2008 Chrysler 300 Support Question
2008 Chrysler 300 Support Question
Find answers below for this question about 2008 Chrysler 300.Need a 2008 Chrysler 300 manual? We have 2 online manuals for this item!
Question posted by kimlight0128 on November 21st, 2014
Fob Key Battery
If the battery in fob key is low, will the car go into theft mode where it wont start?
Current Answers
Related Manual Pages
Owner Manual - Page 9
... YOUR VEHICLE
CONTENTS
Ⅵ A Word About Your Keys ...12 ▫ Wireless Ignition Node (WIN) ...12 ▫ FOB With Integrated Key ...12 ▫ Tip Start Feature ...14 ▫ Ignition Key Removal ...14 ▫ Key-In-Ignition Reminder ...15 Ⅵ Sentry Key ...15 ▫ Replacement Keys ...16 ▫ Customer Key (FOB) Programming ...17 ▫ General Information ...18 Ⅵ Security...
Owner Manual - Page 12
... a spring-loaded momentary contact position. 12 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
A WORD ABOUT YOUR KEYS Your vehicle uses a keyless ignition system. When released from the START position, the switch automatically returns to an ignition switch. This system consists of the Fob. It has four operating positions, three of which stores in the...
Owner Manual - Page 13
... the mechanical latch at the top of the Fob sideways with your thumb and then pull the key out of the Fob with your other hand.
2
Valet Key Removal
NOTE: You can keep the valet key with either side up. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 13
The valet key allows for locking the glove box.
Owner Manual - Page 14
...Power Off to the LOCK position. WARNING! Don't leave the key in "P" (Park). Turn the key to the START position and release it will cancel this feature is running. ...Opening either front door will remain active for a number of this feature. Never leave children alone in Section 4 of reasons. Use the Fob...
Owner Manual - Page 15
... operation by disabling the engine. The system uses the factory-mated Fob with the electronics. Therefore, only Fobs that there is in the LOCK or ACC position. An unlocked car is locked or unlocked. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15
CAUTION! Key-In-Ignition Reminder If you to thieves.
In addition, if the...
Owner Manual - Page 16
... the engine being shut off after the bulb check, it cannot be used an invalid Fob to start and operate the vehicle. Should this system. Replacement Keys NOTE: Only Fobs that someone used to start the vehicle. Always remove Sentry Keys from the vehicle and lock all doors when leaving the vehicle unattended. Keep the PIN...
Owner Manual - Page 17
... chime will sound and the Vehicle Security Alarm Indicator Light will stop flashing, turn on again for dealer replacement of programming a blank Fob to 8 keys. Repeat this procedure. Insert the second valid key and turn off. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17
location. Turn the ignition switch OFF and remove the second...
Owner Manual - Page 20
... this occurs, disarm the system. however, the buttons on that transmitter; 20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
If the alarm system is armed and the battery becomes disconnected the system will remain armed when the battery is in the "defeat" position (extreme downward position), unless the overhead map/reading lights are...
Owner Manual - Page 21
... transmitter buttons for details.
2
Keyless Entry Transmitter THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 21
continue to "Remote Key Unlock," under "Personal Settings (Customer Programmable Features)," under "Electronic Vehicle ... UNLOCK button on .
Remote Key Unlock, Driver Door/All Doors First This feature lets you program the system to unlock all Fobs. To unlock the doors: Press...
Owner Manual - Page 25
...you turn the ignition switch to SENTRY KEY "Customer Key (Fob) Programming." (See page 17 for more information.) If you turn on. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 25
Using The Panic ...by either pressing the PANIC button a second time or drive the vehicle at least one CR2032 battery. NOTE: • Perchlorate Material - See www.dtsc.ca.gov/hazardouswaste/perchlorate
2 Programming ...
Owner Manual - Page 26
.... General Information This device complies with part 15 of the FCC rules and RSS 210 of the Fob. Avoid touching the new batteries with rubbing alcohol. 3. Battery access is subject to operate the equipment. Operation is through a door located on the back housing or the printed circuit board. 1. Insert a small, flat blade ...
Owner Manual - Page 27
...; Hazard switch off. • Brake switch inactive (brake pedal not pressed). • Ignition key removed from a normal distance, check for these two conditions. 1. The expected life of the battery is a minimum of 328 ft. (100 m).
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27
If your Remote Keyless Entry (RKE) transmitter fails to operate...
Owner Manual - Page 63
...to fresh air. NOTE: The interior lights can 't protect you .
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 63
process that causes airbag deployment, with cool water. If you are involved ... collision. Have the airbags replaced by an authorized dealer as soon as the battery has power or until the ignition key is driven.
2
WARNING! These airborne particles may irritate the skin, eyes,...
Owner Manual - Page 405
... other cable, first to the negative terminal of the booster battery and then to the following illustration for jump-starting connections. 6. Refer to the engine ground (-) of the vehicle with the discharged battery. WHAT TO DO IN EMERGENCIES 405
NOTE: The battery is provided by a battery in another .
3.
WARNING! Wear eye protection and remove any...
Owner Manual - Page 519
... (BeltAlert) Automatic Locking Mode - If EquippedOutside MirrorsExterior ...TO KNOW BEFORE STARTING YOUR VEHICLE A WORD ABOUT YOUR KEYS Wireless Ignition Node (WIN)Fob with Memory ... Additional TransmittersTransmitter Battery ServiceGeneral Information REMOTE STARTING SYSTEM - ... Distribution Center)VEHICLE STORAGE REPLACEMENT BULBS BULB REPLACEMENT Low Beam Headlight, High Beam Headlight, Park/Turn ...
Owner Manual SRT8 - Page 15
... key with Integrated Key operates the ignition switch. The valet key allows for locking the glove box. To remove the valet key from the Fob, slide the mechanical latch at the top of the Fob sideways with your thumb and then pull the key out of the Fob. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
13
Fob with Integrated Key The Fob...
Owner Manual SRT8 - Page 16
...car is running. The starter motor will disengage automatically when the engine is an invitation to run, and it as soon as the starter engages.
CAUTION!
Use the Fob with Integrated Key... to the START position and release it will continue to thieves. Turn the key to the LOCK position.
A child could be seriously or fatally injured.
Don't leave the key in a vehicle...
Owner Manual SRT8 - Page 22
...occurs, disarm the system.
20
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
If the alarm system is armed and the battery becomes disconnected the system will operate if the dimmer ... will remain armed when the battery is turned ON from distances up to activate the system. NOTE: Inserting the Fob with Integrated Key into the ignition switch disables all fobs. REMOTE KEYLESS ENTRY (RKE)...
Owner Manual SRT8 - Page 25
....
2 Programming Additional Transmitters Refer to Sentry Key, "Customer Sentry Key (Fob) Programming." (See page 17 for details. See www.dtsc.ca.gov/hazardouswaste/perchlorate • Do not touch the battery terminals that are on the rear of the fob. Transmitter Battery Service The recommended replacement battery is one CR2032 battery. special handling may need to be...
Owner Manual SRT8 - Page 380
... the LOCK position on the engine ground. Refer to the positive terminal of the booster battery and then to the remote jump-start positive battery post (+) in PARK, and turn the ignition switch to the following illustration for jump-starting connections. 6. Make sure you have a good contact on both vehicles. 4.
378
WHAT TO DO...
Similar Questions
My Car Doesn't Start But The Battery Seems Okay Might Be A Fuse Problem Maybe?
my car doesn't start and it seems like the battery is still good but it won't turn on do you think i...
my car doesn't start and it seems like the battery is still good but it won't turn on do you think i...
(Posted by Jazlynaudrigarcia 7 years ago)
2008 Chrysler 300 Wont Start After Replacing Battery
(Posted by peolTO 10 years ago)
How Can You Tell When Your Fob Key To Your 2008 Chrysler 300 Is Damaged
(Posted by pygtbela 10 years ago)
Hesitation When Trying To Start.
What would cause the car to hesitate when trying to start. After turning key. I can hear relays unde...
What would cause the car to hesitate when trying to start. After turning key. I can hear relays unde...
(Posted by devilsadvo70 11 years ago)