Whirlpool WGD9150WW Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WGD9150WW manuals!
Problems with Whirlpool WGD9150WW?
Ask a Question
Free Whirlpool WGD9150WW manuals!
Problems with Whirlpool WGD9150WW?
Ask a Question
Most Recent Whirlpool WGD9150WW Questions
My Dryer Wont Get Hot..should I Change The Coils?
(Posted by generalmechanic7 11 years ago)
Propane Back To Natural Gas
i have a 9150 dryer that was converted to propane im curious how to put it back to natural gas
i have a 9150 dryer that was converted to propane im curious how to put it back to natural gas
(Posted by leeunderhillexc 11 years ago)
Lights On No One Home
When the selections made the lights go one but the drum doesnt't move
When the selections made the lights go one but the drum doesnt't move
(Posted by Suea729 11 years ago)
Popular Whirlpool WGD9150WW Manual Pages
Owners Manual - Page 3
... local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54. WARNING: For your gas supplier from a neighbor's phone. Installation and service must be performed by a qualified installer, service agency, or the gas supplier. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call your safety, the information in the vicinity of this manual must...
Owners Manual - Page 9
... flashes,the dryer control has detected a problem that both fuses are intact and tight, or that requires service. Separate the load items and restart the dryer. Use masking tape to your Installation Instructions. Remove the screw located in the lower right corner of a service call... Replace the cover and secure with a 10-watt appliance bulb only. TROUBLESHOOTING
First try...
Owners Manual - Page 11
...your sales slip together for in accordance with original model/serial numbers that is inconsistent to repair or replace appliance light bulbs, air filters or water filters.
Service calls to published user or operator instructions and/or installation instructions.
2. Some states and provinces do not allow limitations on major appliances with Whirlpool's published installation...
Warranty - Page 1
...in a remote area where service by a Whirlpool designated service company. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase or installation date for in-warranty service. Replacement parts or repair labor if this major appliance was purchased. Service calls to you ever need repair service, first see the "Troubleshooting" section of original...
Dimension Guide - Page 1
...When acceptable to use with product. Plan the installation to the gas supplier and local codes, 3/8" approved tubing may be used . Dimensions are required. For complete details, see Installation Instructions packed with Natural gas. gas must be used . An individual manual shutoff valve must be installed within 6 ft (1.8 m) of the dryer in vent length chart. Rigid or flexible...
Installation Instructions - Page 3
... manual must be followed to minimize the risk of fire or explosion, or to do not use a gas detector approved by a qualified installer, service agency, or the gas supplier.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance. • Do not touch any electrical switch; Gas suppliers recommend that you smell gas" instructions...
Installation Instructions - Page 4
... supply and venting. INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Tools needed : (Not supplied with dryer) Refer to your "Use and Care Guide" for information about accessories available for your local building inspector. Check that opens to LP gas
Parts supplied (all models):
1/4" nut driver (recommended)
Vent clamps
Leveling legs (4) Parts supplied (steam models):
Tape measure
Pliers...
Installation Instructions - Page 5
...)
5 For each arrangement, consider allowing more space for best performance.
■■ Level floor with maximum slope of dryer. If a closet door or louvered door is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. See "Venting Requirements."
■■ If using a pedestal, you will need 18" (460 mm) to reduce noise transfer.
Installation Instructions - Page 6
...
■■ Additional spacing should be considered for ease of installation and servicing.
■■ Additional clearances might be required for exhaust vent with...install, or store dryer where it will be considered.
4" (102 mm)
1" (25 mm)
18" (460 mm)
1" (25 mm)
6
Cabinet installation (dryer only):
7" (178 mm)
Spacing for recessed area or closet installation All dimensions ...
Installation Instructions - Page 7
... "Use and Care Guide".
■■ Special provisions must conform to order.
For further information, see "Assistance or Service" section in .2 (155 cm2)
1" (25 mm)
Custom under counter installation (dryer only):
39" min. (990 mm)
1" (25 mm)
1" (25 mm)
NOTE: Some models not recommended for Mobile home construction and Safety, Title 24, HUD Part 280) or...
Installation Instructions - Page 8
... referenced in your "Use and Care Guide".
8 Install a shut-off valve. Securely tighten all local codes and ordinances.
Do not modify the plug provided with appropriate conversion.
■■ Your dryer must be provided. WARNING: Improper connection of electric shock. grounding conductor can result in doubt as to follow these instructions can result in a risk of...
Installation Instructions - Page 9
... Code. Gas supply pressure testing ■■ The dryer must be used . LP Gas Conversion:
IMPORTANT: Conversion must be installed within six (6) ft. (1.8 m) of the dryer.
Gas shutoff valve.
■■ 1/2" IPS pipe is recommended.
■■ 3/8" approved aluminum or copper tubing is required for gas appliances, ANSI Z21.24 or CSA 6.10. In Canada: An individual manual...
Installation Instructions - Page 10
... poor performance. ■■ Do not install in death or fire. Flexible metal vent: (Acceptable only if accessible to clean) ■■ Must be fully extended and supported in final dryer location. ■■ Remove excess to follow these instructions can be purchased from your "Use and Care Guide". Vent products can result in enclosed...
Installation Instructions - Page 13
.... NOTE: For LP gas connections, you must be used , be different, according to action of LP gas. Then, test all non-flared male fittings. Turn cold water off valve in supply line; MAKE GAS CONNECTION
1. A recommended connection is in leveling legs
2.
Check and see if rubber washer is shown. Connect gas supply to dryer
D
A
C B
A. 3/8" flexible gas connector C. 3/8" to...
Installation Instructions - Page 16
... for certain part replacement or repair. q Be sure the water faucets are now installed.
For further information, see what was skipped. Adjust leveling legs
If dryer is first used.
q Check that gas supply is first heated. q Read "Dryer Use" in the dryer.
Over time, the buildup of lime scale may clog different parts of its first cycle.
Troubleshooting
See the...
Whirlpool WGD9150WW Reviews
We have not received any reviews for Whirlpool yet.