2008 Chrysler Sebring Support Question
Find answers below for this question about 2008 Chrysler Sebring.Need a 2008 Chrysler Sebring manual? We have 2 online manuals for this item!
Question posted by gloriakeeton on June 25th, 2021
How Do I Replace Rear Window Myself
Current Answers
Answer #1: Posted by Technoprince123 on June 25th, 2021 6:11 PM
Please response if this answer is acceptable and solw your problem thanks
Answer #2: Posted by SonuKumar on June 25th, 2021 10:16 PM
https://www.youtube.com/watch?v=4uifRmn6Sqg
https://www.justanswer.com/chrysler/2pkfa-procedure-replace-rear-window-2008-chrysler.html
1. Activate power top and raise so backlite glass is vertical.
2. Remove the 12 pushpins across the top of the backlite glass above the headliner.
3. Remove the upper elastic straps (1) on both sides.
4. Remove the lower elastic straps (2) on both sides.
5. Release plastic retainer inside vehicle at top and both sides of glass.
6. Remove rubber extrusion from flange at bottom of glass, inside vehicle.
7. Remove the headliner retainer from the rear bow (1) to allow it to fold toward the front of the vehicle.
8. Pull headliner toward front of vehicle and clip to front edge of top.
9. Remove heated rear glass electrical connectors from glass.
10. Remove the 18 retaining bolts inside vehicle for backlite.
11. Protect top of windshield header with fender cover or equivalent and lower top.
12. Mask fabric around perimeter of window opening on the outside with masking tape and paper.
13. With the help of 2 assistants, remove glass.
14. With one person in vehicle pushing out working back and forth from top corner to top corner, and two people outside, (one on each side), pulling carefully out on window assembly releasing butyl sealer from top.
15. While the window frame is being removed, butyl sealer will stretch. Carefully cut butyl sealer as close to fabric top as possible, (to avoid excess from remaining with fabric top).
16. Place backlite face down on protected surface.
17. Remove plastic clip (1) and pushpins (2) from both sides of opening.
18. Remove 2 rearmost nuts retaining fabric on left and right of glass, lift fabric off studs.
19. Remove T-patch from the vehicle roof glass mount panel and butyl from the 2 rear studs.
20. Remove all remaining butyl from fabric and mounting panel.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Manual Pages
Similar Questions
How do I remove the old bearing from the wheel assembly?
How much (estimated) will it cost to replace a broken motorized window? When I engaged the electroni...
How do I replace the rear turning light signal for a 2008 Sebring