Whirlpool WGD9470WW Support and Manuals
Get Help and Manuals for this Whirlpool item
This item is in your list!
View All Support Options Below
Free Whirlpool WGD9470WW manuals!
Problems with Whirlpool WGD9470WW?
Ask a Question
Free Whirlpool WGD9470WW manuals!
Problems with Whirlpool WGD9470WW?
Ask a Question
Whirlpool WGD9470WW Videos
Popular Whirlpool WGD9470WW Manual Pages
Owners Manual - Page 2
... instructions below.
For further assistance If you need further assistance, you still need to your area or to schedule service, visit www.whirlpool.com/customer support or refer to order replacement parts, we recommend that you placing the dryer on our full line of appliances
■ Installation information
■ Use and maintenance procedures
■ Accessory and repair parts...
Owners Manual - Page 4
... Code, ANSI/NFPA 70. Do not store or use gasoline or other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to do not use a gas detector approved by smell. WARNING: Gas leaks cannot always be performed by a qualified installer, service agency, or the gas supplier. Gas suppliers recommend that you smell gas" instructions.
4 Follow the gas supplier's
instructions...
Owners Manual - Page 7
... comforters, pillows
(rearrange load part way through
cycle to ensure ...models - Default)
Extra Low
25
Low
25
DAMP DRY Clothes to complete drying, if needed. See Automatic Preset or Manual Preset Cycle Settings...Dryers
Automatic Preset Cycle Settings NOTE: Not all models. Steam models
Non-Steam models... Under certain environmental or installation conditions, you are available...
Owners Manual - Page 8
... feature setting. (The Wrinkle Shield feature is preset to select a specific amount of
one to four dry items.
ENHANCED TOUCH UP
Medium
20
Helps to dry. The Steam Cycles ...Manual Cycle is not recommended with heat. You can be adjusted for an extended
period.
*The Enhanced Touch Up Cycle has a minimum dry time of 15 minutes and a maximum dry time of water is sprayed into the dryer...
Owners Manual - Page 11
.... 4. Replace all parts and panels before servicing. Steam models only: Disconnect the water inlet hose from
faucet, then drain the hose. Use masking tape to faucet. Special Instructions for the dryer. Plug in death or electrical shock.
1. Replace the bulb with the screw.
4. Replace the cover and secure with a 10-watt appliance bulb only.
If the problem continues...
Installation Instructions - Page 3
... or Canadian Electrical Code, CSA C22.1. Installation and service must be detected by a qualified installer, service agency, or the gas supplier.
The dryer must be electrically grounded in accordance with local codes, or in the absence of fire or explosion, or to light any appliance. • Do not touch any phone in the vicinity of this manual must be...
Installation Instructions - Page 4
... available for gas connections)
Parts supplied Non-Steam Models
4 Leveling legs
Remove parts package from dryer drum.
Long inlet hose E. NOTE: Do not use leveling legs supplied with any tools listed here. Remove parts package from whom you purchased your dryer. In the State of Massachusetts, the following installation instructions apply:
■ Installations and repairs must be...
Installation Instructions - Page 5
... mm)
Non-Steam (Electric or Gas)
1" (25 mm) 14" (356 mm) 3 7/16" (87 mm)
* Dimension A is approximate, depending on when the diamond marking on the leveling foot is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. Some codes limit, or do not permit, installation of 1" (25 mm) under entire dryer. Contact your washer using a power...
Installation Instructions - Page 6
... and servicing.
■ Additional clearances might be required for wall, door, and floor moldings.
■ Additional spacing should also be considered on all sides of the dryer to reduce noise transfer.
■ For closet installation, with a door, minimum ventilation openings in the top and bottom of 0" (0 mm) clearance on pedestal
(460 mm)
A
B
C D*
E
F**
Steam (Electric or Gas...
Installation Instructions - Page 7
... on ordering.
7 Recommended installation spacing for cabinet installation
NOTE: Some models are not recommended for stacked recessed or closet installation.
Additional installation requirements
This dryer is available for mobile home installations. For gas dryers
■ Mobile Home Installation Kit Part Number 346764. Mobile home installations require: All Dryers
■ Metal exhaust...
Installation Instructions - Page 9
... Gas and Propane Installation Code. Burner information is located on the model/serial number plate is acceptable for test gauge connection, immediately upstream of the dryer in
your dryer has been converted to the dryer. Gas supply pressure testing ■ The dryer must have a qualified person make sure gas pressure does not exceed 13" (330 mm) water column. GAS DRYER POWER HOOKUP
Gas...
Installation Instructions - Page 10
... outlet installed by a qualified electrician. Do not use an extension cord. It is a registered trademark of electric shock by brushing on the pedestal model.
SAVE THESE INSTRUCTIONS
†®TEFLON is also recommended that a separate circuit serving only this dryer be sure there are in doubt as to the existing gas line. Dryer gas pipe
■ The gas pipe...
Installation Instructions - Page 11
... by calling Whirlpool Service. Do not use a plastic vent. For more information, see the "Assistance or Service" section. ...gas vent, chimney, wall, ceiling, attic, crawlspace, or a concealed space of fire, this is recommended to seal all governing codes and ordinances.
C: Acceptable hood style. B
4"
C
(102 mm)
A
4" (102 mm) 4" (102 mm)
2½" (64 mm)
A. If this dryer...
Installation Instructions - Page 14
... "Level Dryer." 6. Wipe the dryer drum interior thoroughly with an additional two-thirds turn . Steam Models Only: 12. Select a Timed Dry heated cycle, and start , check the following:
■ Controls are on
the dryer. 7. Do not select the Air Only Temperature setting.
This dryer automatically runs an installation diagnostic routine at bottom of /recycle all parts are on...
Dimension Guide - Page 1
...)
NON-STEAM - 311/2" NON-STEAM - 5"**
(800 mm)
(127 mm)
1"
27" 1"
(25 mm) (686 mm) (25 mm)
For dryer on pedestal; Rigid or flexible metal exhaust vent must be used for planning purposes only.
Number of 90o turns or elbows
Type of elbows and turns. See Installation
Instructions, "Venting Requirements." cabinet installation, with the National Fuel Gas Code ANSI Z223...
Whirlpool WGD9470WW Reviews
Do you have an experience with the Whirlpool WGD9470WW that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Whirlpool yet.
Earn 750 points for your review!