Zenith WC-6053-WH - Heath - Motion Light Set Support and Manuals
Get Help and Manuals for this Zenith item
View All Support Options Below
Free Zenith WC-6053-WH manuals!
Problems with Zenith WC-6053-WH?
Ask a Question
Free Zenith WC-6053-WH manuals!
Problems with Zenith WC-6053-WH?
Ask a Question
Popular Zenith WC-6053-WH Manual Pages
User Manual - Page 1
... of switches 1 through 3 set the code setting to work on the same principle and use the same code setting information. All products work together.
Heath®/Zenith wireless lighting controls are UL/cUL and/or FCC/IC tested and approved. • Operational range of Switch)
Example 1 -
Floodlight
This manual includes operating instructions for switch locations.
( - Entry...
User Manual - Page 2
ON 1 2 3 4
Close-Up of Typical Code Switch (Factory Default Setting is Off)
2
598-1306-07 Code Switch Locations
Code Switches
DAY NIGHT NIGHT ONLY
1234 CODES
DETECT
180° Motion Sensor
Code Switches
CODES
DETECT
1 2 3 4
DAY NIGHT NIGHT ONLY
240° Motion Sensor
CR2032 3 VOLTS
ON 12 34
Code Switches Entry Switch
Code Switches
LAMP MODE switches
RAINTIGHT
ã THIS END...
User Manual - Page 3
... be mounted with the bottom cover facing down in order to remove. • 240° Model - Slide cover down to either the DAY/NIGHT or NIGHT ONLY position. Replace battery compartment cover by reversing the above instructions. Installing Motion Sensor 1.
Install 2 AA batteries (180°) or 2 AAA batteries (240°) according to 100 feet (30 m) away...
User Manual - Page 4
... mode. Check Operation and Adjustment Note: When first turned on the motion sensor: • The RANGE control and ON-TIME control are when the LED begins to flash. Do not point other lights at motion sensor. Set the ON-TIME control to the corresponding setting. Adjust RANGE Control. Locate the RANGE control and ON-TIME...
User Manual - Page 5
... m) Maximum Range
Maximum Coverage Angle
240° Motion Sensor Coverage Area
Aim Sensor Down for Short Coverage
Aim Sensor Higher for Long Coverage
Adjusting Motion Sensor Coverage
598-1306-07
5 ENGLISH
8 ft. (2.4 m)
180°
Motion
Motion
70 ft.
(21 m) Maximum Range
Maximum Coverage Angle
180° Motion Sensor Coverage Area
Sensor Least Sensitive
Sensor Most...
User Manual - Page 6
... are for indoor use magnet extension and two long screws (provided) to automatically turn the light on when entering a closet, attic, room, etc. 1. The magnet should be mounted on... Directions of Movement
Possible Directions of door or window in alignment (see Troubleshooting Guide.
4. Entry Switch
Installation Note: Entry system includes a transmitter and magnet. Before mounting, hold...
User Manual - Page 7
... attached to switch.
598-1306-07
7
Continued In addition, some local build- ing codes may require installation by wall switch receiver.
2. Snap transmitter onto back cover. WARNING: FOR USE ONLY with small, flat-blade screwdriver. Select light switch to operate. ENGLISH
Battery Replacement The entry transmitter requires a type CR2032, 3-volt lithium battery to be...
User Manual - Page 8
..., make sure they are secure and that no bare wires are 5 DIM settings ranging from the old switch. Connect the green ground wire from receiver to decrease brightness. Replace bulb(s). 4. Check wire connections to make sure it is switched on , OFF commands sent by any transmitter will once again accept a transmitter's ON/OFF...
User Manual - Page 9
... AUTO and MANUAL MODE. Note: Do not rotate the lamp holders more than 180° from the light receiver through the hole in accordance with mounting bolt. 7. Light gradually dims to half-bright, pauses, and then
continues dimming to off when motion is detected:
• NORMAL
or
- Secure with receiver (see transmitter instructions). Align the...
User Manual - Page 10
...replace if necessary. 7. If the problem persists, call 1-800-858-8501 (English speaking only) for assistance before returning product to : HeathCo LLC P.O. Troubleshooting Guide
POSSIBLE CAUSE 1.
Change codes on transmitter and receiver units do not match.
8. Circuit breaker or fuse is out of Purchase. Same as 5, 6, and 7 above .
1. Device does not turn off .
2. No Service Parts...
User Manual - Page 11
... a period of use, unauthorized service, or return shipping charges. Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other expendable items are not covered by the party responsible for regulatory compliance could void the user's authority to province. The user is required for inconvenience, installation, setup time, loss of two...
Zenith WC-6053-WH Reviews
We have not received any reviews for Zenith yet.