Danby DAC6011E Support Question
Danby DAC6011E Support Question
Find answers below for this question about Danby DAC6011E.Need a Danby DAC6011E manual? We have 1 online manual for this item!
Question posted by Anonymous-139576 on July 7th, 2014
Ac Settings
I hit the button to shut off the outside air suction (at least I think that's what the button does) and can't seem to get it turned back on. Now my AC doesn't seem to be putting out as cold of air as it did before. Any suggestions?
Current Answers
Related Danby DAC6011E Manual Pages
Product Manual - Page 2
...; Caractéristiques • Installation • Consignes d'utilisation • Soins et Entretien • Dépannage • Garantie
Model • Modèle DAC6010E / DAC6011E Contents
AIR CONDITIONER Owner's Use and Care Guide 2-17 • Welcome • Important Safety Information • Features • Installation • Operation Instructions • Care and Maintenance...
Product Manual - Page 4
....
See Table 1 for specifications for receptacle and fuse information. DO NOT use an approved "air conditioner" extension cord only (available at most local hardware stores).
6) The rating plate on copper ...wire at 60°C temperature rating. If you are not sure whether your air conditioner, use plug adapters. If it is located on the service cord supplied with local and...
Product Manual - Page 5
... the room, but do not allow drapes or curtains to obstruct the air flow around the unit.
4) Start your air conditioner before installing or servicing.
Inadequate support on a cooling setting.
Features
Interior Air Outlet Control Panel Interior Air Inlet
Cabinet Exterior Air Inlet Air FIlter
Installation Instructions
ELECTRIC SHOCK HAZARD To avoid the possibility of personal injury...
Product Manual - Page 6
... be necessary to fit easily into a single or double hung window. Your air conditioner may fail to evaporate condensation under extreme humidity conditions, excess condensation may be ... This room air conditioner is designed to make some modifications for ample air circulation through the unit (See Fig. 2). However, since window designs vary, it is advisable to the outside.
D) Provide...
Product Manual - Page 7
... installed on some units)
• "L" Shaped Top Channel: Install the "L" shaped channel to the top of the window sill that the air conditioner will rest on the side channel of the air conditioner, as left and right.
3) Completing the Installation
• Cut the foam (non adhesive) sealing strip to fit the area of the...
Product Manual - Page 8
...screw (See Fig. 6). Installation Instructions
3) Completing the Installation (cont'd)
• Carefully place the air conditioner into the window with the "L" shaped mounting bracket (on the "recessed" portion of the window ...positioned on top) positioned in a variety of the cabinet should be necessary to the outside window frame using one 3/4" screw on each side (Fig. 5).
• Place the ...
Product Manual - Page 9
... is off (Auto-On): 1) Press the Auto-Timer button once and the adjacent Auto-On indicator
light will appear in either "Celsius" or Fahrenheit" according to your preference.To change the temperature scale displayed on the set temperature is complete, the air conditioner will be cancelled by turning the unit On/Off.
8 MODE: Allows you...
Product Manual - Page 10
...air conditioner may not function properly.
Operating Instructions
USING THE REMOTE CONTROL
Location of the remote controller.
• Use the remote controller within a distance of CPU Emitting Signal Signal Receiving Range
Environment
R15A, R15B, R15C 3.0V(Button... IN G
TIMER
FA N SLEEP
CAUTION
• The air conditioner will not operate if curtains, doors or other electrical appliances...
Product Manual - Page 11
... temperature for you . TEMP UP FA N
S
TEMP DOWN
ENERGY SAVER
TIMER
CLEAN AIR
SLEEP
TEMP DOWN button
Push this button to decrease the indoor temperature setting in 1°C increments to select the fan speed in three steps:
LOW MED
HIGH
CLEAN AIR button (on COOL, HEAT or AUTO mode only and maintain the most comfortable temperature...
Product Manual - Page 12
... power is 2 available.
1) Press the ON/OFF button to start the air
3
conditioner.
2) Press the mode button and select
AUTO.
3) Press the TEMP UP / DOWN button to control the room temperature either. If the Auto mode is not comfortable for you can be set within a range of
CLEAN AIR
SLEEP
17°C~ 30°C in 1°C increments...
Product Manual - Page 13
...button while the unit is selected. • The temperature will then increase by another 2°F after an additional 30 minutes. • This new temperature will be maintained for about 10 seconds until the
setting temperature reverts back in a range of the air conditioner. NOTE: • To set... cold/hot air alternately to obtain comfortable cooling/heating.
2) Press the SWING button again...
Product Manual - Page 14
... can be set in the
display window of the air conditioner. NOTE: To cancel the TIMER setting, push the TIMER button until the
setting temperature reverts ...AIR
SLEEP
CLEAN AIR OPERATION
When this mode, the fan will continue to stop feature
can be set temperature, at which time the compressor turns back on the LCD window of the air conditioner. ON/OFF
MODE
1) Push the TIMER button...
Product Manual - Page 16
... on the front of the air conditioner is taken to install the air filter. It is obstructed and reduces efficiency.
Use of the unit.
2) Turn off power and remove plug from wall socket.
3) Clean filter.
4) Store (covered) air conditioner in a dry location. Care and Maintenance
CLEAING
When cleaning the air conditioner, be sure to turn the SELECTOR knob to...
Product Manual - Page 17
PPRROOBBLLEEMM
1) Air conditioner will not operate.
2) Inefficient or no cooling.
3) Noisy unit. 4) Odors. 5) Water dripping outside temperature. • Unit air filter is dirty.
• When outdoor temperature is approximately 18.3°C (65°F) or below, frost may form when unit is minor in nature, and a ...
Product Manual - Page 18
...requiring service outside the limited...is hereby expressly excluded. GENERAL PROVISIONS No warranty or insurance herein contained or set out shall apply when damage or repair is caused by any of the following...warranty is not approved for commercial or industrial purposes (ie. EXCLUSIONS Save as inadequate air circulation in customer education. 8) Improper Installation (ie. If the appliance is not...
Product Manual - Page 26
...to the remote controller, either move these appliances or the service depot. Use curtains to direct sunlight, the air conditioner may not function properly. Reception is exposed to prevent the sunlight from falling into the remote controller. REMOTE ... of CPU Emitting Signal Signal Receiving Range
Environment
R15A, R15B, R15C 3.0V(Button cell: CR2025) 2.0V 5m -5°C ~ 60°C
25
Product Manual - Page 27
.... TEMP UP FA N
S
ENERGY SAVER
TEMP DOWN
TIMER
CLEAN AIR
SLEEP
TEMP DOWN button
Push this button to decrease the indoor temperature setting in 1°C increments to side.
Consignes d'utilisation
REMOTE CONTROLLER BUTTONS
NOTE: Modle R15B does not have the CLEAN AIR feature.
TIMER button
Push this button to AUTO. This function is available on some models)
When...
Product Manual - Page 28
... Dehumidifying by sensing the difference between the actual ambient room temperature and the set the desired temperature. ON/OFF
MODE
3
3 1) Press the ON/OFF button to start the air
3
conditioner.
2) Press the mode button and select
AUTO.
3) Press the TEMP UP / DOWN button to select auto. The
temperature can be selected manually. NOTE: In the Dehumidifying...
Product Manual - Page 29
..., the vertical louvers automatically swing right and left sweeping the cold/hot air alternately to obtain comfortable cooling/heating.
2) Press the SWING button again to set the Autostart and Auto-stop the swing operation.
The time can be in the
display window of the air conditioner. After the desired time has established,
wait for 7 hours before...
Product Manual - Page 30
... temperature is above the set in the
display window of the air conditioner. This indicates the program is displayed on and cooling stars.
29 Consignes d'utilisation
USING THE REMOTE CONTROLLER BUTTONS
TIMER OPERATION To set . CLEAN AIR
SLEEP
4) After the desired time has established,
wait for 2 minutes at which time the compressor turns back on the LCD...
Similar Questions
The Remote Control Is Not Working.how To Set Temperature Without Remote
how to set temperature without re
how to set temperature without re
(Posted by Annydhawan 1 year ago)
Ac Unit Not Blowing Cold Air
My DAC12010E is going into its 3rd summer and is no longer producing cold air. The temp is set at 62...
My DAC12010E is going into its 3rd summer and is no longer producing cold air. The temp is set at 62...
(Posted by Davidsturge 8 years ago)
How Do I Set Up A Danby Dpa100a1gd Portable Air Conditioner
How do I set up a portable air conditioner? How does it drain?
How do I set up a portable air conditioner? How does it drain?
(Posted by Jujubeads 10 years ago)