Home » Cub Cadet » Lawn Mowers » Cub Cadet ZT1 42E

Cub Cadet ZT1 42E Support Question

Find answers below for this question about Cub Cadet ZT1 42E.
Need a Cub Cadet ZT1 42E manual? We have 2 online manuals for this item!

Cub Cadet Overview Questions Manuals Reviews Videos Research

Question posted by Yamastar118 on June 11th, 2022

Cub Cadet Lt1 42e

it will not charge and shows S01 on the vcm what does that mean and how do I fix it? Only has 10 hrs

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on June 11th, 2022 10:29 AM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,633,680

1,090
points

https://www.manualslib.com/manual/1065738/Cub-Cadet-Rzt-S-Zero.html?page=99

https://cub-cadet.tractorerrorcode.com/

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Related Cub Cadet ZT1 42E Manual Pages

Operation Manual - Page 2

..., and are involved in a large percentage of the operator can cause serious personal injury. 2. Always wear safety glasses or safety goggles during operation. Do not charge or operate the tractor in serious injury. These operators should be operated according to avoid discharge of its useful life, have the product inspected annually...

Operation Manual - Page 3

... Overspeeding may become hot and can be dangerous and they must stay away from it at least 10 feet (3 meters) from the tractor, which could suddenly appear in . 14. They do not... The tractor is over accidents, always look down and behind and down before attempting any adjustments. 10. Restart the tractor. Never carry passengers. 13. Do not operate the tractor while under the ...

Operation Manual - Page 4

... into a trailer or truck. Do not attach towed equipment except at least five minutes before charging or storing. 4. Do not tow on slopes greater than (5) five seconds after disengaging the blade...or death. Check the blade(s) mounting bolt torque in accordance to complete stop in not more than 10 degrees (17%). 9. Replace the blade(s) with a stop completely in less than 15 degrees (25%)....

Operation Manual - Page 5

... the charger specified by a cord. Recharge only with the battery charger specific to charge the batteries in the motors and electrical connections. Make sure the extension cord is suitable...; and 104° F (0° and 40° C). 5 If in any way. 10. Damaged cords should be provided on the charger indicates the voltage used unless absolutely necessary. To reduce...

Operation Manual - Page 6

...with conductive materials, such as follows: 1. Exercise care in handling batteries in order not to charge a cracked or damaged battery. 4. Leakage from the battery may explode. Open manual to temperatures... Do not short the battery with the object. 4. Do not use or charge a wet battery or a battery that shows any evidence of fire or chemical burn if misused. The battery or conductor ...

Operation Manual - Page 7

.... Keep bystanders, children and pets inside during operation. ELECTRIC SHOCK Do not charge tractor in its proper place. Contact with water. Belt and/or blade spindle... AVOID TIP-OVER/ROLL-OVER INJURY Do not operate machine on the mower before attempting to learn more information. > 15 < 15 >10 ft (3 m) >10 ft (3 m) DANGER - WARNING - WARNING - Keep this information ...

Operation Manual - Page 8

... position, stop engine and remove key before attempting to remove the mower deck. WARNING - Do not charge tractor in rain. WARNING Your Responsibility-Restrict the use of this ...unauthorized use . If you are leaving the tractor unattended, always remove the key to charge this tractor. SAVE THESE INSTRUCTIONS! 8 Read this Operator's Manual before attempting to persons...

Operation Manual - Page 10

... adjustment. 2. Position Lapbar Drive Control Levers The lapbar drive control levers can be used to secure the lapbar drive control lever into the desired position. 10 b Figure 8 TO ADJUST THE LAPBAR DRIVE CONTROL LEVER HEIGHT: 1. Align the two chute deflector mounting holes (a) with the carriage screws and flange lock nuts (Figure...

Operation Manual - Page 11

...level surface, preferably pavement. 2. www.P65Warnings.ca.gov. Keep away from the deck (Figure 10). 7. Do not puncture, disassemble, mutilate, or incinerate. Recharge only with the charger provided with... Refer to support the weight of four index holes on previously adjusted wheel. Do not charge or operate the tractor in the rain or in wet conditions. ASSEMBLY REMOVING THE STOP ...

Operation Manual - Page 12

...Stand behind the tractor and pull back on the Vehicle Control Module (VCM) will blink continuously when charging and the LCD display will take approximately 4 hours to the charger for...that results in a discharged state could cause a system fault that the tractor be fully charged after a complete charge. • It will display percentage of power. Power off the tractor. 2. Unplug ...

Operation Manual - Page 14

... to remove the footpan bolt, adjust the height of several control buttons for detailed instructions regarding the VCM and operating the tractor. 1. This mode is OFF. 5. E. OPERATION D. Start/Stop Button -...the cutting deck (blades ON), press and hold the PTO button for more information on the VCM, the LCD display & battery level indicator are used as a removal tool with the 1/2" ...

Operation Manual - Page 15

...device. Refer to the Assembly & Set-Up section for more information. To access the charging port, lift up other USB devices. K. Refer to Safety Interlock Switches for instructions on...18 G. The ports can be adjusted using the knobs on adjusting the seat position. CHARGING PORT The charging port is not equipped with a safety interlock system for stopping the tractor or setting ...

Operation Manual - Page 16

...for instructions to adjust the lapbar drive control levers so that allows you will display on the VCM when the key switch is turned on the control levers. Set the lapbar drive control levers ... motion of the tractor. 2. If the cutting deck is ready to operate the controls. Unplug the charging cord (if necessary) (Figure 19). Press the start /stop button down until you strike a foreign...

Operation Manual - Page 19

...pets inside during operation. Your tractor is designed to mow heavy brush and weeds and grass taller than 10" (25.4 cm). Do not cut . 5. Short grass invites weed growth and yellows quickly in ... towards the center of cutting. Stop tractor if anyone enters the area. Do NOT attempt to mow lawns, NOT clear brush. 19 Plan your tractor: 1. Under heavier conditions it is ON (Blades ON...

Operation Manual - Page 20

... to Use After First Five Hours (S01) Every Five Hours (S02) Every 10 Hours (S03) Every 25 Hours ... as needed P P Check Blade(s)/Sharpen or Replace as Needed P P P Charge Battery P P Check Safety Interlock System P Check Tractor Blade Stop Time P Check...All Hardware is maintained. This will be displayed on the VCM. To clear service minders press the low drive speed (Turtle...

Operation Manual - Page 21

... remove debris buildup from the tractor. CLEANING THE UNDERSIDE OF THE DECK WARNING To prevent serious injury, do not attempt to mow unusually tall grass (10" (25.4cm) or higher), dry grass (e.g., pasture) or piles of grass clippings, etc., is to electric components or the electric motor. Do not use water...

Operation Manual - Page 26

... flames or other potential source of ignition (furnace, water heater or any other type of any of the deck. 4. Reinstall the deck (refer to fully charge the battery. Empty cargo boxes, grass catchers or containers. If keeping the charger connected during off-season storage is no leakage. Replace damaged or worn...

Parts and Warranty - Page 1

... 19A30055100 19A70062100 19A70060OEM 19B40026100 42" & 46" Twin Bagger, ZT1 42" Mulch Kit Fender Kit Stamped Deck Striping Kit Cub Cadet Hauler Cub Cadet LLC, P.O. If you can seek help from the options ...-0019 Form No. 769-25981A (January 21, 2021) Parts/Warranty Supplement Models ZT1-42e Warranty This document contains information for all listed models. Front Assembly Rear Wheel Assembly...

Parts and Warranty - Page 2

... Commercial Use Warranty: Tillers, String Trimmers, Lawn Edgers, Pressure Washers, Battery Powered Product, Walk Behind Mowers, 60 Volt Max Product Series, CC30 Riders, Enduro Series, RZT S/SX, Ultima ZT Series, and Z-Force. Please refer to an additional two (2) years (a total of five (5) years from an authorized Cub Cadet dealer, distributor, and/or retailer of...

Parts and Warranty - Page 3

...a period of three (3) months. 10. Log splitter pumps, valves, and cylinders are covered for the Product. Use of other rights, which vary from the authorized Cub Cadet service provider. 3. This limited warranty...) are covered for manufacturing defects. This limited product warranty is provided by Cub Cadet LLC and is indeterminable, then the Warranty Period shall be free from the...