Whirlpool WGD8120HW Support and Manuals
Get Help and Manuals for this Whirlpool item
This item is in your list!
View All Support Options Below
Free Whirlpool WGD8120HW manuals!
Problems with Whirlpool WGD8120HW?
Ask a Question
Free Whirlpool WGD8120HW manuals!
Problems with Whirlpool WGD8120HW?
Ask a Question
Popular Whirlpool WGD8120HW Manual Pages
Owners Manual 1 - Page 2
... installation must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part ...instructions. DRYER SAFETY
Your safety and the safety of others .
The dryer must conform with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane Installation Code...
Owners Manual 1 - Page 5
... and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for purchase from dryer. Some codes limit, or do so can be exposed to reduce noise transfer.
The installation must support dryer weight of 1" (25 mm) under entire dryer. For further information, see "Assistance or Service" section in mobile homes to fully open...
Owners Manual 1 - Page 8
... aluminum or copper tubing is located on the model/serial rating plate for use a new flexible stainless steel gas
...the National Fuel Gas Code, ANSI Z223.1. NOTE: Pipe-joint compounds that an individual manual shutoff valve be installed within six (6) ft...service personnel. It is a registered trademark of the dryer in the "Assistance or Service" section of your "Quick Reference Guide."
Owners Manual 1 - Page 21
...Check for leaks. Do not
select Air Only Temperature setting. If dryer will receive L2 code for certain part replacement or repair. You will not start, check the following:
•...Troubleshooting."
See "Level Dryer."
Pinch the hinge latch between two fingers and pull forward.
q Check dryer's final location. Gas Models:
q Check that the door is free to the need for this problem...
Owners Manual 1 - Page 28
...Replace all parts and panels before servicing. Disconnect wiring from faucet, then drain the hose. Transport hose separately. 5. See "Base trim". See "Cleaning the Lint Screen." 3. Unplug the power supply cord. 2. Gas models only: Disconnect gas supply line pipe and remove fittings attached to the dryer. WARNING
SPECIAL INSTRUCTIONS FOR STEAM MODELS
Water Inlet Hose Replace...
Owners Manual - Page 2
... injured if you don't follow instructions.
IMPORTANT: The gas installation must be electrically grounded in accordance with local codes, or in this manual and on your appliance. This is...the instructions are very important.
The dryer must conform with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part ...
Owners Manual - Page 4
...to propane gas
Parts supplied (all models):
Level Plastic putty knife
Vent clamps
Leveling legs (4) Parts needed : (Not supplied with any tools listed here. Check existing electrical supply and venting.
INSTALLATION REQUIREMENTS
TOOLS AND PARTS Gather the required tools and parts before purchasing parts. Read and follow the instructions provided with dryer) Check local codes. Tools needed...
Owners Manual - Page 5
...HUD Part 280) or Standard CAN/CSA-Z240 MH. Space must support dryer weight of the door are acceptable. ■■ Companion appliance spacing should be considered for a garage installation.... the floor for ease of
installation and servicing. ■■ Additional clearances might be at least 18 inches (46 cm) above floor. ■■ Steam models only: Cold water faucets located...
Owners Manual - Page 8
...;®TEFLON is required for opening and closing . NOTE: Pipe-joint compounds that an individual manual shutoff valve be installed in the door well of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. No attempt shall be used . GAS SUPPLY LINE
GAS SUPPLY CONNECTION REQUIREMENTS
■■...
Owners Manual - Page 21
... console and any dust. "See Troubleshooting." If it is an extra part, go away. Then, follow these instructions. You will not start dryer.
DRYER DOOR (ON SOME MODELS)
For normal dryer use of a water softener is not, repeat the removal and installation procedures. 21 q If you have power supply problem in your dryer vent may notice...
Owners Manual - Page 22
...door. Remove the cosmetic screw (B) opposite the door strike (A). Open the dryer door.
2. Set the hinge screws off the cabinet. Reinstall the door strike and cosmetic screw on a flat... models with the inside of the dryer door opening .
2. The following instructions are applicable for reinstalling the door.
You can change your door swing from dryer cabinet
1. Cosmetic screw
3. Install...
Owners Manual - Page 27
... YOUR VENT SYSTEM FOR GOOD AIR FLOW
GOOD AIR FLOW (CONTD.)
Service calls caused by improper venting are not covered by the customer, regardless of the cover. each load. ■ Replace plastic or foil vent material
with your energy savings. See Installation Instructions. Open the dryer door.
The venting system attached to follow these...
Quick Reference Manual - Page 3
... dryer may be guided through the dryer and the dryer vent system for the dryer's life. Once installed, launch the app and you have any other key to setup WiFi later.
1 CONNECTING UNIT TO INTERNET
2 ALLOWING REMOTE CONTROL AND INTERACTION
To connect your unit to the internet please download the Whirlpool® app and...
Quick Reference Manual - Page 4
... with all your Manuals for more information on it (including cooking oils). Failure to follow these instructions can completely remove oil. Failure to Factory settings then perform Factory ... all cycles, settings, and options are available with "Select Language" display message.
*NOTE: See "Cycle Guide" for more information about cycles, settings, and options. Read all models. Do not...
Quick Reference Manual - Page 7
....ca/owners. For detailed product dimensions, please see the INSTALLATION AND CARE INSTRUCTIONS MANUAL included with any of a service call. For information on any questions or concerns at:
Whirlpool Brand Appliances
Whirlpool Brand Appliances
Customer eXperience Center
Customer eXperience Center
533 Benson Road
Model & Serial Unit 200-6750 Century Ave
Benton Harbor, MI 49022-2692...
Whirlpool WGD8120HW Reviews
Do you have an experience with the Whirlpool WGD8120HW that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Whirlpool yet.
Earn 750 points for your review!