Craftsman 28908 Support Question
Craftsman 28908 Support Question
Find answers below for this question about Craftsman 28908 - Lt 2000 19.5 HP/42" Lawn Tractor.Need a Craftsman 28908 manual? We have 1 online manual for this item!
Question posted by christophercmpn on May 1st, 2011
When I Turn The Key The Brand New Solenoid Just Clicks With New Batterry
The person who posted this question about this Craftsman product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Craftsman 28908 Manual Pages
Operation Manual - Page 3
... turning. • Never leave a running machine unat- Always look down before operating.
Do not allow responsible adults, who are familiar with
specifications of the manufacturer of riding mower-...tractor.
_WARNING:
Tow only the attachments
that operators, age 60 years and above, are recommended by and comply with the instructions, to a complete stop engine, and remove keys...
Operation Manual - Page 4
... when approaching blind corners, shrubs, trees, or other than the operator.
• Be alert and turn machine off .
Uneven terrain could sud- they can occur if the operator is over by putting your... gradual. iV. Allow engine to neutral and coast downhill.
• Avoid starting, stopping, or turning on the ground away from your foot on the ground.
• Do not mow near drop...
Operation Manual - Page 5
...; Never carry children, even with manufacturer's recommended parts,
when necessary.
• Mower blades are sharp. Clean oil or fuel
spillage and remove any adjustments or repairs
...a foreign object, stop or shift while on the slope.
• Avoid starting, stopping, or turning on clothing, change clothing immediately.
• Never overfill fueltank. Adjust
and service as required.
&#...
Operation Manual - Page 6
... access to help by our 12,000 profesional
repair specialists.
• Unlimited service and no charge for parts
and labor on your tractor. • Follow the instructions under "Mainte-
Your new Craftsman® product is required by the operator. Here's what's included in the Agreement:
• Expert service by phone - also, 10...
Operation Manual - Page 7
... be tightened securely. Cut along dashed lines on label (label located between terminals) charge battery for charging instructions).
Keys
(2) Keys
(1) Oil Drain Tube For Future Use
Slope Sheet
Your new tractor has been assembled unassembled for any additional loose parts or cartons and remove. Use the correct tools as
TOOLS REQUIRED FOR ASSEMBLY
A socket...
Operation Manual - Page 10
...- Used to the applicable safety standards of mower or other attach- Used for
declutching and braking the tractor and
starting the engine.
(C) PARKING BRAKE- YOUR of
Our tractors conform to raise and lower the mower or other powered attachment while in reverse.
(H) LIGHT SWITCH - Used for future reference.
Turns the headlights on and off .
10...
Operation Manual - Page 11
... speed
(fast) reduces engine's operating efficiency. • Full speed (fast) offers the best mower
performance.
pletely, as described above, and set parking brake before stopping, maycause engineto"backfire". • Turn ignition key (F) to neutral position. GROUND DRIVE-
• To stop tractor com- We recommend standard safety glasses or a wide vision safety mask worn over...
Operation Manual - Page 12
...gauge wheels should be assembled so they are measured from the ground to the blade tip with tractor on
hills.
• If stopping is depressed. • To restart movement, slowly release ... ADJUST MOWER CUTTING HEIGHT
The position of grass being mowed. • The average lawn should be cutto approxi- lever to help prevent scalping in operating position. Repeat for all turns slowly....
Operation Manual - Page 13
..., cord, etc.). Slowly move motion control lever to
reverse (R) position to tractor.
TRANSMISSION ENGAGED
TO OPERATE MOWER
Your tractor is equipped with a Reverse Operation System (ROS).
ment lift lever.
2. TOWING CARTS AND ATTACHMENTS
Tow only the attachments that are certain no longer needed,
turn ignition key
counterclockwise
to leave the seat with the engine running...
Operation Manual - Page 14
...a few minutes and try again. NOTE: Before starting, read oil level. Insert key into ignition and turn key
clockwise to start , move
throttle control to separation and formation of leaded gasoline will... below ) 7. Sit on seat in neutral
position.
4. Do not mix oil with tractor on dipstick is in storage.
TO START ENGINE
When starting (See the oil viscosity chart...
Operation Manual - Page 15
... mower ... and give the mower cutting performance as well...Be sure the tractor is wet. This...when the
mower housing is...mower and leave undesirable clumps. rf
j
(
,
.)
• If grass is attached to tractor. • Mower...tractor.
AUTOMATICTRANSMISSIONWARM UP
Before driving the unit in cold weather, the transmission should be properly leveled for best engine performance (see "TOAD JUST...
Operation Manual - Page 16
...often when mowing in dirty or dusty conditions. A new
spark plug and clean air filter ensure proper air-fuel mixture and help your tractor. Check for proper operation. 5. Change 2 - ...clean or replace air filter, and check blades and belts for Loose Fasteners
_
C ChecWReplace Mower Blades
T Lubrication Chart
0 Check Battery. MAINTENANCE SCHEDULE
BEFORE
EACH
USE
EVERY
8
HOURS
EVERY...
Operation Manual - Page 17
... tractor requires more than five (5) feet to stop at highest speed in the seat.
gaged position.
Install new ...turning counterclockwise.
3. NOTE: Protect your warranty. IMPORTANT: treated.
Install and tighten blade bolt securely (45-55 Ft. Raise mower to highest position to allow access to slip from your local parts dealer.
If your tractor. BLADE CARE
For best results mower...
Operation Manual - Page 19
... to clean cartridge. Spark plug
type and gap setting are properly positioned. 4. Place new pre-cleaner and cartridge
firmly in "PRODUCT
SPECIFICATIONS"
section of operation or every season,... tabs on handle to close.
Carefully remove air filter cartridge and pre-cleaner from tractor and mower.
19 of all foreign matter.
• Keep finished surfaces and wheels free of
operation,...
Operation Manual - Page 20
... and washers.
,_ CAUTION: After rear lift links are pointing forward before sliding mower under right side of tractor. Slide mower out from tractor and hook the clutch spring (Q) into the cable guide on front edge of bracket.
5.
Slide mower under tractor.
03042tex
20 Turn ignition key to either side of the lever.
%
8.
IMPORTANT: If an attachment other than...
Operation Manual - Page 23
...of left footrest. Remove belt from mower. Remove belt downward from tractor rear to be replaced without tools. ...MOWER" in highest gear on bottom side of tractor and roll
belt onto engine pulley (E). 3. Pull belt slack toward rear of manual). TO CHECK BRAKE
BELT REMOVAL-
1.
If the rear wheels rotate, then the brake needs to front,
over cooling fan blades (D). 4. Install new...
Operation Manual - Page 25
...When replacing hood, be connected first to run poorly, stop running, or prevent it from tractor. 3. Remove bulb holder from accidental grounding. 1. Replace bulb in holder and install bulb...nut. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Install new batterywithterminals in fuel, temperature, altitude or load. First connect RED battery cable to ...
Operation Manual - Page 26
... tractor ...tractor to rust. Allow the engine to cool before painting. Clean entire tractor...
Never cover tractor while
engine and...possible, store your tractor indoors and
cover ...; Cover your tractor with
gasoline in...or damp surfaces. Turn ignition key to start position ... prepare your tractor for storage...tractor for storage, do not store battery directly on stabilizer container. TRACTOR
When tractor...
Operation Manual - Page 27
....
4 Replace fuse.
5 Clean battery terminals. 6 Check all wiring.
4 Check/replace solenoid or starter.
27 TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center...
PROBLEM
CAUSE
CORRECTION
Will not start
Hard to start
Engine will not turn over
Engine clicks but will not start
1 Out of fuel. 2 Engine not "CHOKED" properly.
3...
Operation Manual - Page 29
....
before stopping engine.
1 Reverse operation system (ROS) 1 Turn ignition key to ROS "ON"
is shifted into reverse
1 Engine speed too slow. 2 Travel speed too fast. 3 Wet grass. 4 Mower deck not level.
1 Place throttle in "FAST" position. ...Loss of drive
Engine "backfires" when turning engine "OFF" Engine dies when tractor is not "ON" while mower or other product manuals online.
Similar Questions
Can't Lower Blade
i have a model LT 2000 craftsman riding mower, I can't figure out how to lower the blade. It's a use...
i have a model LT 2000 craftsman riding mower, I can't figure out how to lower the blade. It's a use...
(Posted by Zfawnn1 7 years ago)
I Need The Help With My Craftman Lawnmower Model# 376741 I Can't Get It Started.
The lawn mower has fuel but when I pull the cord to start it the motor won't start. Am I supposed to...
The lawn mower has fuel but when I pull the cord to start it the motor won't start. Am I supposed to...
(Posted by lawn 11 years ago)
Headlights Will Not Come On On Sears Yt 3000. Brand New
(Posted by norridj 11 years ago)
Wiring Diagram For A New Pyt9000, 42' Model 28980 Mower
ON MARCH 13 I WILL PURCHASE A NEW PYT9000, 42" MOWER. MODEL 28980. IN DETERMING MORE ABOUT THIS ...
ON MARCH 13 I WILL PURCHASE A NEW PYT9000, 42" MOWER. MODEL 28980. IN DETERMING MORE ABOUT THIS ...
(Posted by dlangley 13 years ago)
I Thought I Could Make A Tight Enough Left Turn On My 42' 19.5 Craftsmen Tractor
(Posted by scuba485 13 years ago)