Program Scanner

cobra scanner typically

involves the following steps:

Turn on the scanner by pressing

the power button.

2. Press the "Program" button to

enter programming mode.

3. Use the number keys to enter thefrequency you want to program.

For example, if you want to

program 155475 MHz, press "T,

"5","5","", "4, "7", "5".

4. Press the "Enter" or "E' key to store

the frequency.

5. Repeat steps 3 and 4 for each

frequency you want to program.

6Press the "Program" button again

to exit programming mode.

7. Use the arrow keys to navigate

through the programmed

frequencies.8. Press the "Scan" button to begin

scanning.

Note: Please refer to the

user manual for detailed

instructions on

programming your specific

model of SR 925 cobra

Scanner, as programmingscanner, as programming

procedures may vary

slightly between models.

1. Determine the frequency range: Find out the frequency range for the channels you want to program. This information can be found in a frequency directory or online.
2. Enter programming mode: Press the "Pgm" button on the scanner to enter programming mode. The scanner's display should show "Pgm".
3. Select a channel: Use the up or down arrow keys to select the channel you want to program.
4. Enter the frequency: Use the number keys to enter the frequency for the selected channel. Be sure to include the decimal point, if needed.
5. Save the channel: Press the "Enter" button to save the programmed frequency for the selected channel.
6. Repeat for additional channels: Repeat steps 3-5 for each additional channel you want to program.
7. Exit programming mode: Press the "Pgm" button again to exit programming mode.

These steps are general, and the specific instructions may vary depending on the model of your Cobra scanner. You can refer to the user manual for your specific model for detailed programming instructions and additional features.

1. Turn on the scanner.
2. Press the "Prog" button to enter programming mode.
3. Use the arrow keys to select the channel you want to program.
4. Press "Prog" again to confirm the selection.
5. Use the arrow keys to select the frequency you want to program.
6. Press "Prog" again to confirm the selection.
7. Use the arrow keys to set any other options, such as CTCSS/DCS codes or scanning modes.
8. Press "Prog" again to store the settings.

Repeat these steps for each channel you want to program. Once you have programmed all of your desired channels, press "Scan" to start scanning through them.