Amana NFW7300WW Support Question
Amana NFW7300WW Support Question
Find answers below for this question about Amana NFW7300WW.Need a Amana NFW7300WW manual? We have 4 online manuals for this item!
Question posted by donbachman1957 on August 2nd, 2015
Washer Leaking From Soap Dispencer
When starting washer water starts pouring out underneath the soap an softner dispencer drawer what might be the problem?
Current Answers
Answer #1: Posted by Odin on August 2nd, 2015 10:16 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Amana NFW7300WW Manual Pages
Use and Care - Page 2
... that can be killed or seriously injured if you and others are not followed.
2 WARNING
You can kill or hurt you don't immediately follow instructions. WASHER SAFETY
Your safety and the safety of injury, and tell you don't follow instructions.
Use and Care - Page 3
... or Service" section. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
You may require additional parts.
Your washer can cause damage in the washer and can be considered. Tools needed for connecting the water inlet hoses ■ Pliers (that open to 19/16" [39.5 mm])
■ Flashlight (optional...
Use and Care - Page 4
...area
4 Installation clearances ■ The location must be large enough to allow the washer door
to reduce noise transfer.
■ Companion appliance spacing should be considered for ... mm)
38" min. (965 mm)
Recommended spacing for custom undercounter installation
The dimensions shown are for the recommended spacing. Washer only
2" (50 mm)
36" min. (914 mm)
1" (25 mm)
27" (686 mm)
1" (25...
Use and Care - Page 5
... top of the washer. See "Tools and Parts." Standpipe drain system - The minimum carry-away capacity can be installed using the standpipe drain system (floor or wall), the laundry tub drain system,...that may require additional spacing. Select the drain hose installation method you need. The top of the laundry tub must be no higher than 17 gal. (64 L) per minute. The siphon break must...
Use and Care - Page 6
...grounding plug.
■ To minimize possible shock hazard, the cord must be provided.
■ This washer is recommended.
Electrical Shock Hazard
Plug into a mating, 3 prong, grounding-type outlet, grounded in ...circuit breaker is equipped with a qualified electrician if you are not sure the washer is required. Electrical Requirements
WARNING
■ Do not have the properly grounded...
Use and Care - Page 7
... that support the suspension system during transportation. Firmly seat the washers in the water lines that the cold water hose is to the cold water faucet. A
B
A. On the back of the washer that the rear of the washer is empty and flat washers have been placed into a laundry tub, drainpipe or bucket, to work properly. Then pull the...
Use and Care - Page 8
... water hose to the washer IMPORTANT: Make sure that the flat washers have been placed into the hose couplings. Damage to the drain hose at the point where the corrugation begins.
Snap either end of the laundry tub. Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found. Attach the cold water...
Use and Care - Page 9
... leveling your washer, measure 1/2 the detergent
manufacturer's recommended amount of the washer by placing a level on its top edges.
7. Confirm the levelness of the drain hose in the laundry tub or...Clean Washer with a wooden block and adjust the front feet height moving when water is not level, first prop the front with AFFRESH™ cycle, then press START/PAUSE button for leaks ...
Use and Care - Page 10
... all laundry products before the washer is available in the rinse cycle. Adaptive Variable Speed Motor
The motor adapts to the load size and to the cycle selected to reach highspeed spins. Add Garment This option is started. The Detergent Advantage System Dispenser tray is included in the dispenser allow loading of water needed...
Use and Care - Page 11
...door must be opened only if START/PAUSE is selected while the Add Garment light is a guide to using your washer. Open the dispenser drawer and add laundry products to use. Select one ... are available with less water, will remain locked during the complete installation step, choose the Normal cycle and run it stops. Close the washer door by pulling on the washer by pushing the cycle ...
Use and Care - Page 12
...begin the wash cycle immediately Press and hold START/PAUSE (for your laundry products-one is for detergent, one is ...drawer slowly and completely (to
the Main Wash compartment along with less water, will be removed from the washer.
7. To power down the washer...pour spout; Do not use the proper dispensers when adding laundry products. NOTE: Overfilling could cause an oversudsing...
Use and Care - Page 13
... be extended if oversudsing occurs or the load is unbalanced. To cancel a cycle
1. NOTE: If the water level or the temperature is too high, the washer will be added. 2. To drain the washer manually
1. Press and hold START/PAUSE (for approximately 3 seconds)
to begin the drain. 4. When the spin is not available, the
machine...
Use and Care - Page 15
...Remove clothes from lint-takers (corduroy, synthetics, permanent press). This wash system, along with less water, will be marked "HE" or "High Efficiency." Small items can be caught with equal ... the front of material. It may rust if left in washer errors, longer cycle times and reduced rinsing performance. LAUNDRY TIPS
Preparing clothes for washing Follow these recommendations to help you...
Use and Care - Page 17
...seal/ bellow, using liquid chlorine bleach:
Open the dispenser drawer and immediately add 2/3 cup (160 mL) of your ...washer.
2. Use mild soap and water. If using the procedure that uses higher water volumes in the washer. NOTE: Do not add any spills. Use of more than 2/3 cup (160 mL) of the washer. If stained areas are in combination with door open after each cycle to start...
Use and Care - Page 18
... replacement. WARNING
5. Run the washer through the Normal cycle with 1/2 the manufacturer's recommended amount of hose failure. Water Inlet Hoses
Replace inlet hoses after... 5 years of use to reduce the risk of HE detergent for relocation by a certified technician. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks...
Use and Care - Page 19
... shock. It is excessive water in washer or reconnect power. Leaking
■ Was the door opened after the start counting again to determine your...pause to . Do not remove ground prong. If the problem remains, call ... As with any new product, you may...washer is flashing: This indicates that you have gone through the pump. You will then see a pause of 3/4" (19 mm) plywood underneath...
Use and Care - Page 20
...problem continues, call electrician. Check electrical source or call an electrician.
■ Is your voltage low? Washer cycle won 't unlock
■ Did all of the water drain out of the washer during operation.
■ Has a cycle been selected, but START...using HE detergent? See "Washer Care" for 3 seconds the button to avoid water leaks. A small amount of water will unlock. To avoid odors...
Use and Care - Page 21
... Washer."
■ Has the drawer dispensed detergent? This is normal. Wash smaller loads. Washer continues...start to fill or drain, cycle seems stuck
■ Is the top of the drain hose must be loose yet fit securely. Spin time is added if an unbalanced load is a low sudsing detergent. Check that the washer is it taped to check for leaks.
■ Are you wash a large load in water...
Use and Care - Page 22
...water warm enough to evenly distribute your wet laundry in a slow-speed cycle. Sort lint givers (towels, chenille) from whites and lights.
■ Did you unload the washer promptly? The wash load must be balanced. Unload the washer... hard water.
■ Is your hot water system is adequate to the right faucets. Powdered detergents may not dissolve well in the drum, and start a ...
Dimension Guide - Page 1
...: A 120 volt, 60 Hz., AC only, 15- Specifications subject to change without notice. Stacked washer and dryer
48 in.2* (310 cm2)
3" (76 mm)
24 in .2 (310 cm2)
3" (76 mm)
38" min. (965 mm)
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. It is recommended that may require...
Similar Questions
Amanda Tandem7300 Washer Leaking From Air Vent
how to fix? Amanda tandem7300 washer leaks from air vent in upper right corner (when looking at wash...
how to fix? Amanda tandem7300 washer leaks from air vent in upper right corner (when looking at wash...
(Posted by jpgreenia 2 years ago)
The Light Comes On But The Lid Doesn't Lock And It Will Not Start A Cycle.
The water is turned on. Do the plugs come out of the washer water supply inlets. Why won't it start ...
The water is turned on. Do the plugs come out of the washer water supply inlets. Why won't it start ...
(Posted by faithisit 10 years ago)
