How To Reset Cable Box After Power Outage

The person who posted this question about Comcast did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Comcast Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Connect Your HomePoint Equipment
... wall Disconnect the coaxial cable from the back of your existing cable device (DVR, television, cable box or cable modem) Connect the coaxial cable to the splitter from the cable wall jack as shown below Connect one of your existing cable devices (either TV, cable box, DTA or DVR) Connect free end of an emergency during a power outage. This should always...
Why does the remote not respond immediately when I press a key?
Why does the remote not respond immediately when I press a key? Occasionally, when the cable box is receiving new guide data or menu updates there is a delay between the time a remote key is processing a lot of information at the same time. This happens because the box is pressed and the time the Guide responds.
How to Use the All On Button on Your Remote Control
To use the button, you must first program your remote control for your cable box (either it will be in the same state as described above to use the button ...press and hold the button until both your TV and cable box turn on (or off) If the cable box and TV become out of your remote Press the Power button Your TV will only turn the cable box on/off. Once the remote is programmed, ...