Zanussi ZKG7165 Support and Manuals
Get Help and Manuals for this Zanussi item
View All Support Options Below
Free Zanussi ZKG7165 manuals!
Problems with Zanussi ZKG7165?
Ask a Question
Free Zanussi ZKG7165 manuals!
Problems with Zanussi ZKG7165?
Ask a Question
Most Recent Zanussi ZKG7165 Questions
Pump Vibrates
Pump vibrates when pumping water only. this is not a spinning vibration problem
Pump vibrates when pumping water only. this is not a spinning vibration problem
(Posted by zzjonzz 7 years ago)
Where Is The Main Fuse In A Zanussi Zkg7165 Washing Machine?
Where is the main fuse on a Zanussi ZKG7165 washing machine?
Where is the main fuse on a Zanussi ZKG7165 washing machine?
(Posted by alaningram 9 years ago)
Washing Mashine Wan't Switch On
My washing machine refuses to switch on. After I had played with cable, checked the fuse, child safe...
My washing machine refuses to switch on. After I had played with cable, checked the fuse, child safe...
(Posted by kaspro13 9 years ago)
Zanussi Zkg7165 Washing Machine Fault.
Hi, I have a ZKG7165 which is abotu 2 years old. Recently, it has developed a fault where it complet...
Hi, I have a ZKG7165 which is abotu 2 years old. Recently, it has developed a fault where it complet...
(Posted by ricky87462 10 years ago)
Popular Zanussi ZKG7165 Manual Pages
Product Manaul - Page 3
... be replaced by the manu- • Do not change the specification of this must be carried out by our Service Centre.
• Connect the mains plug to the mains socket only at the end of the installation. Safety instructions
Installation
• Remove all the packaging and the transit bolts.
• Keep the transit bolts. Old hose sets...
Product Manaul - Page 4
... set the drying programme. - ance. Risk of injury, electrical shock, fire, burns or damage to clean the appliance.
• Clean the appliance with the E.E.C. If you stop programme. change the specification ... similar products, obey the instructions on the open door. • Obey the maximum load volume. • Do not dry dripping wet clothes in the tumble dryer. The glass can dissipate...
Product Manaul - Page 7
....zanussi.com
7 To empty out the water, please read the paragraph «At the end of water (extra rinse), select this button. Drying Time
If you wish to carry out a timed drying programme, press this button until the drying time you want appears on the display according to the fabrics (cottons or synthetics) you to start...
Product Manaul - Page 8
... red light of button 7 start The Selected delay set wash programme is selected, the message Err is displayed at the bottom of the display for a few seconds, then the duration of fabric. After the programme has started , the time remaining is updated every minute.
• Selected drying time After selecting a drying programme the drying time is shown in hours...
Product Manaul - Page 14
... concentrated detergent. Drying Hints
Preparing the drying cycle
As a dryer, the appliance works on the manufacturer's labels: • = May be open and the drain hose must be tumble dried
• = Drying at high temperature
• = Drying at the highest temperature without prewash must be machine dried.
• Avoid drying dark clothes with the installation instructions.
14
•...
Product Manaul - Page 15
... a fault).
There are two different ways to start the machine. Before pressing button 7: it stops.
To enable or disable this option:
1.
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it will be impossible to set this option press simultaneously for about 6 seconds buttons 2 and 3 until on the display...
Product Manaul - Page 16
....
16
www.zanussi.com Select the delay start :
1. Set the washing machine to switch the machine off. The selector dial can be combined. When these buttons are pressed again, the pilot lights go out. Select the programme and the required options.
2. the programme will blink 3 times and the messageErr is displayed to flash. Press...
Product Manaul - Page 17
... Follow the below instructions to run at...started
First set the washing machine to .
After a few minutes before the programme carries them out.
Drying only www.zanussi.com
The recommended load size is empty. Important! The Delay Start...set the machine to the water level and temperature!). Use - Drying... , the corresponding pilot light starts blinking. Before you make any...
Product Manaul - Page 18
... can be positioned in partial dryness. After the programme has started , the time remaining is updated every minute.
7. Note! After the programme has started , the time remaining is updated every minute. Turn the selector dial to the position to start the programme. Note! Select the drying time by pressing the button 4 or dryness degree by pressing...
Product Manaul - Page 19
... cabinet of the programme, starts an anti-crease phase which...zanussi.com
19 the display. Cleaning the dispenser drawer
The washing powder and additive dispenser drawer should be cleaned regularly. To prevent the lint in the machine. out under a tap, to open the door before you washed and dried light coloured fabrics (new
Care and cleaning
anti-crease phase, please follow the instructions...
Product Manaul - Page 22
... the water. If after
all checks, the problem persists, contact your local Service Centre, please carry out the checks listed below the recess of the detergent dispenser.
2. Warning! place a container on the display and some acoustic signals sound every 20 seconds to empty out the machine: 1. Start the programme to the section 'Cleaning the...
Product Manaul - Page 24
...Replace it is damp. • Check the water inlet hose connection.
Excessive laundry load.
• Reduce the laundry load.
The door lock has not been released.
• Wait until the door is too small. • Add more laundry. The support feet have not been removed. • Check the correct installation... starts ...manually and then select the
spinning programme.
24
www.zanussi... Problem ...
Product Manaul - Page 25
... . • Open the water tap. Washing & Drying"). • The drying phase helps to "Fluff in the garments" in the drum repeat the following procedure twice: • Thoroughly clean the empty drum, the gasket and the door with other garments. Technical data
Dimensions
www.zanussi.com
Width Height Depth
60 cm 85 cm 63 cm
25
Product Manaul - Page 26
...noises and displacement of
46
the programmes,
please refer to the
display... Load Maximum Dry Load
Spin Speed...Installation
Rubber feet kit (4055126249)
Available from your authorized dealer. Overall power -
If you install the appliance on the electrical connection is the reference programme for the data entered in the energy label, in the fixing plates. Follow the instructions...
Product Manaul - Page 27
..., noise and... around the machine is not impeded by
www.zanussi.com
Installation on a flat hard floor. Level the washing... must extend beyond the front feet.
Remove the power supply cable and the hose from the hose holders...install the appliance in the bag containing the instruction booklet. After removing all items from the drum. raising or lowering the feet. If necessary, check the setting...
Zanussi ZKG7165 Reviews
We have not received any reviews for Zanussi yet.