Brother International JX2517 Support Question
Brother International JX2517 Support Question
Find answers below for this question about Brother International JX2517.Need a Brother International JX2517 manual? We have 2 online manuals for this item!
Question posted by rs100k on May 21st, 2022
Winder Tire
Brother JX2517 :Where can I find a winder tire? What is the part number for the winder tire? Is there a new replacement number for the winder tire?Thank you for any help I can get.
Current Answers
Answer #1: Posted by SonuKumar on May 21st, 2022 7:53 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://www.sewingpartsonline.com/brother-jx2517-parts.aspx
https://www.brother-usa.com/support/jx2517
https://www.sewingmachinesplus.com/brother-jx2517-parts-accessories.php
https://www.aliexpress.com/item/1005003097458470.html
https://www.sears.com/brother-17-stitch-sewing-machine-jx2517/p-SPM11843533119
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Brother International JX2517 Manual Pages
Users Manual - English and Spanish - Page 2
... the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment.
• While the machine is required when
sewing:
• Always pay close attention to the needle. Keep ventilation openings of the machine and foot control free from the build up of the electrical outlet. To reduce
the risk of...
Users Manual - English and Spanish - Page 3
....brother.com
SAVE THESE INSTRUCTIONS
This machine is required around the machine needle.
• Do not turn it to inspect and adjust the machine...all moving parts. Benzene, thinner, and scouring powders can be replaced by the manufacturer as it must be used by or near....
• Do not push or pull the fabric when sewing, and follow the troubleshooting table in the back of experience ...
Users Manual - English and Spanish - Page 4
... Restrictions on oiling 34 Precautions on plug.
• Always replace the fuse cover. KNOWING YOUR SEWING MACHINE 4
ACCESSORIES 4 Optional accessories 4
THE MAIN PARTS 5 Flat bed attachment 5
USING YOUR SEWING MACHINE 6 Connecting plugs 6 Main power and sewing light switch 7 Foot controller 7 Checking the needle 7 Replacing the needle 7 Changing the presser foot 8
THE CONTROLS...
Users Manual - English and Spanish - Page 5
... to help you purchased, the following accessory may be purchased separately.
Depending on the model you easily perform most sewing tasks.
1.
2.
3.
4.
5.
6.
7. No. Part Name
6 Narrow Hemmer Foot
7 Blind Stitch Foot
8 Quilting guide
Part Code
Americas Others
SA127
F003N: XC1945-052
SA134
F018N: XC1976-052
SA132
F016N: XC2215-052
4 1 KNOWING YOUR SEWING MACHINE...
Users Manual - English and Spanish - Page 6
...
The accessories can be stored in the foot controller plug and connect the machine to start and stop sewing. Slide the flat bed attachment to the left to manually raise and lower the needle.
KNOWING YOUR SEWING MACHINE
THE MAIN PARTS
3
2
1
4
B
5
A
C
6
0
7
8
9
1 Bobbin winder (Page 11) This winds the thread onto the bobbin for 220-240V...
Users Manual - English and Spanish - Page 7
... your authorized dealer for repairs before continuing use extension cords or multi-plug adapters with wet hands. b
a
Note
● If a power outage occurs while the sewing machine is not to be used for the power source. Connecting plugs
Connect the foot controller plug to
them. Do not modify the plug in the...
Users Manual - English and Spanish - Page 8
..., glass, etc.)
Replacing the needle
CAUTION
● Always turn off (toward the 'O' mark)
CAUTION
● Do not turn on the machine while pressing down lightly, the machine will stop.
1
... when the machine is accidentally pressed and the machine starts sewing.
● Only use sewing machine needles for smooth sewing.
1 2
1 Turn on (toward the 'I' mark) 2 Turn off the machine before you
...
Users Manual - English and Spanish - Page 9
...| Press the black
foot by turning the 2 handwheel toward the 5 back of the sewing machine may be damaged. Raise the needle by pulling it
| button at the back of the... is
in the needle plate.
● Always turn off the machine. 1 Raise the presser foot lever.
CAUTION
Changing the presser foot
● Before replacing the needle, place fabric
1
or paper under the presser foot ...
Users Manual - English and Spanish - Page 10
...presser foot or fabric may bend or break the needle and cause injury. KNOWING YOUR SEWING MACHINE
Lower the presser foot lever and fix the 5 presser foot onto the shank.
Pattern Stitch...Bar
THE CONTROLS
CAUTION
● If the presser foot is in either direction.
2
1
1 Pattern selection dial 2 Chosen pattern number
1
23 4
5
67
*1 *1 *1
8 9 10 11 12 13 14 15 16 17
*1 : Stitch nos. ...
Users Manual - English and Spanish - Page 11
...)
1
11
STRAIGHT STITCH (Left Needle Position)
2.5 (3/32) -
23, 30, 32
1 Reverse sewing lever
12 2 (1/16) 24, 33
BLIND HEM STITCH
5 (3/16)
13 1 (1/16) 25
ELASTIC STITCH
5 (3/16)
10 The length of reverse stitches is fixed at 2 mm (1/16 inch).
10 4 (3/16)
23, 32
STRAIGHT STITCH
(Center Needle
- The machine will then sew forward.
Users Manual - English and Spanish - Page 12
...1 Pull the thread in completely.
2 3
1 Pre-tension disk
2 Bobbin winder shaft
Pull up the spool pin and put a spool of thread is in ...machine will not work properly.
If you , in completely.
11
CAUTION
● If the spool of 1 thread on this pin.
3 Bobbin
While holding the thread from other bobbins may tangle on the thread guide. KNOWING YOUR SEWING MACHINE
THREADING THE MACHINE...
Users Manual - English and Spanish - Page 13
... the bobbin properly may cause the thread tension to break. Then stop the machine. Note
● When the sewing machine is started or the handwheel is not a malfunction.
● The needle bar does not move when you slide the bobbin winder shaft to the left and remove the bobbin. this is turned after winding...
Users Manual - English and Spanish - Page 14
...controller and the machine starts to be...sew, you turn off the machine while threading. Prepare the bobbin wound properly 1 before starting sewing. KNOWING YOUR SEWING MACHINE
Lower threading
Install the bobbin wound with your finger, and then
pass the thread through
the tension-adjusting spring of the bobbin case, it may cause incorrect thread tension.
1
1 Tension-adjusting spring
Replace...
Users Manual - English and Spanish - Page 16
...
CAUTION
● When threading the upper thread, carefully follow the instructions. CAUTION
● If the spool of thread is in the correct combination. KNOWING YOUR SEWING MACHINE
Upper threading
2
2
3 4
1 5
1 Spool pin 2 Thread guide (back) 3 Thread guide (front)
4 Thread take-up .
• If the needle is not correct, the thread may become tangled...
Users Manual - English and Spanish - Page 18
... or darts, you can begin sewing immediately without cutting it there
without drawing up...SEWING MACHINE
Drawing up the lower thread
While lightly holding the end of the upper 1 thread, slowly turn the handwheel toward the back of
the machine under the presser foot.
1 2
1 Upper thread 2 Lower thread
17
Before you (counterclockwise) by hand so that some thread will be removed. Replace...
Users Manual - English and Spanish - Page 19
.../11), may be uneven, the fabric to pucker, or the machine to skip stitches.
18 The wrong combination may cause machine malfunction. and the higher the needle number, the thicker the needle.
■ Ball point needle Use the ball point needle when sewing on stretch fabrics or fabrics where skipped stitches easily occur. Memo...
Users Manual - English and Spanish - Page 20
... placing the fabric under the presser foot,
and then pull out about 5 cm (2 inches) of the machine.
1
1 5 cm (2 inches)
19 SEWING BASICS
2 SEWING BASICS
Please read before sewing
CAUTION
● To avoid being injured, watch the needle carefully while you may be injured. ● Always use the correct presser foot.
Change the presser ...
Users Manual - English and Spanish - Page 21
... where you (counterclockwise). While holding the end of the thread and 7 the fabric with your left side of the c machine, and then pass the threads through the thread cutter to cut them.
.
1
Sewing thick fabrics
■ If the fabric does not fit under the presser foot If the fabric does not fit...
Users Manual - English and Spanish - Page 28
... the two lines on a scrap piece of fabric before replacing the presser foot. Sew the length of the stitch and then raise the needle....Stop the machine when the needle is accidentally pressed and the machine starts sewing.
Turn the pattern selection dial to "a". 2. SEWING BUTTONHOLES AND BUTTONS
4 SEWING BUTTONHOLES AND BUTTONS
CAUTION
● Always turn off the machine before you ...
Users Manual - English and Spanish - Page 37
...machine.
Correctly install the needle.
7
The needle clamp screw is scratched.
The bobbin case is loose. authorized service center.
Replace the needle.
7
The upper thread was not threaded correctly. sew. breaks.
Replace...sewing The bobbin-winder shaft is pushed to the Move the bobbin-winder... you need additional help, the Brother Solutions Center offers ...
Similar Questions
How Do I Take Apart Brother Sewing Machine Jx2517. To Reattach The Belt?
(Posted by louisianajean 8 years ago)
Where Is A Parts Guide Or Service Manual For Brother Jx2517 Sewing Machine?
the inside of my brother JX2517 sewing machine broke. Its a plastic piece,gear, at end by the needle...
the inside of my brother JX2517 sewing machine broke. Its a plastic piece,gear, at end by the needle...
(Posted by Discogypsy 9 years ago)
Tension Adjustment On The Brother Sewing Machine #jx5217?
How do you adjust the tension on the Brother Sewine Machine #JX5217?
How do you adjust the tension on the Brother Sewine Machine #JX5217?
(Posted by flokay8 10 years ago)
I Need A Parts And Schematic Manual For Sewing Machine Xl-3200 Brother
(Posted by MANUALS1 10 years ago)
Rating
Do you have any review or rating on brother jx2517 sewing machine.
Do you have any review or rating on brother jx2517 sewing machine.
(Posted by Moelimo53 10 years ago)