Bose VCS-10 Support Question

Find answers below for this question about Bose VCS-10.
Need a Bose VCS-10 manual? We have 1 online manual for this item!

Bose Overview Questions Manuals Reviews Videos Research

Question posted by acgsi2 on July 9th, 2016

No Picture On My T.v. While Using A Bose 1.2.3 Dvd System. I Have Sound.

I turned Comcast Cable T.V. Remote Control off; Television set is on but when I attempt to play a DVD in the Bose 1.2.3. System - It is on and it is switched from TV to CD-DVD - the tray is opened and a DVD inserted & closed. Sound is produced but no picture comes up on T.V.Please Help!

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on July 11th, 2016 5:45 AM

This answer was accepted by the poster of the original question.

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,813

1,100
points

See the troubleshooting here https://www.bose.com/en_us/support/article/video-troubleshooting-lsv-35.html

Hope that is helpful.
Kervz at www.satechhelp.co.za

Related Bose VCS-10 Manual Pages

Owner's guide - Page 3

...speaker 6 Position your surround speakers 7 Connect the speakers 8 Choosing speaker cord 8 Be sure to use the cord properly 8 Make the connections 9 Check the connections 10 Mounting your speakers on a wall 11 Adjusting Your Surround Sound Settings 12 For realistic home theater sound 12 How to set...or otherwise used without prior written permission. No part of each speaker. Setting Up 4 ...

Owner's guide - Page 4

... a wall. Note: Now is a center speaker. Both the VCS-10® center speaker and the VCS-30® Series II center/surround speaker system are designed to make the surround speakers simple to one center speaker, the VCS-30 Series II system includes two surround speakers. If any speaker appears damaged, do not use your authorized Bose dealer immediately. Advanced design brackets included...

Owner's guide - Page 5

The VCS-10® speaker carton contents Center speaker Rubber feet Setting Up Owner's guide B. The VCS-30® Series II system carton contents Left surround speaker Right surround speaker Mounting brackets Rubber feet Center speaker Mounting hardware Owner's guide 5 English Figure 1 A.

Owner's guide - Page 6

CAUTION: The VCS-10® speaker is not designed to be set on end in a vertical position, mounted on a wall, or to fall on the speaker. Do not allow debris or water from plants, or other apparatus (including ampliﬁers) that is in from a television surface that produce heat. CAUTION: Do not install near any heat...

Owner's guide - Page 7

... other apparatus (including ampliﬁers) that produce heat. If you use the supplied brackets, refer to the bracket instruction diagrams in a horizontal position. English Setting Up Position your surround speakers Surround speakers in the VCS-30® Series II speaker system provide surround sound effects from the rear of your room allows. • To mount the...

Owner's guide - Page 8

... check with your authorized Bose dealer. Twist the bare end of each cord, strip approximately 1⁄2 inch (12 mm) of speaker cord. English Setting Up Connect the speakers CAUTION: Before making any connections, turn off your receiver or ampliﬁer and unplug it from both wires carefully. 8 Use an RCA cable to connect the center channel...

Owner's guide - Page 9

... (+) terminal. Connect one terminal lever and insert the appropriate wire (Figure 6). A. Attach the plain wire to the black (-) terminal. • The center speaker connects to the center speaker and surround speakers Red terminal lever Marked wire Marked wire Red terminal lever 1. Some surround sound receivers have two sets of the speaker, push one end of the same...

Owner's guide - Page 10

... Figure 7 Completed connections Center speaker Receiver or amplifier Right Surround speaker OUTPUT To speakers FRONT SPEAKERS Right +- Left Left Surround speaker 10 Bridged wires can shortcircuit and damage the electrical components. Tighten any loose connections before you plug in the receiver or ampliﬁer and turn it on. Left +- English Setting Up Check the connections Make...

Owner's guide - Page 11

... The brackets were designed to bracket part A using screw C. Note: For Stereo Everywhere® speaker performance, horizontal mounting is required. 1. Secure the speaker with the hole for the mounting template and ... you plan to feed wires through the wall, mark the speaker wire pilot hole also. 2. English Setting Up Mounting your speakers on a wall CAUTION: Do not mount the brackets on ...

Owner's guide - Page 12

... (Bass Boost or Super Bass on the receiver brand and model you prefer that each speaker reproduces sound as the tone moves from both SURROUND speakers at the receiver remote. 2. Figure 9 The receiver or ampliﬁer set your Pro-Logic receiver For use in video applications, be silent at times. One tone should come from...

Owner's guide - Page 13

... speaker and surround speakers. You will hear the speaker resume normal play will continue for using the receiver test tone to an overload. Note: The overload problem described here should occur only if the receiver is overdriven and sending a distorted signal, or when the center speaker is interrupted The VCS-10 Center Speaker and VCS-30 Series II Center/Surround Speaker...

Owner's guide - Page 14

... all connections (see page 10). • If your surround sound receiver is Pro-Logic, be sure an RCA stereo cable connects the receiver to a stereo sound source (TV, VCR, laserdisc, or DSS player). • If the receiver is connected directly to a stereo television, make sure that speaker returns to normal intermittently shuts down play. Customer service To arrange...

Owner's guide - Page 15

... If necessary, use a mild detergent, like dish soap, being careful not to allow it to Bose. Clean the outside of your speakers. Details of the coverage are covered by wiping each speaker with your VCS-10® or VCS-30® Series II speakers by a limited 5-year transferable warranty. Warranty period Bose® VCS-10 and VCS-30 Series II speakers are provided...

Owner's guide - Page 18