2010 Chrysler Town & Country Support Question
2010 Chrysler Town & Country Support Question
Find answers below for this question about 2010 Chrysler Town & Country.Need a 2010 Chrysler Town & Country manual? We have 2 online manuals for this item!
Question posted by hreniger on April 24th, 2013
Check Engine Light - Remote Start
My check engine light came on last night, and this morning when I used the remote start it started and ran until I put my key fob in - engine stalled. Tech said that was small evap leak and they reset the code, but remote start - ignition issue is still happening. Too coincidental . . . and I can't run diagnostic forever at $90 / hr . . . any suggestions????
Current Answers
Related Manual Pages
Owner Manual - Page 15
The system uses Key Fob with factory-mated Remote Keyless Entry (RKE) transmitter and Wireless Ignition Node (WIN) to the
WARNING! NOTE: The Key-In-Ignition reminder only sounds when the Key Fob is placed in the ignition and the ignition switch position is LOCK or ACC, a chime will sound to remind you to remove the key. The system does not need to...
Owner Manual - Page 16
...- cannot be reprogrammed to start the engine. In All of the Key Fobs provided with the electronics. Once a Key Fob is used to the vehicle electronics. Should this occur, have addition, if the light begins to flash after the bulb check, it indicates that someone used an invalid Key Fob to any other vehicle. vehicle. After turning the ignition switch to the ON...
Owner Manual - Page 20
... is in the interior lights ON position (extreme top position).
2 The RKE transmitter does not need to be EQUIPPED equipped from distances up to approximately 66 ft (20 m) using a hand-held Key Fob with RKE transmitter. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
19
NOTE: Inserting the Key Fob with RKE transmitter into the ignition switch disables all...
Owner Manual - Page 24
... pushed while the liftgate is on, the headlights and park lights will flash, the horn will cause the alarm to the .... Press the within five seconds to be its previous setting. Using the Panic Alarm To turn the Panic Alarm feature on or off... by pressing the PANIC button a second ignition switch in the LOCK position and the Key Fob time, or you are in the vehicle...STARTING YOUR VEHICLE
23
2.
Owner Manual - Page 29
... and disarm the Vehicle Security Alarm (if in the Remote Start mode for a 15-minute cycle.
• The engine can be turned to the ON position before you can enter the vehicle, insert the Key Fob NOTE: • If your power door locks were unlocked, Remote Start into the ignition switch and move it to unlock eration (if...
Owner Manual - Page 30
... engine warning lights come on Once inserted, the message "Turn to ON" will flash in the Remote Start Mode, the system will also cancel if any of two times. occur: When to Reset Remote Start • The engine stalls or engine speed exceeds 2500 rpm The vehicle can be in the ON position in the EVIC until you insert the Key Fob...
Owner Manual - Page 31
..., or if the PANIC button was initiated but the engine stopped cranking without starting. Manual Door Lock DOOR LOCKS Manual Door Locks Lock the front doors by inserting a valid Key Fob into the ignition switch and rotating the Key Fob to the ON position, and then rotating the Key Fob back to the LOCK/OFF position. After either front...
Owner Manual - Page 35
... the ON position (do not start the The Unlock Doors Automatically On Exit feature unlocks engine). Place the Key Fob into the PARK position, after the vehicle has been driven (the in the programming procedure.) EVIC (if equipped), Personal Settings (Customer3. all doors 6. Within 15-seconds, cycle the ignition Key Fob from the Unlock Doors Automatically On...
Owner Manual - Page 36
...be changed .
2
7. If neces1. sary, repeat the previous procedure. 2. engine). THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
35
• On vehicles equipped with the optional Electronic Vehicle Information...position (do not start the features in accordance with the optional EVIC perform the following steps: 8. Within 15-seconds, cycle the ignition Key Fob from the NOTE: Use the Lock Doors...
Owner Manual - Page 46
...Sliding Side Door Master Lock Switch To provide a safer environment for small children riding in the rear seats, the second row sliding door ...Side Door Open Flash can turn the feature back on the 1. in the ignition switch. Left Door 2 - Right Door 4 - Place the Key Fob in the ON position (do not start the engine). 3. trim panel just in the front overhead console.
2
Overhead Console ...
Owner Manual - Page 80
... the engine. the battery has power or until the ignition key is wrong with chemicals. The particles are not caused by -product of the following may occur:
2
•
• The nylon airbag material may see your doctor Unlock the doors automatically. process that generates the non-toxic gas used for THINGS TO KNOW BEFORE STARTING...
Owner Manual - Page 106
Also, if gasoline fumes are detected or if fuel, power steering fluid, or brake fluid leaks are suspected, the cause should be located and corrected immediately.
2 Fluid Leaks Check area under vehicle after overnight parking for positive closing, latching, and locking. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
105
Door Latches Check for fuel, engine coolant, oil, or other fluid leaks.
Owner Manual - Page 234
... (ETC) Light 4. Cycle the ignition key when the
vehicle has completely stopped and the shift lever is in the PARK position, the light should come on when the light will come on during starting, have driving, turn on, and remain on while check. Charging System Light This light informs you may require towing. 3. Low Fuel Light flashing when the engine is 2.
Owner Manual - Page 328
..., or move the vehicle.
5
NOTE: This vehicle is running. 3. Use the Fob with Integrated Key to briefly turn the ignition switch to the OFF position, wait 10 to run, and it as soon as the starter engages. The starter motor will disengage automatically when the engine is equipped with a transmission Automatic Transmission shift interlocking system...
Owner Manual - Page 329
... your vehicle to push or tow your authorized dealer) is flooded. To ensure reliable starting at these temperatures, use of start after you have followed the "Normal Starting" procedure, it may be started . This type of an externally powered electric engine block heater (available from a booster battery or the battery in another vehicle. This should clear...
Owner Manual - Page 330
... at one time. that is located on the accelerator pedal and the key fob once the engine is released. To prevent damage to the floor. IF EQUIPPED The engine block heater warms the engine, and permits If the engine has been flooded, it may start to the 110-115 volt electrical cord could cause electrocution. second intervals...
User Guide - Page 3
......FUSES ...TIRE PRESSURES ...WHEEL AND WHEEL TRIM CARE EXTERIOR BULBS ... ONLY ...INSTRUMENT CLUSTER WARNING LIGHTS ...IF YOUR ENGINE OVERHEATS . . TOUCH-SCREEN RADIOS ...STEERING WHEEL AUDIO CONTROLS ...VIDEO ENTERTAINMENT SYSTEM (VES)™......4 INSTRUMENT CLUSTER ...6
GETTING STARTED
KEY FOB ...THEFT ALARM ...SEAT BELT ...CHILD RESTRAINTS ...FRONT SEATS ...HEATED SEATS ...TILT STEERING COLUMN . ...
User Guide - Page 10
... cause serious injury or death when inhaled. • Keep Key Fob transmitters away from children.
WARNING! Remote Start
• Press the REMOTE START button 2 twice within five seconds to unlock all the doors and the liftgate. Carbon Monoxide is odorless and colorless. Leaving unattended children in the ignition and turn to unlock on the first press of...
User Guide - Page 32
... Monitoring (BSM) system warning light, located in the unlocked position. • To engage the Child Protection Door Lock, open the power sliding doors. POWER SLIDING SIDE DOORS
Automatic/Manual Operation
• The power sliding door may be opened or closed manually or by using the buttons on the Key Fob, overhead console switch, or...
User Guide - Page 58
...towing.
- If the light is flashing when the engine is running, immediate service is not on during starting, stays on, or turns on while the engine is time for more...(do not increase engine idle speed.
56 Resetting The Light After Servicing
• Turn the ignition switch to appear for your vehicle may experience reduced performance, an elevated/rough idle or engine stall and your next...
Similar Questions
What Do I Do?
I have a 2010 Chrysler Town & Country Van (Touring). There is a recall on the key fobs or ignition m...
I have a 2010 Chrysler Town & Country Van (Touring). There is a recall on the key fobs or ignition m...
(Posted by queencitytaxi 7 years ago)
Mil Light
My malfunction indicator light had turned on while i was driving a and stayed on 3 days, then turned...
My malfunction indicator light had turned on while i was driving a and stayed on 3 days, then turned...
(Posted by deefisch5 10 years ago)
Low Engine Temperature 4 L 2010 Chrysler Town And Country
when driving my 2010 Chrysler Town And Country Minivan 4.0 l engine the temperature gauge goes down ...
when driving my 2010 Chrysler Town And Country Minivan 4.0 l engine the temperature gauge goes down ...
(Posted by allangreimer 11 years ago)
The Battery Lite Came On All Of A Sudden A Bunch Of Lights Came On And The Van S
Started chugging and quit its a 2011 town and country
Started chugging and quit its a 2011 town and country
(Posted by Markbenoy 11 years ago)
Check Engine Light Came On, What's The Possible Cause?
(Posted by Anonymous-84628 11 years ago)