Craftsman 79194 Support Question
Find answers below for this question about Craftsman 79194 - 29cc 4 Cycle Gas Trimmer.Need a Craftsman 79194 manual? We have 1 online manual for this item!
Question posted by jmarshll777 on April 28th, 2013
My Trimmer Will Start And Run For A Couple Of Seconds And Die.
i have cleaned the spark shield, replaced the gas, replaced the spark plug. continues to happen. runs for a couple of seconds and dies.
Current Answers
Answer #1: Posted by jomama2345 on May 14th, 2014 9:37 AM
The issue is valve timing. This happened to me. The gap in the rocker arms (exhaust/intake) is out of tolerence. Easy to set. You just need a 0.005 feeler gauge and a small wrench. Take the valve cover off so you can see the valve rocker arms. Remove the sparkplug and set the piston to top dead center (i.e. no pressure on rocker spring arms. They should be loose and even rattle a little. Place 0.005 (5 mil) feeler gauge under the rocker arm and rod. If its too tight (won't fit) or too loose (more than 5 mils, loosen the set nut on top of rocker arm and tighten until the 5 mil feeler gauge just fits. Reassemble and it should fire right up.
Related Craftsman 79194 Manual Pages
Similar Questions
Repair Of Rope Pull On Craftsman 316.791940 29cc 4 Cycle Gas Trimmer
Rope pull pulls but don't "catch" to rotate shaft. It retracts fine.
Rope pull pulls but don't "catch" to rotate shaft. It retracts fine.
(Posted by belldon10 7 years ago)
Which Spark Plug For Older Sears 4 Cycle Trimmer
(Posted by shpopo 9 years ago)
Craftsman 4 Cycle Gas Trimmer, Where Does The Oil Go
(Posted by ninedor 9 years ago)
How To Replace String On Craftsman 29cc 4 Cycle Gas Trimmer
(Posted by johlvbec 10 years ago)
29cc 4 Cy Gas Trimmer
(Posted by royerton 10 years ago)