Bosch WFMC2201UC Support Question
Bosch WFMC2201UC Support Question
Find answers below for this question about Bosch WFMC2201UC - Nexxt 300 Series Washer.Need a Bosch WFMC2201UC manual? We have 4 online manuals for this item!
Question posted by eyp1967 on August 25th, 2023
How To Take The Clean Out Cover Front Front Of The Washer
how to take clean out cover on fron
Current Answers
Answer #1: Posted by SonuKumar on August 25th, 2023 10:08 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,617,810
Member since:
May 9th, 2021 Points: 16,617,810
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by Hanna0809 on August 25th, 2023 8:13 AM
Hanna0809
Member since:
July 22nd, 2023 Points: 21,130
Member since:
July 22nd, 2023 Points: 21,130
To remove the clean out cover from the front of the Bosch WFMC2201UC washer, follow these steps:
1. Unplug the washer from the power source to ensure safety.
2. Locate the clean out cover, usually located at the bottom front of the machine.
3. Depending on the model, you might need to remove a kickplate or access panel to access the clean out cover.
4. Once you've gained access to the clean out cover, carefully remove any screws or fasteners securing it in place.
5. Gently pry open or unscrew the cover, being cautious not to damage it or any components behind it.
6. After removing the clean out cover, you'll have access to the pump filter or drain trap. This is where you can clean out debris or foreign objects that might be clogging the drainage system.
Remember to consult the user manual or manufacturer's instructions for your specific model for accurate and detailed guidance. If you're unsure about any step, it's always a good idea to seek professional assistance to avoid any damage to your washer.
Related Bosch WFMC2201UC Manual Pages
Pedestal Installation Instructions - Page 3
For dryers go directly to 2" off the floor (see Figure 3).
Start with your thumb while (2) sliding the cover in the plastic cover (see Figure 5). Figure 4 q Make sure the tab on the
transportation bolt washer is removed from the wall so it can be noticed due to allow it against the floor as this manual...
Pedestal Installation Instructions - Page 4
...: It is recommended to install the pedestal.
NOTICE
If installing the pedestal to a new washer, do so can be noticed due to installing the pedestal. 2. Helpful Hint: Place the...not available, items such as the pedestal carton) or other suitable protective covering flat on its side. Note for Washers: Slight water spillage may be reinstalled later without the pedestal. Remove ...
Pedestal Installation Instructions - Page 6
...and carefully try again. Follow the Installation Instructions
that direction. Figure 15 q Insert the covers until they can make it unlevel again.) Each foot of the appliance or pedĆ... risk of the foot.
6 q Store the transport bolts with all 4 transport
bolt assemblies (bolt, washer and bushings) by turning it is level in
completely (see Figure 17, item 1) by reaching through ...
Pedestal Installation Instructions - Page 7
For Washers: Fine tune the leveling by freely opening and closing the drawer. Use the supplied 17mm open&#... weight distribution to all feet) is satisfactorily raised or lowered, lock the height-adjustable feet in the Customer Service" section of laundry in the machine, starting it does wobble, lower the foot on your pedestal contact BSH Home Appliances.
Correct
Incorrect
Figure 19 7....
Installation and Use & Care (all languages) - Page 2
... Archie paddles cascade water from high above, rinsing away suds and giving your laundry a complete, even clean.
SYNCROt Technology
Manage your washer and dryer times with our unique suds sensor, you wait for your dryer ...the wash process at every stage of your wash load. Stainless Steel Drum The Nexxt washer drum has hundreds of a button. This machine virtually operates at the touch ...
Installation and Use & Care (all languages) - Page 3
...laundry 15
Preparing the laundry 15
Sorting the laundry 15
Degrees of soiling 15
Loading the laundry 16
Laundry Detergents and Additives 16
Dispensing the correct amount of detergent 16
Filling laundry... the program 20
Canceling active program 20
After Washing 20
Cleaning and Care 21
Cleaning the washer 21
Descaling the washing machine 22
Troubleshooting of Minor Faults ...
Installation and Use & Care (all languages) - Page 4
...power cord/plug.
6. This modern washing machine cleans your washer. Excellent engineering and reliability reduces operating costs significantly. ...following :
1. The appliance may show different details than your laundry using the washing machine.
2. This indicates that could ignite or...hydrogen gas may occur as curtains and window coverings that has not been
used for several minutes ...
Installation and Use & Care (all languages) - Page 5
...
34. To reduce the risk of the detergent(s), cleaning aid(s), fabric softener(s) and static eliminator(s) which may ... by a qualified electrician. all water connections to whether the washer is properly grounded. Precautions should be taken to avoid damage ... ordinances. Store all laundry chemicals and aids in this washing machine until you do not cover all local regulations and...
Installation and Use & Care (all languages) - Page 6
...marking).
2. Water supply hose for high efficiency and front loading washers. - Accessory parts bag (see below freezing, or if it ...°C) tap water and conventional additives that are there. Covers to be placed over the holes for the winter, any...with your dealer or local authority about the best means of laundry and water hardness, and follow the detergent manufacturer's instructions....
Installation and Use & Care (all languages) - Page 7
...according to the floor.
in (155 sq. when moving).
This appliance must be stacked. Closet If installing the washer in a corner of the appliance:
- cm), Bottom: 24 sq. Closed wrench (1/2" / 13 mm). ...following: q Soft floor surfaces, such as possible
11
before first use, run a cleaning cycle 15
Removing the transport bolts
d CAUTION
To avoid possible injury and damage to ...
Installation and Use & Care (all languages) - Page 8
...on , at least 2.2 U.
q If the bushings do not come out properly. q Insert the covers until they snap in doubt, have the water connection installed by hand when connecting the water supply ...from the water supply hoses. q Completely remove all 4 transport bolt assemblies (bolt, spring, washer and bushings) by reaching through the open .
8 Water connection
Water supply
ATTENTION
The washing...
Installation and Use & Care (all languages) - Page 11
...against the washer housing. Disconnect the washing machine
from front to side and from the power outlet. - Preparing and inserting the transport bolts
q Remove the covers. Start with the end of laundry in the... wash program. q Turning the foot out (clockwise) will raise the corner of the washer, turning the foot in length) to heklp reduce vibration. Transport, such as possible to...
Installation and Use & Care (all languages) - Page 12
OPERATING INSTRUCTION
Your new washer
Filling laundry detergent and/or additives into dispensers
Open the door (colored marking) ...
...and close the door
dCAUTION The access panel located on the bottom right of the washer is for Service Access
and is only to be opened by an Authorized or Qualified Service Technician. 12
Installation and Use & Care (all languages) - Page 15
...), red clay.
First, dab soapy water onto the stain. Do not rub. q Turn on (red). Preparing the laundry
ATTENTION
Loose debris (coins, paper clips, nails and other hard objects to avoid scratching the washer interior. Tćshirts, shirts and blouses that the water valves for the washing machine have been worn for...
Installation and Use & Care (all languages) - Page 17
... Sturdy, hard wearing items made of your front-loading washer. Permanent Press Warm Items consisting of the
programs
The ...because they are dependent upon the cycle. Dispenser II: Cleaning additives, e.g. Do not fill over edge of the detergent... programs are particularly designed to provide extremely gentle
treatment of laundry in wash performance. Bulky items, e.g. These cycles have...
Installation and Use & Care (all languages) - Page 21
...program (except Spin or Drain). q Rub dry with a pressure washer. Never use flammable solvents to Off.
q Turn the program selector to clean the appliance. Never use steel wool.
q Turn on the ... debris (e.g. q Insert the strainer and reconnect the hose. Cleaning and Care
Cleaning the washer
d WARNING d
TO AVOID RISK OF ELECTRIC SHOCK!
Always disconnect the appliance from the...
Installation and Use & Care (all languages) - Page 22
... follow the instructions provided by the descaling agent manufacturer.
22 Cleaning Tips It is recommended that you can use the correct type of detergent, it is not necessary to descale the washing machine. With no laundry in the machine, run through the washer every 3 months. If white spots, lime or mineral deposits appear...
Installation and Use & Care (all languages) - Page 23
... and you High Efficientcy washer produce fewer suds and ...this program. Press the Start/Pause button. If required, select another program. Clean the water drainage pipe and/or drain hose. Turn the program selector to ...from the power outlet. underneath the machine. Leak in supply hose clogged. If the laundry is restored. Wait until the program ends; see Page 21. Select a program....
Installation and Use & Care (all languages) - Page 26
... you choose to such parts.
STATEMENT OF LIMITED PRODUCT WARRANTY
What this Warranty covers & Who it Applies to:
The limited warranty provided by BSH Home Appliances ("BOSCH") in this Statement of limited product Warranty applies only to the Bosch 300 Series washer ("Bosch") sold to you are solely responsible for any structure and setting...
Installation and Use & Care (all languages) - Page 92
Type of laundry Check care labels on water supply and quality, type and amount of load and detergent, as well as other factors.
1/3 load
WFMC2201UC 02/2007
9000224447 92
Program selection table Nexxt 300 Series
Please read and observe Operating, Care and Installation Instructions carefully before using the washing machine ! Drain pump operates prior to and...
Similar Questions
Bosch Nexxt 300 Series Washer Will Not Spin Or Agitate.
Found on the internet to how to put into dervice mode, which I tried and received a P:01 and E:20 er...
Found on the internet to how to put into dervice mode, which I tried and received a P:01 and E:20 er...
(Posted by garrisonml 9 years ago)
Bosch Nexxt 300 Series Washer Water In Drum When Sitting
(Posted by niksaidyle 9 years ago)
Where Is The Bosch Nexxt 300 Series Washer Water Drain Hose Located
(Posted by najtoum 10 years ago)
How To Remove Front Access Panel On Bosch Nexxt 300 Series Washer
(Posted by eaaug 10 years ago)
How To Take A Pump Off A Bosch Nexxt 300 Series Washing Machine
(Posted by lilpodi 10 years ago)