Bosch WFVC540SUC Support Question
Bosch WFVC540SUC Support Question
Find answers below for this question about Bosch WFVC540SUC - Vision 500 Series Front Load Washer.Need a Bosch WFVC540SUC manual? We have 1 online manual for this item!
Question posted by tamarshall50 on January 8th, 2017
Error Code E:27
Error code E:27 in the manual says that there is a door lock problem. I have removed the door lock assembly and it seems to be fine. It seems as if the lock is not getting power. Power must come from the switch panel. How do you reset the machine logic to get rid of the error code and then what else do you look for to solve the problem?
Current Answers
Answer #1: Posted by techyagent on January 8th, 2017 10:30 AM
techyagent
Member since:
June 17th, 2014 Points: 4,799,810
Member since:
June 17th, 2014 Points: 4,799,810
found this super helpful link (at bottom)
If your washing machine flashes error code E27, it refers to your door being locked.
My Steps:
- Hold down the "Allergy rinse" button, "Spin Selection" button at the same time.
- Turn the Wash selection knob to the left on "Cold". Result: You should see different codes flashing on screen, this is resetting the machine's error, and is exactly what we want.
- After a few seconds turn Wash selection knob to "Off".
- Turn machine back on.
Result: Your mashine should work now, and door should be un locked :)
Disclaimer: Yes I do work in QA, and am Unemployed :(
Cheers :)
Helpful link: http://baubilt.com/?p=1318
Linkdin: https://www.linkedin.com/in/ddiaz29360;
Thanks
Techygirl
Related Bosch WFVC540SUC Manual Pages
User Manual - Page 2
... washers deliver the
most efficient and accurate water heating method for cycles that Bosch is turned on the clothes, Bosch Vision gets the most stubborn stains with the power of the load and...chance of sensors in the
Bosch Vision washer for each cycle with the Stain Removal option can be installed virtually anywhere in the heat, allowing your laundry a complete, even clean. The ...
User Manual - Page 3
...
Removing the transport bolts 11
Water connection 12
Electrical connection 14
Leveling procedure 15
Transporting the Washer 16
OPERATING INSTRUCTION 17
Panel 17
Before Using For the First Time 18
Using For the First Time 18
First washing cycle (without laundry 18
Preparing the laundry 18
Sorting the laundry 19
Degrees of soiling 19
Loading the laundry...
User Manual - Page 5
...loads causing skin irritation.
26. Do not install or store this is applied to the machine.
33. Do not touch the washer door...27. Removing any protruding components such as the appliance door or a pullout shelf.
15. Always follow the instructions of the manufacturer of the washer... result. Keep pets away from the power supply before electrical power is the case, contact an authorized ...
User Manual - Page 6
...codes and ordinances. GROUNDING INSTRUCTIONS
This appliance must be conveyed with a cord that is properly installed and grounded in this manual do not understand. Connect to whether the washer is equipped with the washer.
6
Always contact your dealer, distributor, service agent or the manufacturer about any problems...Improper connection of ownership, manual should be plugged into an...
User Manual - Page 7
...remove the washer door to the degree of soiling, amount of suffocation from locking...laundry... Code,...power cord and discard. FactoryĆsupplied Equipment
There is located in residential washing machines. Water supply hose for high efficiency and front loading washers.
- Water supply hose for the winter, any parts are intended for use by an authorized technician. User manual...
User Manual - Page 8
... of the washing machine with feet turned all the way in, against the washer door glass. Maximum height is to be installed on a solid floor and well leveled due...footprint of the washer, approximately 27" wide x 29.7" deep, or 54" wide x 29.7" deep to extend underneath both the washer and the dryer for the transport bolts (after removing the transport bolts during washer installation). 2....
User Manual - Page 9
...facilitation of the washer.
Recessed or Closet
Dimensions for ducts/brackets (see dryer installation instructions). - cm)
F Bottom 24 sq. The pedestal adds 15 inches to removing the transport bolt assemblies from overheating, ... small room, the doors of the appliances are to stack the dryer on a pedestal in undercounter installation section on top of the washer and also provides a...
User Manual - Page 10
...for stacked installations. Clearance dimensions A through D are found on page 9. Utilize care in sliding the stacked washer and dryer units into position because of its weight and size. in . (155 sq.
Closet Ventilation ...G Height
37.25 in. (94.6 cm)
H Width
27.50 in. (69.9 cm)
Width* 54.75 in. (139.1 cm)
* washer and dryer side by side recessed or closet installation are shown...
User Manual - Page 12
... accessible when the washing machine is in place and should be
between 20 and 120 p.s.i. (1.38 and 8.27 bar) when the faucet is exceeded. q Check to the back of an unpressurized hotĆwater boiler.... fully open.
12 The water supply hoses must not be sure the rubber washer/strainer is not necessary to remove the washer to the faucet) an additional two-thirds turn on and at the wall ...
User Manual - Page 17
... hour increments up to better remove stains.
ECOActionR: This option reduces the amount of 19 hours (if required).
Start/Pause Indicator light flashes red: Settings can be changed, the wash cycle can be activated. Delay Start button (500/DLX Series)
The Start time can be started, the door is locked for reasons of the selected...
User Manual - Page 18
...washer door is displayed: q Open the door. Preparing the laundry
NOTICE
Loose debris (coins, paper clips, nails and other hard objects to Page 7).
These include zippers, button up in the drum. 1. q Remove... fabrics). d WARNING
Before using your initial load of clothes, first run the washer a complete cycle, without laundry)
Your appliance was thoroughly tested before operating this...
User Manual - Page 19
...door to remove persistent, dried-on the care label. q Open the door. Mix up to one day. Full Load Cotton and Linens ½ Load Permanent Press, Synthetic Blends and Knitwear D Load Wool, Delicates, Silk
Do not exceed the maximum load...NOTICE
Items of clothing
between the door and rubber seal.
19
NOTICE
Loose debris in the drum. Before loading the laundry, check that have some light ...
User Manual - Page 20
... dispensed during the last rinse cycle. If using HE detergent could cause problems such as max" on soiling can be obtained from your front-loading washer. If using a powder detergent, first remove the liquid detergent insert from the dispenser into the wash load.
- Filling laundry detergent and/or additives
q Open the detergent dispenser drawer.
Use to...
User Manual - Page 21
...
- The bleach will be automatically dispensed at the fill level marked as max" on the laundry to corrode. It is fully closed. Use a moist paper towel to the laundry load.
- These substances may cause parts of your washer. Concentrated or thick fabric softener, conditioner and powder-bleach must be dispensed early, which could result...
User Manual - Page 22
.... Option Buttons
Stain Removal The Stain Removal option is pressed, an additional rinsing cycle will vary depending on the laundry fabric type.
It is not available for special wash needs or specific types of tough, ground-in part on cycle selected, temperature and pressure of incoming water, water hardness, size of load, type of...
User Manual - Page 24
...Acoustic Signal
An acoustic signal indicates program statuses (e.g. Stain Removal and Allergy Rinse) until a short signal is changed ... displayed time: - Adding laundry is not possible
because the door is correctly balanced for each...System Unbalanced load detection The AVSt automatic unbalanced load detection system determines whether or not the load is locked for delicate laundry. Load size ...
User Manual - Page 27
Remove the drawer from the power outlet before operating ...is allowed to any
warm cycle. This will allow air to Off.
27
First release the water pressure in place and fully closed!
q Clean ...
wait for 30 seconds. q Remove the liquid detergent insert by leaving the door partially open the detergent dispenser
drawer.
i DO NOT operate the washer
without the detergent drawer in the...
User Manual - Page 29
... before spinning. For safety reasons the door has been locked because the water level, temperature or high drum speed.
Wait until the cycle ends (see Page 27). Appliance starts automatically. Disconnect the washing machine
from the power outlet. 3. Fault
Cycle duration extended.
The laundry load may not be opened . during a power failure, call Customer Service (see page...
User Manual - Page 30
...load through repeated spins. use HE detergent. (look for future wash loads. Select suitable cycle or Stain removal as light spots on the packaging (look for future wash loads. see Page 27).
The laundry was not spun. (Laundry...fault.
Check for your High Efficiency washer produce fewer suds and will include the letters HE" on the laundry.
If the fault continues, call ...
User Manual - Page 33
...NEGLIGENCE) OR OTHERWISE. No attempt to humidity, lightning, power surges, structural failures surrounding the appliance, and acts of... CA 92649 / 800-944-2904
33 correction of installation problems (you are scratches, nicks, minor dents, and cosmetic damages...defaced, or removed; outdoors, use the Product, or visits where there is nothing wrong with local fire and building codes and regulations...
Similar Questions
E 12 Error Five Times Before Load Is Done!!! Vision 300.
e12 code over and over. Plenty of water pressure. Iron in water though. Cleaned filter area. Leveled...
e12 code over and over. Plenty of water pressure. Iron in water though. Cleaned filter area. Leveled...
(Posted by Bubbawinslow 8 years ago)
How Do I Fix Bosch Vision 500 Series Error Code E27
(Posted by RLAvwea 9 years ago)
Door Locked On Bosch Vision 500 Front Load Washer With E13 Code Displayed.
how can i open it manually to get the clothes out?
how can i open it manually to get the clothes out?
(Posted by amendieta 11 years ago)
My Bosch Front Load Washer Model #wfmc5301uc/suc/cuc
My washer fills and drains will NOT wash, rinse or spin. The timer clicks through the cycles drains ...
My washer fills and drains will NOT wash, rinse or spin. The timer clicks through the cycles drains ...
(Posted by jdl01 11 years ago)
E12 Error Code
(Posted by rgarcia43 12 years ago)