21
... reports the TPM to the TPM during POST.
Integrated Devices Screen Options (continued)
Option
Description
System Interrupts This field controls the interrupt assignment for the PowerEdge 2900 III system.
Information Update - Page 23
.... Information Update
23 RHEL - SATA Optical Drive Support on RHEL3 and SLES9
SATA optical drives are supported on the Server OS Install tab.
Incorrect Processor Information
• If an Intel Xeon 54xx processor is installed in a system running ... information is displayed in /proc/cpuinfo. (The actual processor speed is supported by the PowerEdge 2900 and 2900 II systems, but not by the...
Information Update - Page 46
System Security
表 1-6 PowerEdge 2900 III TPM。
TPM Security （TPM TPM。
表 1-6. 新的 System Security
选项
说明
TPM Security
TPM
（TPM Off [
关
]&#...
Information Update - Page 48
Microsoft Windows 2000
System Build and Update Utility Microsoft® Windows® 2000 将位于 Server OS Install PowerEdge 2900 和 2900 II PowerEdge 2900 III
Customize Log output file pathname USB
1-3
48
信息更新
Information Update - Page 116
PowerEdge 2900 III 1-1
表 1-1
原因
対応処置
Alert! Node Interleaving disabled! Memory configuration does not support Node Interleaving.
れかの DIMM
ださい。
116
Information Update - Page 133
...; cat/sys/devices/system/cpu/cpuxx/cpufreq/scaling_ cur_freq
• RHEL 3 9 Intel Xeon 54xx proc/cpuinfo
RHEL 4
Microsoft Windows 2000
System Build and Update Utility Server OS Install OS OS Microsoft® Windows® 2000 PowerEdge 2900/2900 II OS PowerEdge 2900 III
133
Information Update - Page 146
... Node Interleaving.
DIMM
!!*** Error: Remote Access Controller initialization failure *** RAC virtual USB devices may not be available...
PCIe PCIe SAS
146
Node Interleaving disabled! 표 1-1 PowerEdge 2900 III
표 1-1
메시지
원인
Alert!
Information Update - Page 158
표 1-6에는 PowerEdge 2900 III TPM TPM Security(TPM TPM
표 1-6
옵션 TPM Security (TPM Off ( 끄기 ))
TPM Activation (TPM 활성화 )
설명
TPM
Off ...
Information Update - Page 160
.../cpu/cpuxx/cpufreq/scaling_ cur_freq
• Intel Xeon 54xx RHEL 버전 3 9 proc/cpuinfo
RHEL 4 Update
Microsoft Windows 2000
Microsoft® Windows® 2000 이 Server OS Install(서버 OS PowerEdge 2900 III 대신 PowerEdge 2900 및 2900 II
USB
160
Similar Questions
What Is E1000 Failsafe In Dell Poweredge 2900 Server
(Posted by brdodge 10 years ago)
Dell Poweredge 2900 Server Says Log File Is Full Where Is It
(Posted by namemik 10 years ago)
When I Installing Server 2003 On Poweredge R710 It Give Message I Could Not
find hard drive
find hard drive
(Posted by jcfaaaaaa 10 years ago)
Dell Poweredge 840 Flashing Orange Light Monitor Does Not Display
(Posted by mofjorg 10 years ago)
Why Fan Of Poweredge 2900 Dell Servers Keep Running After Upgrade Ram
(Posted by wta2ngcs 10 years ago)